Find trusted insulation contractors in Melbourne

One bag of insulation batts to be placed within roof space where some batts are missing. I am providing the wool insulation batts. Manhole opening is 520mmx 420mm.

About a metre at the hatch to ~300mm at the lowest point. Timber subfloor. Dirt floor. Some minor obstructions such as water pipes Installer to supply batts, R2.5

Looking to get under timber floor insulation done. Weatherboard house has access to under floor.

Lay ceiling insulation in my home

Single storey freestanding house with tile roof. Total area approx 80m2. Reasonable access to roof from all sides of house. Existing insulation is old and non existent in places. Looking for quote to: -Remove old insulation -vacuum dust & debris -Supply and install new insulation in roof space Looking for good quality insulation and experienced installer with insurance. Can provide any further info required.

I'd like some insulation put in my ceiling to help with heat loss.

Looking for a builder / carpenter to help complete a camper fit-out in my van (VW Crafter). I will provide all the parts! Just need someone with the skills and tools to build everything :) everything wooden, and as light weight as possible :) Scope of work - 1. Rear Drawer System (Boot) • 1 x heavy-duty slide-out drawer system • Approx. 1600mm length, 40cm depth • Needs to be strong enough for camping gear (very sturdy, no wobble) • Top surface/lid to be usable as a table/work surface 2. Internal Cupboard Unit • Build a compact cupboard inside the van • Include 3 x slide-out shelves • Clean, minimal finish to match existing interior • Practical for storage (clothes, food, gear etc.) 3. Insulation • Insulate rear barn doors + sliding door, cover with plywood 4. Finishing • Grey paint + wood stain to match current van interior Details: • Van: 2023 Volkswagen Crafter • I already have a rough layout in mind but open to suggestions

I have an old Victorian home with no insulation and need to stop seal under the floor for draft proofing and thermal insulation purposes Clear man whole from back of house, only section that is hard to hit is centre were the old fireplace used to me (bricks piled there) Screenshot of floor layout where you can access and we want insulation

Looking for an experienced and reliable person to remove old insulation and install new insulation in a 3-bedroom single story home

300-400 mm clearance on entry, 500 mm clearance once under. 6 packets to be installed.Foam sheets supplied

Remove old roofing insulation from the roof void, vacuum dust and debris, lay new insulation batts to compliance at R6 between the joists. Roof area around 120m2, access via manhole and standing room in roof void

We need someone to repair and restore an area of mould in our ceiling, fixing possible installation damage and replacing if need be

Tiling an alcove area for installing a stove/oven

Installation of Tile Backer Insulation Boards (1200mm x 600mm x 6mm) across a concrete slab. Boards will cover a area of approximately 50m2. These boards need to be screwed using 25mm fibre cement screws into the concrete slab below. A high strength poly-urethan tape will then need to be taped across the joints of the boards. Note Boards, Screws and Tape will be supplied. This quote request is for the installation and waste removal cost only.

Plaster garage ceiling and instal insulation batts Garage measures 6 metres x 5.5 metres

Dear respected team I need your help to install 2 light box shop front. You please supply Material and installation and no hidden charges Thanks 🙏

Remove existing blow-in insulation and install R6 ceiling insulation batts.

Install insulation to an existing older home Insulation to be supplied Single storey home around 300m2

Job is to install floor insulation across our house, approx 100sqm. Install is done from above as there is extremely low clearance underneath. Everything is up in the house. Work does not include bathroom area. You will need to work around a bunch of floorboards (example pictured), but they will be laid in tandem with your work so will get more out of your way as time goes on. Insulation and tooling is provided. Most of the insulation is polyester rolls that just need stapling directly to joists. Some (~15sqm) is batts and strapping that need to be installed. !Important: Job needs to be done in tandem with our floorer who is starting on morning of 27th, as our timelines have been completely chewed up. Polyester rolls are arriving on 27th but prior to their arrival, batts will need to be installed in order for floorer to lay. Being able to do this is a timely fashion is super important to us so that we don’t hold up the floorer, as well as being able to work as a team (with our floorer) and prioritise areas that he needs done. I believe this is a ~6-8hr job for one person or 3-4hr for two.

Child's bedroom wall needs insulation to external facing wall. Dimensions 3500L x 1380 H x 220 D. Existing finish is painted plasterboard. Foam insulation to be injected into walls. Prefer sustainable options such as water or soy based.