Find trusted local electricians in Central West NSW

Electrical 4 gang switch not working

Need to re route a cat 6 cable from under house To inside house Good access underneath Need to install a wall plate and fit off cable with rj45 mech. Need it installed next to the modem.

The below is to get my property compliant to be leased out. * Must be licensed electrician ** Please take before and after photos of any work completed 1. Replacement of Damaged Light Switches - Supply and installation of new light switch in laundry - Supply and installation of new light switch in kitchen 2. Switchboard Upgrade - Upgrade of existing switchboard to meet current standards - Installation of new Main switches - Installation of new SPD/MPD - Installation of RCBO (RCD) protection to all circuits for rental compliance - Safe removal and replacement of existing asbestos switchboard panel - Installation of new compliant switchboard enclosure - Labelling of all circuits - Testing and commissioning upon completion 3. Compliance certificate

One of the electrical switch broken. Electrician required

Urgent Solar & Battery Installers Needed – Condobolin NSW Chasing experienced solar & battery installers around Condobolin (within Condobolin & Surroundings 100km radius). Must have: • Solid experience • SAA battery accreditation • Own tools & insurance • Available ASAP Ongoing work for the right crew. Ready to go now.

I need a quote to install a new instant water heater and removal of the old unit as well as to complete drain pipe connection to storm water pit (image shown). Please provide me with your best quote.

Hi, I am looking for an electrican to draw cables, install Led lights, rangehood, replace power points, switches, etc. I will supply the material. Approx. 8 Lights 12-14 power points 7-9 light switches

An electrician has rewired some new connections in my house but has unfortunately left for overseas. All wiring has been done. 1) I need the wires in the switch board connected. (3 circuits.) Wires are in the board 2) I need the light wires connected to switches for all light circuits. Wires have been run and connected to switch bit needs to be connected to the switch. Approx 7 switches. 3) Hot water tank connected. Circuit and wires already there.

Install a 15 amp power point

I need an electrician to install new power points, switches and light fittings

I was wondering if I could get a quote to make a pathway for an NBN FTTP upgrades Pathway from PCD (external) to NTD ( Internals) Telecoms conduit with drawstring with sweeping bends no sharp right bends. Cat 6 Cable

Changing lights to LED in a number of properties

Looking for an electrician to do some work at my home in Orange. Install 3 power points. Also a plumber/ handyman to get some work done in the bathroom. Please let know if you know anyone from the community with humble pricing. Any handymans out there.

Please provide a quote Get a quote for the Total Job price including travel and any extras. Objective . Get power connected to old house for renovations. The purpose of this work is to: Install a new compliant switchboard and meter box Install two new dedicated power circuits (each with a double power point) directly from the new switchboard. The existing/deregistered house wiring is not to be connected or certified. 2. Scope of Work Stage 1 – New Switchboard & Meter Box Supply and install new compliant switchboard with main switch, RCDs, and earthing. Install main cabling from point of supply to switchboard. Ensure full compliance with current wiring rules. Stage 2 – New Circuits Run two new circuits directly from the new switchboard to two double power points. Use compliant cable, conduit, and accessories. Circuits separate from existing house wiring. Exclude any connection or assessment of existing/deregistered wiring. All work must comply with: Rules All materials must be new and certified for Australian standards. Access to property and existing electrical infrastructure is provided,  existing wiring not be energised or connected.

Running new cable and changing light fittings. Ongoing work. Need a team of 3-4 guys

Extra power points to be put in

Hi there, My partner and I are currently building a camper. We have converted a horse float and are in the process of the internal fitout. We are having a 12v solar electrical system as well as 240v. We have a shore power outlet and an inverter. For our compliance we know that this electrical work has to be done by a licensed electrician. We are at the stage of wiring and before putting on our walls we need to have someone check over and approve the wiring and then in the coming months we will need someone to connect and approve all our electrics. Hope that all makes sense and any further clarification just ask! Appreciate your help, Kind regards, Michael

Finish wiring Bathroom and check other (walls are not gyprocked)

Network Rack Cat 6 cable Patching. Connecting cables from Patch to the Network Switch

Need someone with an electrical background to help install an outdoor light