Find experienced local roofers in VIC

extend downpipe to ground level

Gutter Clean, single level on entry side, double level on the garage side

I need to remove my existing 90cm rangehood and replace with new one. The rangehood duct needs to go out to the tiled roof using some vent. Roof vent/cowl installation is part of the job. I will provide the rangehood and vent/cowl kit. A photo of existing working rangehood is attached. Please give me a price quote.

Gutter needs to be cleaned as there are some plants in it in the roof and also it is leaking a bit regularly.

There are several areas of concern observed with the roof tiles that require some rectification. The issues are as follows; Some minor cracking was evident in the pointing of the roof tiles. (See photos attached) There were some broken and chipped tiles observed that need to be replaced. (See photos attached)

Remove and dispose of any existing roof insulation and replace with new. Roof area is approx 150m2 and accessible from within the house. Roof insulation will be provided. Must be a professional with an ABN and previous experience, with references. Home is located in Geelong West. Thanks Insulation will be provided

I have a woodburning heater. There is scratching and sliding sounds coming from it as though there is a small animal trapped high up. It has a cap and was recently serviced so I'm not sure how something got in there. you would need your own ladders and be fit and confident enough to walk on a roof, take the cap off, inspect the chimney from above and potentially remove a small animal. Yes I know this one is a long shot!

We have recently purchased a home and I want the roof to be pressure washed and guttering service. And check if the roof is maintained.

Just need a small section of the gutters cleaned out as it’s dripping so I know it needs To be cleaned out. I just don’t have a tall ladder.

Gutter cleaning for single storey house

Need someone who can remove debris and clean the roof gutters and down pipes of my home. The house is single story and built area is 27 squares ( approximately). The job to be performed in next two weeks time. Day and time can be negotiated mutually. Please contact if interested or need any other information. Pictures attached anyways.

I have a roof top tent I want help lifting from my Ute. And then another, lighter one I just need help fitting.

1. Towel rack to be re attached. It has become loose and not sitting securely on the wall. We have had it fixed although keeps coming lose. I believe new wall plugs will be needed. And these will need to be supplied please 2. Down pipe on roof had become loose. You will need a ladder to securely fix screw back on to wall and assemble the down pipe

I need gutter guard removed from a box gutter on a flat roof. The gutter is approx 6 meters long and is currently screwed on. I would like the screws removed and then screwed back in after the gutter guard is removed (to seal the holes). It is a polycarbonate roof but you can access the gutter from a ladder. You call also walk on that part of the roof using a walk board or thick wood planks to spread the load if preferred.

My roof cornice is seperating from the side of the wall bringing with it the plaster on the roof Need it re-fixed

Looking for an experienced and licensed roofing contractor to inspect and quote on repairs/replacement for an older home in Boronia. Job details: - mortar roof requiring patching or updating to fixed point - signs of leakage in eaves/rafters - needs assessment - gutters likely need full replacement, open to Colorbond/painted Zincalume Scope: On-site inspection and quote only No obligation beyond above Access: Easy roof access available Flexible with inspection times. Thank you for your interest. Cheers, John

Assemble roof racks and installation on a Ford Ranger 2016 model and series is PK2, can be seen on this website - https://www.ozbestdealz.com.au/unassembled-flat-roof-rack-aluminium-platform-stee?gad_source=1&gad_campaignid=20741286179&gbraid=0AAAAAC8oA2jvK89C1ioDW1tdPtdQcs_w-

I am a tenant in a very old place and the gas inspector has picked on this, which has the landlord stressed and upset (I try to fix what I can around here due to the situation so that I can stay here) ... was told that bracing it against the wall would be enough, so the flue can't move away from the exhaust on the top of the unit) but let me check on that (may need poles on the roof also? ... or maybe you have knowledge about that in terms of requirements ... it can be really rough and ready so long as they approve it. (p.s. I'm getting up on the roof this weekend to clear the debris and branches)

I have just moved into a new house and the down pipe drain is draining straight out onto the ground and not into the box thing. The pipe appears to be longer than the box? Need to get it fixed so it drains into box and not draining straight onto the ground

Check my down pipe spreader and do repointing on a few tiles