Find experienced local tradies in Ryde

Need rendering over exposed brick walls in the bathroom. We can discuss price after you see the site

The existing power point (white plastic rectangle sockets) need to be taken off and the wires covered so that it is safe for the skirting boards to be installed. Want the covers removed so it’s easier for the carpentry to make a small hole for the power points to be poked back through rather than cutting out a large rectangle piece for the existing power points. There are three rooms - approx 3 power points each room. Location Gladesville Can be done today, friday or Sat

Need rendering done in bathroom prior to waterproofing One full wall H 2.4 W 1.6 where bathtub was removed and some other touchups on 3 walls

One of the power point is not working (can’t plug in the socket). Would like to repair it or install a new one. Please advise the work and fee.

This job will also require a painter. If you can complete both the plaster and painting, we can offer a total of $1,650. Supply and install 13mm plasterboard ceiling Sanding to a smooth finish, ready for painting Ceiling only needs to finish to the edge of the WIR cabinetry Use angle trim for a clean edge finish.

Need to take out the existing plaster board and install the new one need to be square set finish About 15 square meter It is under the balcony outside the house, so it has to be blue plasterboard

1. Remove windows and close up with weatherboard, add required framing and gyprock. 2. Move door over to window next to it. Close up Curren doorway with weatherboard and gyprock. I will provide weatherboard to match.

Very small area (I measured and it’s just under 19.5 sq meters) - I just want to beautify the entrance to this address and a small wall outside, this is one storey house only, I had someone come and he installed most of the plastic caps then took the money and ghosted me - I’d prefer to pay on the spot once the job is completed.

Hi, I have a double power point in my kitchen that is broken. Looking for a licensed electrician to replace it with a new double GPO. I am located in Epping (near Rawson St). Preferably looking for Alan T. if available! Thanks.

I need to install 1/2 extra powerpoints in my garage.

I need a very experienced renderer to render part of a front beam Scaffold is there and labourer if needed

Looking for an experienced handyman or renderer to repair minor cosmetic damage to exterior render on a granny flat wall. Damage was caused by an item leaning against the wall. The wall itself is solid — this is surface render cracking/compression only, not structural. Scope of work: • Remove loose/cracked render • Patch and re-render damaged section • Match existing texture as closely as possible • Paint/blend repaired area to match existing colour Details: • Small area (approx. window sill width) • Exterior ground-level access • No structural or brickwork issues • Photos attached

Need an electrician to install one power point in our family room on the wall.

We have a house which is about to go up for sale. The garage had a damaged dual electrical socket which has since been re-placed to another position but the old socket now needs filling and smoothing off. Completely flexible of time/date just let me know what suits you best.

Hi, need the holes patched in ceiling, sanded and be ready for painting.

New spa getting delivered Need spa PowerPoint extended from already 15amp outside PowerPoint as new spa comes with only 2.5 meter power cable Need extra 4meter extended

Seeking an experienced tradesperson to remove an existing timber balustrade and supply & install a new timber balustrade (white finish paint). Must be secure, neat, and compliant with Australian standards. Existing framing (treated pine): Posts 900x900 mm Ends 900x450 mm Handrail 900x450 mm Lower rail 900x250 mm 📍 Beecroft NSW 2119 | Complete before 23 Jan 2026 Site visits can be arranged. Please see attached current photos of balustrade (damaged) that needs to be replaced and measurements.

I need a licensed electrician to install a double power point in my apartment. The purpose is to have: • One outlet dedicated to the fridge, and • One outlet for a modem / router Currently there is only a single power point in this location, and I would like it upgraded to a double power point for safety and proper usage. The job involves replacing the existing socket and ensuring the installation is compliant with Australian electrical standards. Please quote including labour and materials. Note apartment is an old one built in 1970s.

Small gyprock/plasterboard wall repair needed (minor hole/dent – see photo). Job includes: 1. Patch and repair the hole 2. Sand smooth 3.Paint touch-up to blend with existing wall colour Damage is very small. Finish needs to be neat and suitable for rental inspection. I’m happy to Supply matched paint from Bunnings, OR Have you source a small sample pot / colour match (please include in your offer)

There’s a damaged area of gyprock been cut out due to a leak that has been repaired. I need someone to install new gyprock and sand and paint