Find experienced local tradies in Ryde

20sqm floating render no sponge finish. Preparing bathroom for tiling and waterproofing

There is a straight crack running horizontal to our outdoor wall (double brick and rendered) Hoping to get it cosmetically patched up as close to the same rendered wall colour and texture as possible. I do not have the paint so you will need to source that once onsite. It’s about 5m long in length.

Scope of Work: Cut and fit gyprock to patch 6 ceiling holes (see photo attached) Tape, set, and apply joint compound (at least 2 coats) Sand flush and smooth for a flawless surface Final result should be invisible – no sign holes were ever there Job Requirements: Must bring own tools and materials Must have experience with ceiling patching and blending paintwork

Need a carpenter or gyprocker to firstly frame two false walls then sheet set and sand Nail two 45mm Timbers to ceiling every 600 then sheet set and sand All materials supplied

2.1 meter with X 3.25 Long X 2.7 meter height all the old tiles striped and clean wall needs the render for half hight and the tiles floor and walls up the sealing. Hourley rate or day labour all materials supplied. if necessary photos can be attached.

2 x power points One behind tv the other in a bedroom

In the kitchen, I need a mains power connection that previously powered a 20+ year old stove into w power point to facilitate upgrade of the cooktop. Installation of the cooktop is being completed by the gas fitter at 7.30am Thursday so it's essential this task be completed today

I am planning to get Illume LED light, but would prefer it to look like a real skylight, so want to have a recess built into the ceiling for it. Cut out for the LED alternative skylight, gyprock, set and sand and paint to match existing ceiling I have dropped ceiling, 300mm worth of clearance and power connection in that spot. I’ve been told it’s a very easy ceiling to work on. First photos the ceiling, last photos examples of effect I want to end up with.

Paint front render of house. Some hairline cracks which need to be addressed.

Want to install Bunning Windoware 3 x 2m Charcoal Easy Fit Awning to side of house, Can help lifting & holding

Need help patching a small circular crack in the gyprock on the ceiling which opened up when cleaning the surface with a sponge. A piece of the gyprock seems to have pushed inwards.

There's a small patch on the ceiling in the pathway that needs to be replaced and painted. Also, I'd also like the ceiling in bathroom painted. One coat to refresh. The bathroom is approximately 2 meters I've attached some photos for reference.

Installation in a Strata Apartment About 10 double power points (subject to suitability of position)

I need the gyprock repaired above an internal doorway on both sides. One side requires a repair about 1200 x 600 and the other side is much smaller. The wall was damaged by termites a few years ago. The repairer will need to supply all materials.

12cm by 14cm hole in drywall. Need repairing and possibly painting to colour match wall. Need it done asap.

Our balconies are north west facing hence direct sunlight throughout the day. Need a solution for that.

Need to repair the plaster on ceiling due to water leak

Install 15 amp double power point inside of garage on separate circuit. Garage is 3m wide, so approx 6m of cable required from meter box to new switch location.

Very large common wall (duplex) with dark exposed brick to be gyprocked and painted. Both upstairs and downstairs. We just bought the house and don’t settle until end of May. We cannot get exact measurements but wanted very rough estimate please

We are seeking an experienced professional to assist with the following home electrical and AV tasks: 1. Relocate Coaxial Cable Move an existing coaxial cable to a perpendicular wall approximately 3 metres away. Scope includes: * Removing trim * Cutting drywall behind trim as needed * Drilling through studs (if required) * Rerouting the cable * Installing a new wall outlet for a clean, professional finish * Put trim back in place 2. Relocate Power Point * Shift an existing power point approximately 40cm to the left and raise it to a height of 90cm. 3. Install Additional Power Point (Near Sofa) * Add a new power point beside the sofa. The nearest existing outlet is on the opposite wall, so this will likely require running new wiring through the trim and drilling through studs beneath the window wall, similar to the coax relocation approach. 4. TV Wall Mount & Cable Management * Mount a TV securely to the wall and conceal power and HDMI cables by drilling a pass-through hole for a clean, tidy setup. Note: We already have the TV wall mount bracket. --- Please provide: * A quote for the full job * Estimated time to complete * Any additional materials required Experience with similar AV and electrical installations is preferred.