Book a trusted oven repair and installation expert in Central London

THe electric oven and ignition for gas hob is not working Sorry help no longer needed

I have an induction oven, I need it installed to replace my old induction oven. The cable from my old oven can be used for the new one. I have recycling of the old one arranged. Looking for a qualified electrician please.

Hi, I need help with: 1. Self assemble the base hob cabinet with legs from a flat packed box 2. cut / adjust and Glue join a 60cm Wide worktop from a flat packed 1 Meter Worktop box. 3. Install & connect the oven below and the Ceramic hob on top please

I need someone to look at the wire on My intergarated oven. It is loose and as a result the oven has no power.

I’m looking for someone who can remove my old one and install my new electric built in over and hob

Hello, I need an experienced plumber to seal the little leak under my kitchen sink and Install my washing machine. I would like both services to be carried out on the 11 August at 2:00 pm. Please let me know your availability, the estimated cost, and whether you are fully qualified and insured. Thank you.

Purchasing a new Pizza oven. Needs to be disconnected from Gas and dismantled. Will then need to be transported from Norbury to Wembley, where it will then be reassembled

For some reason the induction hob and oven are not working, we have guest staying and they can’t figure out. The fuses box is showing switches are up.

Fuse box switch caused a minor power cut in my flat. I flipped the switch back on and everything works fine, except my electric oven. The stove works and the oven comes on but its not heating up at all. I tried to reset the timer like what I read online but no changes Brand: Montpellier Model: MDOC60FS

My electric cooker/ oven is not working. The electricity switch was looked at recently so it might have had something to do with that. Could someone please look at it please.

My cooker/oven electricity switch was looked at recently. My cooker/oven is not working at the moment. Could someone pIease look at it either today or tomorrow

Hi there, We are looking for an experienced welder to help us with a very quick job. We need a small spot weld done on our oven. Details: • Job type: Small spot weld (I have attached a photo marking the exact spot with a green dot). • Equipment: You will need to bring your own portable welding equipment. • Preferred Date: after 16 pm It should be a very quick job for someone with the right gear. Please mention your experience and what type of welder you'll be using when you place your offer.

We thought our oven wasn't working and called out our insurance to check it, they done a temporary wire test and it works , they explained it needs to be hard wired - arp rewiring

I am experiencing intermittent electrical faults with my cooker, oven. Symptoms observed: • When the cooker hob or extractor is in use and the oven wall switch is turned on, the circuit breaker trips (requiring reset at the fuse board). • After one trip and reset, the oven remained powered on even though the wall switch was in the off position. • The circuit has also tripped when simply turning down a cooker hob control from a higher to lower setting. • These random but related faults occur only with the cooker/oven/extractor appliances. Could you please attend as an experienced electrician to inspect and safely diagnose/fix the issue? Thank you.

Scratched microwave door open panel to be replaced with new panel. Microwave oven: Bosch Series 2 FFL023MW0B

We are moving house the new occupants need our current oven disconnected before we leave. It is a gas oven

My commercial oven gas keeps chipping out the gas flames so every minute I have to keep opening to check if there’s fire on it. Maybe the thermal stack needs changing

My eletric oven is model HHF113BROB/11. The left control knob is broken, and the inner control mechanism where the knob attaches is also damaged. I have purchased the replacement knob and the support part—one labeled “knob” (part number 10024778) and one labeled “support” (part number 10004592). I need someone to replace the broken internal fitting and attach the new control knob.

Fishy smell from oven. Someone from Domex has come round to look at the oven. He said the oven works completely fine. He said he did note the fishy smell and said it could point to an issue with the main electrics but not the oven itself. He recommended for an electrician to come round and take a look at the electrics properly to make sure there isn’t a potentially dangerous fault.

Wall 5M wide x 2.4M - paper is high quality woven fabric so experience required