Find an experienced plumber in Runaway Bay

Bathroom shower and sink taps and outside tapes require new washers.

Electrician to disconnect hot water so plumber can install new hot water system and reconnect it Runaway Bay

The kitchen sink is leaking underneath. We suspect the leak is coming from the sink waste/drain connection directly beneath the sink (circled in the attached photo), but we're not certain.

I have three toilets that I want bidet guns installed in. The bidets should be watermark certified and high quality. Give me a quote. Note: Airtasker to provide T-adapters and bidets.

I bought a 1/2 BSP (15mm) shower head, but it’s too small to screw in. I have a 20mm to 15mm brass reducer Male/Female, the shower head fits on the 15mm side but the 20mm is still slightly too small to screw in I’d need someone to find a brass reducer that can fit

We have a new fridge in the garage. The old fridge needs removing and the new fridge put in place. One floor up. Also Need to remove cupboards above old fridge. Take old fridge away. Still works needs defrosting. Fisher and Pykle.

install toilet brish holder on tile wall.

Supply and fit 3 exterior taps from individual owners existing cold water supply in common garage. Each job will require 15 - 20m of pipe run, clipped to garage ceiling, thru exterior wall ventilation shutter and up to ground floor apartment wall

Have a look and quote it

Water is leaking from the toilet tank into the toilet bow causing the tank to constantly refill. Repairs may need to include spare parts (e.g., flapper or fill valve).

Require conversion of current bathroom taps to a mixer. Removal of old breech plus supply and install new mixer then plug off old holes. Also requiring service of dripping shower head/wall tap.

My kitchen tap needs replacing. Happy to buy one from Bunnings or to have a tap of same or higher quality supplied. Would also consider having sink replaced if quote works out to be affordable for both.

Just need someone to install a dishwasher

My upstairs bathroom is out of order as the taps do not turn off. The washers have been changed. But still dont work properly. I would like to have these fixed and be water tight and operational. As its an old build there is no isolation valve which makes future works hard. I want an isolation valve installed.

1. Reconnect my hot water system from the Controlled Load (CL) circuit to the general/main circuit. 2. Supply and install a hot water timer 3. Provide a Certificate of Compliance for the work.

Fix gap on kitchen sink..

Remove and install new toilet seat

Just need head alignment done

Need a plastic pipe fitted to the over flow pipe from the water tank

Remove old bathroom tap and handles and install new ones in the basin.