26 Internal door installers in North East Melbourne

I just need 2 brand-new internal doors, hung and door handles added I have the brand new doors and all the hardware they are hollow core doors so they are lite

Secure a door back on to its hinges

Install and paint a new door. Fit door handle. The new door does not have hinge cutouts.

I would like 2 internal doors added to my hallway, they need to be framed in and hung, I would like bathroom door to be rehung to swing other way. I would like an additional hand rail to be hung in bathroom (tiled wall) Pic 1 &2 where i need them installed, pic 3 what i needs to look like

Current doors are hollow / honeycomb, being replaced by engineered timber with meranti veneer. Doors will be supplied. 7 doors in total - 3 of 35 X 720 X 2040 - 4 of 35 X 820 X 2040. Reuse of existing hinges and passage door handles. Including image of current

Purchased a new door handle for my door. Started replacing it but need certain tools that I don’t have to complete the job. The latch part needs to be plained into the door and a few new holes screwed.

Installation of two doors required in my basement. The walls are brick, and openings exist in the brick walls for both doors, opposite each other. The floor is concrete. I can source/buy door frame materials and doors if it will be cheaper to do. I am open to options for type of doors.

Internal bathroom door leading to kitty litter - want a cat shaped cutout for my cat to walk through. Will need to remove the door, use a jigsaw to cut it out and place door back on.

New bathroom door need to be installed, sits higher than current screw holes. Don’t have right tools on hand. Enough space on balcony for planing Handle to be installed also

We have remove internal wall of walk in robe and need ceiling plastered and need one internal door moved and another internal door boarded up/plastered. Ceiling plastering 2550 x 150 1600 x 150 Doors = Standard 2040 x 820 Can reuse existing door frame and door supplied.

Fix misaligned strike-plate of internal door. It's probably about 5mm too low, so the surrounding timber will likely need to be chiselled.

Hang 1 internal door 2 hinges already in tact and cut and fix a door handle . Door may need a little sanding to fit as new door but I’m not sure as it might not be required. Standard size door bought from Bunnings.Door already purchased. Replacing old damaged door with new.Thank you

Install internal door (hollow) Bring own drill/necessary equipment Door, hinges and handle already on site Must be able to carry door up internal stairs and have the physical fitness required to safely install

Replace and install internal doors Also have a sliding cavity door that i want to make larger and have new doors installed

Installing a double door frame and doors also install a bifold and frame. All doors, jams and architraves are supplied.

Install 6 X door handles and strike plates. All handle sets supplied. 4 X passage (bedrooms and laundry) 2 X privacy (toilet and bathroom) All doors have had previous handles in them except for 1 new. All doors are photographed for your reference

I have a few internal doors to be shortened by 1-2cm.

Replace the hinges on this door. Move the placement of the hinges above/ below by 2 cms and re-hang the door

I am needing an internal door installed

Adjusting an internal sliding door….. top and bottom seem equal but not middle….. gap is visible and to lower a clothes line attached to brick wall!