Find experienced local tradies in Canberra Central

Resurface/refinish a bathtub using tub&tile refinishing kit. See photos.

Patch around added in window reveals Scissor lift provided for access

Connect Apollo Folding-Arm Awning – Licensed Electrician Looking for a licensed electrician to connect an Apollo folding-arm awning to the nearby existing power supply/junction box. Work required: * Connect the awning motor to the existing power supply. * Check and connect the wind sensor. * Check the existing wiring and confirm it is suitable for the motor and sensor. * Complete the installation safely and in accordance with Australian electrical requirements. * Supply any minor connection materials required. The power supply/junction box is nearby, so access should be relatively straightforward. Budget: $300 Please only respond if you are a licensed electrician and able to provide the required electrical compliance documentation.

I’m looking for an experienced painter to paint a medium-sized bin room with rendered walls. I can provide the required colour, but you’ll need to supply the paint and all necessary materials. Please ensure the surfaces are properly prepared and the finish is neat, clean and professional. You’re welcome to visit the site to inspect the areas and provide a quote before starting the work.

I would like my brick pillar approximately 120cm high × 60cm wide rendered with a smooth, high-quality white finish. The pillar has an integrated parcel box, so care is required around the box and edges. Looking for an experienced renderer/plasterer who can achieve a neat, smooth and professional finish. Budget: $750, including materials. Canberra location. Please provide examples/photos of similar rendering work.

Stop 10lm of gyprock joints where door has been relocated

I need a handyman to patch and repair two small areas of damage in my home: Drywall: 1 small hole that needs patching, sanding, and flushing smooth. Internal Door: 1 small hole/dent that needs filling and smoothing. Painting: Both spots need to be painted over to match. I do not have any paint, so you will need to supply a standard white paint that matches or matches closely enough for a neat finish. Requirements: Please bring all necessary tools, patching compounds, sandpaper, and standard white paint. Must leave the areas clean and tidy. Location: Dickson, ACT Budget Estimate: $120 - $180 (depending on paint matching/supply)

Need someone who’s decent at plastering to to plaster these joints and get ceiling paint ready. Area is roughly 2m x 1m

I need a hole in a ceiling plastered and sanded smooth to be level with existing ceiling please. Hole was caused by tile falling but roof since fixed. I'd like tomorrow evening for job if possible or afternoon of Tuesday 22 September before 5 pm please.

Looking for a plasterer to supply and install Gyprock and cornices to a 7.4m x 3.3m steel frame garage. Skillion roof. One end wall has a door/window cutout, the roller door end is completely excluded. Total area is 67m².

Repair cracked plasterboard wall, sand and repaint within 2 days

Lower my power point below bench height

A pocket door came off the rails. I tried to fix it myself and made a mess pulling for a bit of drywall up and not resolving the situation so I need the door fixed fixed and reinstalled on the rails properly. I need a large chunk of drywall replaced I may also need some assistance with installing roller blinds and would love some advice on replacing skirting.

Removing several power points from 2 walls in a office.

I power point in lounge room 1 in dining room Double required in 2 hallways 1 double in bathroom

Crack render under window and render blow

I need a licensed electrician to complete the following work: - Replace a damaged double power point in my kitchen with a like-for-like double outlet. - The existing faceplate has broken retaining clips and needs to be replaced. Photos attached. - Install one new double power point on the adjacent wall in the location marked by the red box in the attached photo. Photos of the existing outlet and proposed new location are attached.

I just bought a 2x2.5m Kings awning and need some help installing it into my Jimny

Need a plasterer to patch up two small marks

I need a sparky to do a small job for me, check that this PowerPoint is safe (something fell on it) and put a new face plate on. I can sort out the rest (patching and painting)