Find trusted local electricians in Balmain

Install 4 ceiling fans in an apartment to existing ceiling lights

Looking for a licensed electrician to replace a faulty B22 light fitting in my rental property in Balmain. The internal B22 insert cracked while changing a bulb. When removing it, the circuit breaker tripped. The internal contact appears burnt/exposed. Job required: • Supply and install new compliant B22 batten holder (or advise if full fitting replacement required) • Inspect wiring for damage • Test circuit and ensure safe operation Power will be turned off at the breaker before arrival. Please confirm: • NSW electrical licence number • Availability • Total price including parts Should be a quick job for someone qualified.

I need these light switches replaced. I have new ones from trade co so it’s just an easy swap over.

Backyard with 6 Lillypilli trees

I have two used Powerwall 2 batteries sitting on my front deck ready to be installed. The job: Remove current battery (tiny 3kwh Alpha) and replace with two PW2 with a new gateway. GW and PW2s are within 1m of where they need to be installed.

I have two light fittings that I need hung, currently it’s just one bulb hanging from the ceiling rose that the builder left there

Hello, There’s a slight change to the scope of work. Work – 1. Outdoor Lights Replace the three existing plastic outdoor lights with chrome fittings. I have purchased the following: • SAL Bondi SE7122TC/24 Series Exterior Wall Lights. 2. Garage Tube Lights Replace the two existing garage tube lights with longer warm-white tube lights. I have purchased the following: • SAL Ecoline SL9738-TC-DP2 LED Wide Body Diffused Batten. 3. Garage Switch & Power Outlets Move the existing garage light switch from the far wall to the entry doorway, and install a new double power outlet next to the relocated switch. At the original light switch location, please change the powerpoint plate so all three outlets match. Please supply: • 1 × Clipsal Iconic light switch • 2 × Clipsal Iconic double power outlets This will require conduit and a mounting block. 4. Garage Door Cable Tidy and secure the garage door cable along the ceiling and enclose it neatly in conduit. --- Materials to include – • 1 × Clipsal Iconic light switch (Point 3) • 2 × Clipsal Iconic double power outlets (Point 3) • Conduit (Points 3 and 4)

One light is missing a clip on one side and won’t stay in the ceiling. The other late also won’t stay in but has 2 clips. Both fall out after a few minutes

1. Outdoor Lights Replace the three existing plastic outdoor lights with chrome fittings. I’ll purchase these lights: SAL Bondi SE7122TC/24 Series Exterior Wall Lights. 2. Outdoor Power Outlet Replace the yellowed outdoor power outlet cover with a new fitting. Please supply and install the following: Clipsal Iconic Outdoor Twin Switched Socket (O3025-XW). 3. Garage Tube Lights Replace the two existing garage tube lights with longer warm-white tube lights. I will purchase these: SAL Ecoline SL9738-TC-DP2 LED Wide Body Diffused Batten. 4. Garage Switch & Power Outlets Relocate the existing garage light switch from the far wall to the entry doorway, and add a new double power outlet next to the relocated switch. At the original light switch location, replace the existing powerpoint plate so all three fittings match. Please supply one Clipsal Iconic light switch and two Clipsal Iconic double powerpoints. 5. Garage Door Cable Tidy and secure the garage door cable along the ceiling, enclosing it neatly in conduit. --- For your quote: Please provide labour costs. Please include the cost of materials, specifically: One Clipsal Iconic outdoor powerpoint (Point 2) One Clipsal Iconic garage light switch (Point 4) Two Clipsal Iconic garage powerpoints (Point 4)

Remove existing air conditioner. Supply and Install a 7.1 KW air conditioner Fujitsu. Dispose of current air conditioner. Must be licensed. Must provide receipt for warranty of air con unit and labour.

A/C is not working needs either a service or fault finding.

One of my bathroom light not working, have replaced the tube light and the starter. The wire connecting the ballast seems burnt with browning at the ballast connector. Possible the ballast and the wire needs changing.

We have a roof with solar panels and I need to take 2-4 panels off for 2-3 hours to fix the roof below Roof is quite flat, can store panels on site, and on roof. Photos to come later

Electrical fit off post renovation. Appliances to be installed listed below, wiring has been done. - PowerPoint for oven - PowerPoint for microwave - PowerPoint for wine fridge - PowerPoint for washing machine - PowerPoint for dryer Supply of PowerPoints - generic ones are ok

I need the below electrical work done in my commercial kitchen: 1. 15amp plug installation for my commercial dishwasher - picture 1 2. change two fluorescent lights (I will supply) - picture 2 + 3 3. remove 2 old light fittings - picture 4 + 5 4. fix exit sign, the light is not working

Isolate 2 light fittings. Delete 2 light fittings. Isolate a light switch and power point.

The signage light or cable connection is not working. The task will be to disconnect & remove business sign, move or relocate to the other side and refit to the underside of the awning including cabling and reconnecting it. Need to sort the cabling to make it work. On another sign need to install 2 led floodlight. Led floodlight will be provided but you need the mount bracket to hold the led floodlight. Ceiling need to be glued, very small task (as shown in first picture) which falling apart. All work must be guaranteed. Please ask any questions you may have & propose your final quote, after finalize no extra quotation will be accepted.

I have 3 small jobs required - install new light ar front of house (have light) - remove plug from wall that is no longer needed - fix broken switch

Dirt bike won’t spark, engine fine

We have a Mitsubishi aircon in the bedroom that we disabled during a renovation few months ago. We need to reconnect and restart the unit. It’s currently fixed on the wall and the exhaust unit is outside, but not operational. It’s possible it may need servicing or repairs.