Hire a professional washing machine repair service in Collingwood VIC

Hi there,My LG washing machine has an OE error code and is currently empty and unable to automatically drain.I checked the front drainage filter cavity, and the internal propeller blade does not look right or may be missing. I suspect the machine either needs a replacement drain pump, drain pump motor or there is a main drive motor/spin issue preventing the cycle from advancing. I need an experienced appliance technician to properly diagnose the fault and repair it. Requirements:Bring tools to manually drain the machine and inspect the internals.Diagnose whether the issue is a faulty drain pump, a main motor issue, or a severe blockage.Source and replace the faulty part (or clear the blockage).Test the washer through a full drain and spin cycle. The posted budget is for your diagnostic and labour time. If a replacement part is required (like a new pump or motor component), I will pay for the cost of the part on top of the task rate upon proof of receipt. Please let me know your experience with LG laundry appliances when bidding. Thanks!

Need someone to repair my LG washing machine, model WV9-1408B. It trips the circuit breaker immediately when plugged into the power point. Looking for someone experienced with LG washing machines who can diagnose and repair the issue. Please provide an approximate price range for the repair in advance, including call-out/labour if possible. Location: Collingwood 3066.

moving washing Machine need to add bolts back in

My washing machine or plumbing around the washing machine is leaking when used in my apartment. The washing machine is a Samsung 7.5kg/4kg Washer Dryer Combo WD75M4453JW. I need someone to go and see if they can fix the leak.

Looking for someone to connect the washing machine hoses up and ensure it runs as expected without leaks.

I’m looking for someone to replace the rubber door seal (gasket) on my Electrolux UltimateCare 500 8kg front-load washing machine (Model: EWF8024Q5WB). The seal needs replacing. I haven’t purchased the replacement part yet, so I’d appreciate someone who can either advise me on the correct part to order or supply the part themselves.

I need the power cord replaced on my Bosch Serie 4 washing machine. It has plug gas corroded / burnt due to hea lt and moisture in the laundry / not fitting properly. See photo.

Reverse the fridge door (LG GB-455MBL 420L Bottom Mount Fridge) and help to balance a new washing machine

Need help disconnecting supply hose from back of Bosch washing machine to feed through cut out in bench. The end that connects to tap has bulky solenoid that won’t fit.

One of the hoses at the rear of the washing machine seems to have split or come loose - when water is turned on it leaks and sprays out of the back of the machine in the pictured hose fitting area The washing machine is.a top loader Esatto

Hi there, I need the hose for my washing machine to be removed and replaced, the laundry cupboard door to be reattach and several hooks to be placed on the wall for towels

There are two things to be done: 1. I need someone to seal behind where my washing machine is to avoid any rodents coming through, for this I have purchased steel wool but open to advice. 2. Allow me to clean behind the washing machine and then need someone to put washing machine back in place but on motion absorption stands which I have for each corner.

I need help connecting my washing machine to the water supply and drainage pipe. Very simple and easy job. I just can't figure out why I'm getting an e02 error when I try, but anyone else should see the issue pretty quickly! I'm probably not connecting it properly

hi I have a kogan 6kg top loader washing machine that I would like installed please

Our gasket in the washing machine has a hole, we have a new gasket just not sure how to install. Unrelated our toilet is blocked and water is rising/unable to flush

The washing machine shakes a lot on spin cycle. It is not missing a foot.

Just moved in to the house and I tried to connect the new washing machine, but the mount tap is leaking, I need someone to help me fix it asap. Photos attached

There is a leak coming from somewhere in the bottom of my washing machine that releases water when it is on a cycle. Cannot find the source of the leak. It is a Kogan frontloading washing machine

I need a qualified plumber to create the plumbing required for a dishwasher and a washing machine. The washing machine is on the ground floor and is being installed next to the hot water system. Taps and drainage to flow into the already established system next to it. Washing machine plumbing to be installed in kitchen, using the existing kitchen sick water supply and drainage. No installation of dishwasher or washing machine is required, just the pipes and drainage system attached to existing networks. Please see photos for more information. Dishwasher will eventually be placed where the fridge is, you can see the distance from the fridge underneath the counter tops to the sink and associated existing pipes and drainage system. Washing machine to be positioned where the red circle is, next to it is the hot water system which is enclosed in a timber cover, which is next to a sink with pictured existing piping and drainage.

Service Electrolux washing machine that's out of warranty. We suspect rubber seal needs replacing. Model number: Electrolux ewf7525dqwa 7.5kg front load washer, Quick 15 option.