Find trusted local electricians in NSW

Air conditioner had been reinstalled due to balcony works. Needs to be reinstalled in the same place. Outside unit will be floor mounted. Hole through wall for duct already made, bracket already on wall. Copper pipe damaged and will prob need to be rewelded

I need 30 solar panels (Jinko 440w) reinstalled on to my roof. Had recently renovated and had to remove them temporarily. Just needs to be remounted on the second storey roof of my free standing house, may need some extra wiring. It likely requires installation on 4 faces of the cement tile roof and possibly a low flat section to fit all panels. Inverter is already installed (Growatt 10KTL3-X-AU). Only experienced solar installers and / or roofers thank you. Location is St Peters 2044. It's no rush, so can be done over several days.

i need a few data points to be connected back to the patch panel electrician ot data cabling trade required

Solar battery installation 30 kW to 42 kW single phase house single story solar panels already installed 13 kW solar panels with 10 kW sun grow inverter

2 bedroom granny flat full electrical job

Replace faulty sensor light in driveway

Need electrician to lower light in void area that is 6 m high. The light is too high. Need to pull it lower

I would like a deep clean of my air conditioning unit - Split System

Looking for a licensed electrician to replace a faulty miniature circuit breaker supplying power to my kitchen. The breaker appears to be dead/faulty: • No power is being supplied to kitchen outlets (fridge, dishwasher, microwave, etc.) • Lights are still working, but power circuit is not • The breaker will stay in the “on” position but does not restore power • The test button is not functioning, suggesting the unit has failed From what I understand, this likely requires replacement of the existing RCBO/MCB unit (Australec brand currently installed), but open to your professional assessment on-site. What I need: • Supply and install a suitable replacement breaker. Location: Surry Hills, Sydney Timing: ASAP Parking: Available nearby

Need to replace this broken switchboard

I’m in Bondi Junction and had my house pressure washed today. Since then, one circuit breaker is tripping and won’t stay on. Lights and other circuits are working fine, so the issue is isolated to one circuit. Likely water ingress to an outdoor power point, light fitting, or external wiring. Looking for a licensed electrician to: • Identify which part of the circuit is causing the fault • Diagnose the issue • Make safe and repair if possible Prefer someone experienced in fault finding rather than just replacing fittings. Located in Bondi Junction – flexible with timing but ideally ASAP.

I need a power point put in in my hallway! There is one on the other side of the wall so it should just be a matter of connecting through to that one

Hi, I have a double power point in my kitchen that is broken. Looking for a licensed electrician to replace it with a new double GPO. I am located in Epping (near Rawson St). Preferably looking for Alan T. if available! Thanks.

Needing to have two recessed kitchen downlights replaced. Need to supply and install.

I need to fit a double power point to the wall of the lounge room, I have removed the skirting board so all you will need to do is drill through the masonry wall and connect to the wiring shown in the photo on the exterior side of the wall, I will supply the power point and connectors.

If like to replace the exisiting with another— see attached photos

Install ceiling fan and wall remote

I need to install downlight in the house and switch boards need to be updated accordingly. There are 4 bedrooms, 1 living area and 1 media room. In total 36 downlight, 7 dimmers, some safety switch upgrades.

Hello, We are looking for a licensed NSW Electrician to attend our retail store, in Narellan Town Centre, to diagnose and repair a flickering ceiling light. The Issue: A recessed LED downlight in our main optometry room is persistently flickering. The Job: The task is to find the cause of the flickering and perform the necessary repair to ensure stable, constant light. The scope of work includes: 1. Safely accessing the light fitting in the ceiling (a suitable ladder is required). 2. Diagnosing the cause of the flickering (e.g., faulty LED unit, failing driver, loose connection, or a dimmer issue). 3. Supplying and installing a new, like-for-like replacement downlight and/or driver if the existing one is found to be faulty. 4. Testing the light thoroughly to confirm the flickering is resolved. Requirements: - MUST be a fully licensed and insured NSW Electrician. - You must be able to provide your license number. - You must have your own tools, including a suitable A-frame ladder for a standard commercial ceiling. - The contractor must be able to supply a standard replacement LED downlight and driver if required. Location & Timing: Location: Narellan Town Centre, 326 Camden Valley Way, Narellan NSW 2567. When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include all labour costs AND the potential cost of supplying one new replacement LED downlight. Thank you.

Pendant light install x 2 (purchased) & 1 x down light install