Find an experienced handyman in Ryde

I need help installing my dog door onto my sliding glass door. You’ll need to bring your own tools. Price open to negotiation.

We are hosting a film festival at Event Cinema and require some movie posters hung from a higher level. Requirement is to have someone that has the correct competencies required to operate a scissor lift (cherry picker). Scissor lift is on site. Posters need to be nailed in to a ceiling recess approx 5metres high Please message for more technical information. Install must be tomorrow (Thurs 10th) anytime between 2pm and 9pm. We will be here to meet you to direct the work that needs to be done. Approx 1hr work

I want to render the lower wall and brick (cream section and brick). About 13-15metres and half a metre high.

Hi, I have a small leak underneath my kitchen sink from the white PVC waste pipe/trap. Looking for a plumber to inspect and fix the leak, likely a seal/washer or connection issue. Refer to pictures, circled in red is where there is a leak.

Hi, I’m looking for a reliable handyman to complete a few installation tasks around my home. The jobs include both indoor and outdoor mounting. Tasks Required: 1. Hang 4 picture frames - Must be mounted so the hooks are not visible above the frame. - Even spacing and alignment required 2. Mount 1 outdoor foldable clothes dryer - Bunnings Wall mounted unit outside - Must be securely attached to exterior brick wall. 3. Install 1 outdoor hose reel - Wall mounted outside - Needs to be fixed firmly for regular use **You will need:** - Experience with wall mounting - Drill, screws, anchors, level, and appropriate fixings - Ability to work with both indoor and outdoor surfaces Location: North Ryde Flexible timing.

https://easyshed.com.au/products/gable-roof-garden-shed-2-25m-w-x-1-5m-d-classic Fix to the concrete slab. Remove and dispose the old shed

I bought a set of Yoolax double roller blinds. https://au.yoolax.com/collections/double-roller-blinds/products/yoolax-motorised-double-roller-blinds For the life of me, I cannot get them to click into the clips. I need someone who's potential a bit taller with decent hand strength to give me a hand.

Looking for a handyman to help install a new hoselink retractable system, brick wall already has studs and holes, but for some reason when I mount the hoselink onto the wall mount apply weight , the top part of the screws keep moving out of the studs, I need someone that has the right tools to get this mounted properly.

Looking for a licensed plumber to replace a leaking inline dual check valve (backflow preventer) connected to a pull-out kitchen mixer tap. ​Details: ​Issue: Water is leaking out of the atmospheric vent hole on the existing brass backflow valve. ​Task: Supply and install a compatible WaterMark-approved replacement valve (or install replacement part) and test for leaks. ​Access: Easy, clear access inside the under-sink cabinet. Isolation mini-cistern taps are located directly under the sink. ​Please include whether your offer includes the supply of the replacement valve or labor only. Looking to get this completed tomorrow.

Looking for a licensed plumber to install a non-electric bidet toilet seat on my existing toilet. I’m currently planning to buy the Conor Elara O-Shape Non-Electric Bidet Toilet Seat (approx. 476 × 367 mm), which appears to fit my toilet. Alternatively, if you supply suitable WaterMark-certified bidet seats, I’m happy to purchase the seat directly from you instead. Please let me know the brand/model and price in your offer. My toilet is a close-coupled/back-to-wall style and there is no visible external water tap, so the water supply appears to be concealed. You’ll need to assess/access the existing cistern water supply and connect the bidet. Installation should include any fittings and backflow prevention required under NSW plumbing regulations. I have photos and measurements of the toilet available. Please include in your offer: * Installation/labour cost * Any required fittings * Experience installing bidet seats * Whether you can work with the concealed water connection * Cost of a suitable bidet seat if you can supply one * Any additional cost for required backflow protection Thanks!

Looking for someone to install a passage doorknob for an internal door. The door already has an existing 25mm hole from the previous doorknob, and the new doorknob requires the hole to be enlarged to 54mm.

I'm looking for somebody capable first off

Looking for an experienced gyprocker/plasterer to help us restore our walls and ceiling which were damaged by a plumbing leak. Please supply all materials and tools except where stated. Supply and install Gyprock/plasterboard/corner beads to: Job 1: sections that have been cut out from existing wall sections inside a linen cabinet when we were investigating a plumbing leak. Job 2: parts of hanging ceiling and corner beads where the leak (orginating in the linen cupboard Job 1) has damaged the ceiling. Approximate dimensions are provided in the images. We would also like to reinstall Earthwool or Mineral wool insulation. We can supply this, but would like your expertise to install. Please ask questions if anything is not clear.

Hello, We are looking to have a small utensil drawer installed in our kitchen in Meadowbank (Ryde area). The drawer would sit directly above our small microwave oven, inside the current microwave enclosure. The new drawer cutlery drawer would be done in the style to match the existing drawers. As part of the job, the facia around the microwave oven enclosure would need to be removed as it clashes. Additionally, the power point inside the microwave enclosure, may need to be moved downwards by about 150mm. I have supplied photos, and a concept sketch of the proposed cutlery drawer. We would like to have someone come out and visit us on site, and measure and quote for the design. We are looking to have the job done in the next few months. We have in mind a budget of somewhere in the order of $1, 000 to $1,500 for this task. Regards, John Drake.

Installation of two toilet seats that have already been purchased.

Install 5 vidaXL awnings/door canopies, with the following lengths: 4m, 4m, 2.4m, 2.0m, 1.2m. Ladders are available on site.

I require someone to dismantle a ninja playgym aprox 3.5mx3.7m and move into garage, direct access to back room easy to move into

Fix internal existing door so it closes. Needs adjusting and shaving so it can close. Also needs insulation of a new lock.

3 jobs in total Install 4 x TileWave acoustic wall panels (2700mm high). All 4 panels require approximately 20mm trim to height. Cut panel opening around Samsung Frame TV bracket and install panels. Mount 2024 Samsung Frame 65" TV - have the original bracket and a SANUS 42" - 90" Tilting TV Wall Mount Bracket if needed Install supplied Austral 8m Monument 5 Line Retractable Clothesline retractable to masonry balcony wall. Materials supplied: - 4 x TileWave acoustic panels - Existing Samsung TV bracket - SANUS 42"–90" tilting TV wall mount bracket - Austral retractable clothesline - Liquid Nails adhesive - Ramset masonry anchors - Washers - Screws Installer to supply all tools, saws, drill bits, stud finder, mounting hardware (if additional hardware is required), ladders and equipment required to complete the installation safely.