Find an experienced handyman in Newcastle West

I have the module. Accessing the Headlight Control Module for BWW : Remove the bumper: This is often the first step in accessing the headlight unit. Remove the wheel arch liner: This may also be necessary to gain access. Remove headlight fixings: Unscrew or undo the fixings that hold the headlight in place. Disconnect electrical connectors: Unclip all electrical connectors before removing the headlight. 3. Replacing the Module: Locate the module: It's usually found on the rear of the headlight assembly. Remove the old module: Carefully detach the module from the headlight assembly. Install the new module: Connect the new module to the headlight unit. Reassemble the headlight: Attach the headlight unit and all fixings. Reassemble the bumper: Reinstall the bumper and other components. 4. Coding and Initialization: Some modules need coding: If the module is coded to the car, you'll need to use ISTA or a similar BMW diagnostic tool to initialize it.

1. Paint touch-up- Graffiti removal 2. Carpet strip installation 3. Install drain cover 4. Clean awning 5. Remove waste- rubble from basement ( incl building and electronic waste)

You will need a step ladder & drill to mount bracket on ceiling & assist me installing exercise equipment. Approx 1 hour maximum

Simply need a long ladder that can reach over 5 metres to remove bugs from 6 light bulbs and replace one light with a new bulb.

We need a Ski machine attached to the wall at our gym facility

Scratched the wall with a bike, some of the gyprock has come off minimally - needing filled and painted

I need to vinyl wrap or repair damaged vinyl on two bedside cupboards & one side cupboard. Please see photos. It’s a rented property so need to restore the damaged furniture to my landlord. Existing vinyl has been removed accidentally when removing silicone covering on the edges of them (placed for child protection). Will need to source the vinyl wrap and any equipment needed as I have none. Flexible on date, anytime before 10 December. Address is in Newcastle West, 2302

Two big holes in walls plus a few wall for screws put in for picture. Make an offer

We have a TV at Hunter ST at an apartment that needs to be brought to the Office (3 mins drive). And take the tv from Office to the apartment. Also need to replace a light bulb at the apartment that can be purchased from the shopping centre next doors. Thanks

Need it done before monday - Due date: Flexible

Four large bedroom windows and one screen door. The frames are ok but the window frames keep falling out. The mesh needs replacing on all. - Due date: Flexible

I cracked my rear bumper and Need it repairs it’s 10cm long and 2cm thick - Due date: Before Friday, 22 September 2023

We are a coworking space, with two locations in Newcastle West. Our bathrooms require 11 x toilet roll holders replaced (we have the parts), and 3 toilet seats replaced. 2 x toilet roll holders required to be installed at our Hunter Street premises, and 9 toilet roll holders + 3 x toilet seats required to be installed at our Parry Street location. Please provide an offer of estimated budget/hourly rate. Thank you! - Due date: Flexible

Hi our shop need to install a pedicure chair. Need to extend the water pile to connect to new chair. We need a license plumber. Thank you - Due date: Flexible

Fix shower door that is off the rail in the master bedroom ensuite bath and check if light at the bottom of the stairwell only needs a light globe replacement - Due date: Before Tuesday, 15 August 2023

Just moved in, Need art works put up on walls. - Due date: Flexible

Need to service 2 Caroma wall mount toilets. Increase flush required.

Hi - we have 4 weeks worth of work ready to start today - can you help? Job located at The Hill wall repairs, ceilings the lot! If you have a can do attitude are available for immediate start and take pride in your work - I want to hear from you - Charmayne - Due date: Needs to be done on Tuesday, 11 October 2022

Ashton - StagePerformer500 Volume & Brilliance out put very low. When I offered to look at this for the nursing home, I realised the power transformer was 1.5A instead of the recommended 2.5A. But this didn't make a difference. I feel it could be a fuse or just a factory reset? or the volume/brilliance sliders is are corroded as this board was stored in a garage for a couple of years. - Due date: Flexible

Hi I hAve a gyprock wall that needs to be repaired. Wall also to be colour matched and painted. Thanks