415 Awning Experts Near You

1.4m awning needs to be attached to rear of roof rack on top of Toyota troopcarrier, we have the bracket and bolt set but we are travelling and have struggled to attach it ourselves 😀

We have a folding arm awning with a motor and remote control, the awning is 10 meters wide and 3.6 meters projection, now it does not work at all, although we changed the battery on the remote control. it is called Alfresco Cassette Type Folding Arm Awning.

Need some bright lights for my kebab shop awning or possibly a lit sign box also not sure of the cost so make some offers

Has existing awning installed and now took it down. New awning doesn't line up need to drill new holes and put up on brick work. Can supply ladder if needed and support

Awning arm needs to be reattached.

Need to cut the tarp at the top and remove along with bottom weight pole. 2400mm ladder available onsite. Need it done asap.

The top of the sheet metal needs to be screwed back into the timber supports - very minor repair.

I need sign to be mounted on an awning. The install will be going onto metal. The measurements would be 50cm x 5.5m approx. This job is on Bell St, a busy intersection so will need to be done really early in the morning or late at night

I need someone to install my king's awning on my 4wd outlander. Please note, I have a roof top tent so you will be required to do some creative engineering to properly suit it. Also, I don't have the required bolts and nuts.

Need a awning built around 24sq

Move kings 2.5m sideawning on brackets to the other side of van and install on rooftop steel frame. This may require putting 1 bolt through steel frame itself to avoid solar panel that cannot be easily moved. Install new kings 270 degree awning with supplied brackets to rooftop steel frame on slide door side of van.

Hi I need someone to come and set up a wardrobe and an awning and a desk for me. I’m in port Melbourne

Remove metal sign from Street Awning. Sign is attached with screws to the building hording. Sign is at 3 meters high.

Awning roof is Timber and colorbond sheets. Approximately 7m x 3 m. Only colorbond roof sheets,rafters and brackets on facia need to be taken down and stored onsite. Job should take no more than 3 hrs.

it's 4mx2m backyard colorbond roofing

Two of the four plastic fitting fixtures of our OzTent / Rhino Rack foxwing awning have snapped (pics attached) - looking for someone to come and fit the two replacement pieces that we have already purchased.

Need help to install 2 side awnings at my apartment. Instructions video is here: https://www.youtube.com/watch?v=x-wYXLBNojA so it is not a big job just a few holes to drill.

Need an awning repainted at front of house - it has been discoloured. Would need to provide paint.

4m x 3m Motorised Awning to be installed. Instruction video in photos when scanning code in one of the pics. To be installed with Mounting Brackets on to Brick Rendered Wall on each side of sliding doors in photos. Awning and Materials supplied. Just need the installation done Location: The Entrance North

on installation of ceilings fans need the ceiling patches to be prepared and painted in white paint, small wall patch to be primed and painted (paint is available for wall). 2 cupboard doors to be resized and installed. on installation of range hood the cupboard doors became too big to fit in. Need a cafe type clear awnings to be installed (2.25meters by 2.4 meters (awnings is already purchased). Other handyman type jobs may be made available if the service delivery and quality is of high standard.