Find an experienced flooring expert in Alexandria

Seeking an experienced handyman with trade-quality power tools for 3 small assembly and mounting tasks in Alexandria. Must be available to complete this weekend. Scope of Work: 1. Mount ~2.5m Wide Whiteboard onto Concrete Wall: Mount a large whiteboard (~2.5m wide) onto a solid concrete wall. Tools Required: Must bring a laser precision marking device / cross-line laser level to ensure exact leveling across the 2.5m span, plus an impact/hammer drill with concrete masonry bits. Fixings: Expansion screws are provided. There are 6 pre-drilled marking points on the frame. Note: I will assist with lifting and holding the whiteboard in place during mounting. 2. Skirting Board Installation (~2.8m Run): Cut and install a ~2.8m long timber skirting board along the floor edge at the base of the wall. Tools Required: Saw/drop saw to trim a standard 3m length down to size, plus suitable construction adhesive/fixings. 3. Bar Table Base Assembly: Secure the thick wooden legs to the underside of a bar table top. Tools Required: Heavy-duty drill/driver with long timber bits capable of drilling pilot holes through thick wooden leg blocks. Fixings: 75mm long screws and washers will be provided on-site. Requirements: Must bring a laser level, impact drill (for concrete), high-torque drill with wood bits, saws, and general hand tools. Proven experience in wall mounting heavy items and precision leveling. Location: Alexandria, NSW

Timber floor has scratches due to vacuuming.scratches are lighter and it’s running from hallway to kitchen few parts and living room.looking for specialist to fix this

I got few scratches in my timber floor I need to repair

We are moving out of our unit and need someone to repair various edges of carpet and one small circular section in middle of carpet that our puppy had chewed over the last year. We have a large spare roll of carpet for you to use as replacement which is the exact off cuts from the new layout around 2 years ago

Showroom floating floor is sagging in sections and needs reinforcing

Repair these chips in the timber floor for a commercial office move out

Repair/replace the carpet that has mould on it, I do not have any spare carpet.

Looking for a quote to replace approximately 5–6 damaged hybrid floating floorboards in an apartment. Replacement boards are already on site and match the existing flooring. The current boards were previously replaced using the wrong thickness (7.5mm instead of 6.5mm), resulting in a noticeable lip between boards. Scope of works: * Remove incorrectly installed boards. * Install supplied replacement boards (6.5mm thickness).

Remove carpet and lay hybrid flooring for 1 living area and hallway. approx 25m2. Please provide quotes. I can provide an example of what flooring I am looking for or alternatively purchase and supply

Sand and seal the timber floor in a 16sqm room.

I have a 16sqm storage room that requires a handyman to install new ceiling tiles (approx 30, supplied, some will need to be cut to size), clean and paint the walls (2 coats, paint supplied) and remove old carpet.

I need the carpet to be stretched. It has tripping hazards.

Install 2x decking boards.

Looking for a flooring professional to: * Remove & dispose of existing carpet in two rooms (photos attached) of an empty unfurnished apartment (total area approx. 27sqm) * Prepare subfloor as required * Supply and install appropriate acoustic underlay * Source and install hybrid wood flooring * Install trims/scotia as needed for a clean finish
 * Ensure installation meets standard NSW requirements & give me proof ideally Site Details: * Located by Waterloo Metro * Ground floor apartment * Flat easy access * No dedicated parking spot, but street parking available nearby * Two rooms to do (total approx 27sqm) * Existing flooring: Carpet
 Please include in your offer: * Confirmation you can provide certification of the NSW standards met * Estimated timeframe to complete Thanks in advance!

I’m looking for someone to repair three small spots in my carpet. I have spare carpet available that can be used to cut patches and replace the damaged sections.

Need three different spots repaired in my carpet

Here is the link to the property: https://www.realestate.com.au/property-unit-nsw-alexandria-149216944 I’m thinking of keeping the bedroom carpet and then making the hallway/kitchen/living into a hybrid flooring. Here is the strata requirements: Please include the below details in your formal application which will be included in the strata committee meeting notice for approval: Details of the work, including any copies of the plans; Duration and times of the work; Details of the persons carrying out the work, including qualifications to carry out the work; Arrangements to manage any resulting rubbish or debris If the works include flooring we will require the below: Type of flooring and acoustic rating Details/quote from the contractor carrying out the works Type of underlay to be installed Location/s of proposed flooring Proposed installation date and time frame of works Arrangements to manage any resulting rubbish or debris

Strip a deck of approx 4 meters by 4 meters (including one step) and then white wash it to look like the pic below. Photo of current deck plus what I'd like it to look like. Deck is under cover.

Removal and installation of carpet tiles (already sourced) for 74sqm in office space (1 room)

Hello looking for floor board installer , I already have supply just need to know what Prices there is out there per sqm for installation