Find experienced local carpenters in South Yarra

Build stud walls, battens and install cavity sliders, roof battens where noted

Fit new door hardware (hardware provided) to 3 double doors in apartment in South Yarra. Must have experience. Rate quoted is per hour

Hello, I’m in need of a handyman with a drill to carry out a small job – specifically, making a larger hole in a cupboard and drilling through a piece of wood. The work can be done this evening or tomorrow evening at your convenience. No additional work is required beyond the drilling itself.

I need a carpenter or someone similar to install doors under a concrete BBQ area. The BBQ itself has been installed but is not shown in the picture below. potentially using H3 Treated Pine. Below is photo of the space and two examples of the type of door. BUDGET DOES NOT INCLUDE MATERIALS

I an upcycling an old standing wardrobe into a bar cabinet. I need 3 shelves in it on the left hand side (measurements below). Can supply materials or happy to pay for them. I can probably figure out installation myself, but please quote for installation also! Shelf 1 - 55 x 38cm (to hold glasses) Shelf 2 - 55 x 38cm (to hold liquor bottles) Shelf 3 - 55 x 3X? Cm (mounted to side mount drawer slides to pull out for mixing). Thanks!

small double story residential renovation downstairs and only is fully demolished and cleared providing a dedicated fabrication work area Notes; currently no power on site. You must be self-sufficient (generator-battery tools). Scope of works (carpentry only) -Structural and room layout framing (staircase extend existing stair wall and ensure illustrator is fixed structurally sound, study frame up new internal wall partition, powder room frame up new internal wall partition, scullery kitchen area general partition framing to plan. Carpentry-custom archways construct framing for two custom arch bookcases with specific radius edges specified architectural brief. This includes sculpting the precise curve framework for a plaster to follow. Window-door openings open (upstairs); all new internal doors and windows are specified for a clean minimalist square set finish (no architrave-frames). This requires precise framing-ground work. -Rectification and prep; Review and fix patch strengthen all existing ceiling framing and upstairs wall structures (patching of full re-battening – reframing, to be discussed on site). Frame up two new cavity sliding door units Ensure all areas intended for built-in wardrobes of framed square and true. -Require Qualified companies (certificate frame or Builder referred). Demonstrated experience structural residential framing Specific experience and constructing custom art curve framework square set window prep Must have own tools and be self-sufficient for power Reliable, clean and organised. Please providing examples of previous detail detailed framing work and confirm your availability for an immediate site visit.

Install two cabinet doors in the kitchen.

Kitchen install required

Hi, I am looking for a carpenter to install 2 jambs for a single door. I have the jambs ready (ordered slightly longer than needed so one cut needs to be made on each) The task involves: > Remove existing MDF jambs (please do not cut these inside) > While old jambs are off, check if anything is water damaged behind and repair/replace (can pay extra) > Install new jambs > Reinstall door & strike on new jambs > Recaulk any gap between new jambs & walls/tile. There is no architrave , but a small section of wall above the door (see pics with arrows). The jambs run along this at the top, so this section of plaster may need to be removed in order to install jambs and replastered after? Please let me know if you can do the whole process. I am looking for someone quaified, careful, and experienced. Also who has some reviews and pics of previous work. Thank you 🙂

> I need a handyman to supply and install a reinforcement base for my Australian King bed (183x203cm) to stop my Tempur mattress from sagging. > The Task: > * Supply: 2x Sheets of 12mm Plywood or MDF. > * Prep: Cut to size (split king setup) and drill ventilation holes across the surface for airflow (Essential). > * Install: Place on top of my existing slats. > Please ensure the wood is sanded smooth so it does not damage the mattress fabric. > Location: South Yarra.

I want to replace the warped closet doors in the entry. They are 56cm wide by 186 high. 30 cm door width

I need 12 solid screw in bed legs made for two twin beds. Currently, they have 13 inch legs with 5/16" threads (attached) which don't seem strong. I'd like 12 heavy duty ten inch height legs with 5/16" threads that will support the bed better.

We’re looking for a cabinet maker, shopfitter, or experienced handyman to help straighten eight upright wall units and secure them firmly to the wall. The units are already in place — they just need to be aligned properly, levelled, and fixed securely so they sit straight and stable. Ideal for someone with experience in cabinetry, shelving installation, or retail fit‑outs. Looking for someone reliable, careful, and reasonably priced.

I need 2 x IKEA Cabinets installed high on a wall - I am nervous my wall isn't strong enough and want to understand if it's even possible before I buy them. https://www.ikea.com/au/en/p/besta-wall-mounted-cabinet-combination-white-lappviken-white-s49442006/ Happy for a quote including and not including assemblilng them too. Thanks

Need to fill this holes and fix/paint or try to minimise these stains

I need six cabinets and an insert built

follow the ESV requirement, we are required to have a 2.5-3mm stainless steel plate on the the deep fryer. We need stainless steel plate is heat resistance. And cut with a curve (so not cut staff)

1800D round plywood table to sit on top of round 1550 round. 9 or 12mm. Supply materials and deliver

The timber on the balcony has rotted/ hollowed out, it was aalso supporting the balustrade. It needs to be replaced.Also need to warterproof the balcony and replace the timbers which have been rotten - I believe it will be one day job. $450 plus materials.

Coffee pot exploded and coffee grounds stained on walls and ceiling. Tried to scrub but it’s still there, if you have a wall steamer or can recommend how to clean would be eternally grateful as renting! Happy for offers