Find experienced local tradies in Kedron

Approximately 2 square meters of damaged ceiling that needs replacing. Also some holes cut into wall need repair. Need a licensed plasterer.

An awning has come away from the house. It will be difficult to refit as the current brackets don't line up to the timber behind (never did. only one is in). I need a clever solution for it so that we can sell the house.

I need my awning removed and taken to the tip, should be relatively simple in nature to remove, screws connecting the roof of the awning to the gutter are just normal screws, i have replaced most of them in the last 12 months so they wont be stuck. Then there are 8 screws into the balustrade. Then the whole thing needs to be taken away, photos are explanatory but let me know of any questions

All rounder plasterer, can frame, sheet, set, happy to do little patch jobs around the house, availability is 3pm-6pm M-F and usually all weekend

Ceiling is coming away from the beam and sagging, which is causing cracks. The cornice is also coming away from the wall and cracking. The area is approx. 1m x 2m.

The brand new sauna was dropped by the courier while being delivered. The ceiling has been damaged in several places. We need it to be repaired for our customer. The timber is western red cedar. Not sure if it ca be repaired as new or needs to be replaced. There is alos a damaged light cable which we can send if required.

Peeling rendered brick internal wall

Our existing batwing gates to our verandah are rotten and need to be removed. We have new gates to replace them and need these to be hung following removal of the old gates. (new gates shown next to existing gates in 3rd picture) We will provide new hinges and a drop-bolt an would like to reuse the existing key/latch if possible. The new gates are slightly too tall so approx. 1cm will need to be planed off the bottom prior to installation.

Looking for someone to install 4 window awnings for double storey house.

Replace bottom rail of both balustrades and install new slats ton half of each balustrade (may be able to get away with less). Painting will be done by others. Materials to be supplied and installed by Airtasker, including removal of removed materials.

We are renovating a Queenslander and various areas where plastering is required. Stairwell, closets, walls, plaster cornice install and some repair work to previous plastering. There are also some original horsehair plaster cornices and ceiling roses that require repair work. We are looking for a skilled trade in plastering, ideally with experience in horsehair plaster. We are happy to pay based on an hourly rate of $60/hours

Install gyprock ceiling boards on a low internal ceiling. The ceiling is LESS than 2.1m high, the room is L shaped and will be emptied. The ceiling has already battens installed to attach the gyprock boards. 70mm Ceiling Insulation has to be installed together with the gyprock boards. The areas are about 2.55m by 7m, and 2m by 4m. I will buy 2.7m gyprock boards, and 2.4m boards that have to be cut to size as required. Due to the spacing of the ceiling joists, the width of each board has to be cut down, as well as the length. About every other board needs holes cut for downlights. The room is ground level and the gyprock sheets are stored right next to the room, with space to work. Your job: -Cut gyprock boards to size -Cut holes for downlights -Install ceiling insulation without gaps -Install gyprock boards -Plaster all gaps and screw holes I will provide: -gyprock boards -ceiling insulation -screws -plaster YOU must provide: -Any tools and equipment required to do the job professionally -a helper if you can't do the job alone Your offer must be inclusive of costs, fees, and GST as applicable.

Repair job only, tape has lifted in a few areas of laundry, re-seal and paint... ceiling white is british paints

Needing the gap between internal rendered wall and gyprock ceiling filled to square set aswell as two gpo’s. Two bedrooms and hallway.

Paint side fence, gate, garden bed render and render along edge of pool and alfresco tiling. One side of fence (including capping) and one side of gate, approximately 16mx1.8m, in two section, mostly lapped and capped. Garden bed render to be painted on front and top edges, approx 24mx0.3m. Patio and pool render one edge only, approx 8mx0.2m and 16mx0.05m. Need 2 coats to all surfaces. We will supply paint, drop sheets and brushes, spraying not an option. Preparing for sale so need extra care taken not to damage plants or get paint on plants and as little as possible on grass. Price negotiable.

1)Replace light switch 2)Replace cover and switch on power point 3)Replace light batten (low ceiling) See photos

We used a wet render on the house and forgot to clean a few areas on the black iron pool fence. Require removal and cleaning, acting on behalf of the owner

Replacement / repairing of eroded and damaged bulstrades

Need to install 6 new power points. Probably 3 of these should be on an existing circuit and the other 3 should be on a new circuit with an additional circuit breaker.

We are looking for a Plasterer to come in and patch up areas internal and underneath our house. Happy to be negotiable. Under the house has concrete that needs to be chipped away and needs to be relaid on cracks