Find trusted insulation contractors in VIC

Remove blow in insulation from the ceiling of the first floor of double storey renovation

Approximately 78 m², single-storey late-1980s house with tiled roof and manhole access. I will supply 580 mm-wide R5/R6 glasswool batts. Existing old glasswool insulation will require bagging and removal. Please quote removal, disposal and installation. Installer must have ceiling insulation experience, public liability insurance, suitable crawl boards/PPE.

I am looking for an experienced handyman or carpenter to help finish off the wall and framing around a recently installed door. There are a few specific tasks required to make the area look seamless and finished on the inside. Tasks include: 1. Adjusting Metal Casing: There is a metal track/casing housing a garage door weight that sticks out too far. This needs to be shaved down or pushed in so it doesn't protrude. 2. MDF Extension: Once the casing is adjusted, I need MDF installed to extend the wall to the new door frame. This MDF needs to run all the way from the top down to the floor. 3. Adding Insulation: There is an exposed cavity at the top of the door frame that is missing insulation. Insulation needs to be inserted into this top gap. 4. Gap Filling: All remaining gaps along the top and the side between the new door frame and the wall need to be filled in completely. 5. Skirting Board Touch-up: The baseboard/skirting on the adjacent wall near the floor is messy. This small section needs to be replaced or sanded and painted to look clean. 6. Painting: After all the construction is complete, the new MDF extension and all patched/filled areas need to be primed and painted to match the existing wall color and finish seamlessly. Notes: - There are some exposed cables/wires that need to be safely tucked into the cavity behind the new MDF. - Offer should include all materials, labour to complete the job. I have attached detailed photos of the space to give a clear understanding of the job. Timeline: Ideally looking to get this done as soon as possible. Please review them, let me know your availability, and provide your quote!

I need to install insulation underneath the house. I have taken the flooring of the bathroom out. Easy access and it needs to be done within this coming week

Looking for someone to supply and install ceiling insulation in my single-storey, single-car garage. • Approx. 21m² ceiling • Tiled pitched roof • Install R5.0 glasswool/fibreglass batts • 6 Existing LED downlights — install suitable insulation covers/guards and maintain required clearances • Work around existing wiring and roof ventilation • Supply all materials and leave area clean/tidy $600 budget – materials + labour Please quote your total price and include the insulation brand/R-value you’ll be using. Experienced insulation installers preferred. Any additional costs to be discussed and agreed before work begins.

Need insulation supplied and installed to the specific exposed wall and ceiling areas shown in photos – not whole house. Previous wardrobe area: approx. 2100mm H × 3050mm W × 550mm D. Existing timber framing is exposed and ready for insulation before plasterboard installation. Please quote for suitable wall & ceiling insulation, including installation. And If any slats or battens required

Need insulation batts installed for a single room new build both wall and ceiling . 7.5mtsx3 mts room size

Looking for someone to install insulation in 3 rooms walls Will supply insulation Bedroom Ensuite Main bathroom

Install 12mm Structapanel sheets to interior walls and ceiling of new steel shed. Pitched ceiling is 3.2 metres high at peak.

Sanding and painting filled holes in weatherboard house. Approximately 180-200 holes.

Remove old insulation and replace it with new insulation in roof space

animal faeces in ceiling insulation

Clean the roof cavity of rat dropping and relay insulation

Require about 10m2 of underfloor insulation to be installed. See floorboard area in picture. Unfloored area likely to be covered by the time the job starts. Tighter crawl space but small job.

I require vacuuming of my ceiling and the installation of insulation. The property is small- 2 bedroom house.

Remove (only) roof insulation from a small 3 bedroom home in Ivanhoe on Saturday morning. Ceiling has been removed in kitchen so easy to use to drop insulation on the kitchen floor and then place outside for rubbish collection. Only partially insulated with some patches of no insulation in ceiling.

I need a fit and motivated Tasker to crawl under my house on stumps and shift some dirt to the side.The spray foam insulation guy has completed 70% of the subfloor, but needs a narrow crawl space cleared in the last 30% tight corner so he can fit through to finish the job.$50 an hour

Install R2.5 polyester insulation under the floor of a 2 bedroom weatherboard house (approx 85sqm) (will provide insulation, staple gun, coveralls, dust mask and sheet to lie on if you need)

I’ve already installed over half the subfloor insulation in my home (134m2) and need someone to complete the job (approx 65m2). The product is a recycled polyester batt (soft, no itch, no PPE needed) that simply tucks up between the joists and staples into the timber, very straightforward once you’ve done a few. The work involves: • Cutting rolls to length (width is pre-sized, length cuts only) • Tucking batts snugly up under the floorboards • Stapling into timber joists to secure Important: There is fragile ducted heating pipework under the house. You’ll need to work carefully around this and not rush. This is the main requirement, someone methodical who won’t damage the ducting. It’s not difficult but it is a little tedious and dirty under there. All equipment is provided: • Knee pads • 2 x staple guns • Head torch • Scissors/blade for • Protective eyewear and mask (for dust) •I used a bike helmet to protect my head which you are welcome to use but if you have a hard hat that would be better. You’re welcome to bring your own gear if you prefer. The insulation rolls are on-site and ready to go. I’ll show you what’s been done already so you can match the approach. Product reference and install method: https://youtu.be/-rIyo6bh9A4?si=hNoCcayYgbWn_9LT Please only apply if you’re comfortable working in a crawl space and can commit to careful, unhurried work. Happy to answer any questions.

I’m looking for some help laying the insulation layer for my single-story house. I already have the insulation rolls on-site.