Find experienced local carpenters in Elwood

I would like to get a quote for building a bathroom cabinet

Please read the following job description before replying: built-in joinery removal, kitchen cabinet modification, construction of an MDF bulkhead/infill, and make-good of affected surfaces. Including a bit of timber replacement for the doorway frame when book shelves are removed - see photo. To be done early August or first week of August in Elwood latest. 1. Lounge: neatly remove wooden shelves from lounge room around fireplace (see attached photo). No need for electrical re-wiring 2. Kitchen: neatly remove wooden shelving on Kitchen splashback (see attached photo of the kitchen that needs work including a sample photo) 3. Install bulkhead above upper kitchen cupboards and you don't need to paint it and I can pay extra for MDF material (see attached photos). Length of Kitchen is approximately 3.5m (cupboards travel the whole length) 4. Remove shelf of Kitchen cabinet so I can fit my fridge (see attached photo)

Need cabinet alongside fridge door trimmed down to make more space. Fridge fits and doors can open but not fully. Need someone this weekend (18th/19th). Please see images of fridge, surrounding area and the inside/outside of the cabinet. I am not too fussed about what is done or how it looks, main focus is functioning. Please include what work you would do if offering alongside cost and time needed to complete.

Inspection Only - need a cabinet maker to replace skirting after dishwasher installation.

Extra shelves needed for cd’s. Timber provided and other little jobs for extra $.

Inbuilt wardrobe to be built for a spare room. Made of MDF unpainted. 2500 wide 2800 high (or higher) 500 deep I need three drawers built in 400 high by 80 wide (x2) 250 high by 80 wide I need the remaining space in the wardrobe to have adjustable shelving and hanging space. All measurements are approx. definitely a job you need to see and quote in person. Available during the week to come and quote in Elwood. Thank you!

I have a bathroom cabinet (shaver with mirror) that needs to be installed.please note it is a concrete wall. Hammer drill can be provided if required. There is an inbuilt light, as well as an additional LED Light installed. Rewiring of the other appliances will be required. Must be a registered electrician who can provide summary of works and be insured.

Door for an integrated dishwasher to match existing cabinets. New integrated dishwasher coming to replace the built in.

Looking for a builder / carpenter to help complete a camper fit-out in my van (VW Crafter). I will provide all the parts! Just need someone with the skills and tools to build everything :) everything wooden, and as light weight as possible :) Scope of work - 1. Rear Drawer System (Boot) • 1 x heavy-duty slide-out drawer system • Approx. 1600mm length, 40cm depth • Needs to be strong enough for camping gear (very sturdy, no wobble) • Top surface/lid to be usable as a table/work surface 2. Internal Cupboard Unit • Build a compact cupboard inside the van • Include 3 x slide-out shelves • Clean, minimal finish to match existing interior • Practical for storage (clothes, food, gear etc.) 3. Insulation • Insulate rear barn doors + sliding door, cover with plywood 4. Finishing • Grey paint + wood stain to match current van interior Details: • Van: 2023 Volkswagen Crafter • I already have a rough layout in mind but open to suggestions

Remove plywood (stubborn rusty nails tough to remove). Replace with new plywood, plus two pieces of plinth board to create a bar top

3 deck areas - balcony deck sand and stain - (quite weathered will need full deck sanded will need a few coats) - front door deck slight sand and stain ( patchy areas to sand only) - back larger deck light sand in patches only and stain in good condition won’t need much stain, mainly patches - hammer down nails that have lifted

Our IKEA integrated dishwasher is not opening / closing properly - we need someone to go check out what the issue is and either resolve it with new hinges / etc. or installing a new cabinet front to the dishwasher with proper hinges/rails. I believe it wasn't installed right in the first place, and was GLUED onto the dishwasher instead of on the conecting rails. So some kind of glue removal might be required to save us from replacing the whole dishwasher. OR remove the (damaged?) IKEA cabinet door and PICK UP another one from IKEA in richmond / springvale. I can give you the exact products we purchased with the original kitchen. I basically need someone to work out what the problem is, and solve it haha. Let me know if you're my guy/gal! Available Saturday for urgent attn.

- Install Plywood Sheeting to windows to board up all access to house - Screwed to the window frames with large lag screws. - 7mm thick ply used for strength.

We have a washer/dryer set designed to be stackable, however due to pipework and the location of the electrical outlet, stacking directly isn’t possible. We need someone to build a very sturdy shelf/platform to safely support the dryer above the washing machine. Requirements: • Must be load-bearing and stable • Properly secured (not a basic floating shelf) • Must account for vibration from dryer • Open to practical, clean-looking solution • Experience with similar handyman/carpentry work preferred

Require carpenter to attach 27m of chair rail and 80m of pine moulding to plastered walls in 2 rooms - entrance/hallway and lounge. All timber supplied, wall moulding design and placement has been templated on the walls (see pics). Job requires cutting timber joining and attaching to walls.

Need a carpenter to build a storage solution in a pantry for the space underneath the stairs.

Build a strong quality wooden staircase in a 10 feet corridor with 10 feet elevation and 1 m wide. Note: There is an existing attic ladder setup in place. Also Building Permit (BP) compliance will need to be completed.

Needing to fix onto a trailer. 2 sets of 99L chest fridge/freezer. Needing it to be secured down and drilling / making a cabinet for the trailer also to house certain units. (Supplies provides/materials provided) (Tools not provided)

Replace some skirt /timber at the base of sliding glass and use filler also

I need a carpenter or someone who is able to fit a panel of wood to a stone frame and make it stable. It’s for a laundry space!