Find an experienced handyman in Carlisle North

Move 3 Signes, re lay carpet squares or clean carpet, hang pictures

Repair or replacement of timber on awning There is no asbestos

Repair cord on Venetian blind

I need to have a parcel mailbox installed. It is a Sandleford 75cm black matte York parcel letterbox purchased from Bunnings.y understanding is that it needs a little slab built at the bottom.

Too hang a sliding barn door in a master bedroom

Need a Kmart over the toilet cabinet assembled, I have assembled partially but am unable to finish. Then that, a raised mirror cabinet and soap holder affixed to the bathroom wall. Also need a small shelf hung on the wall opposite the bathroom. I am renting so need a licensed tradesperson with studfinder to avoid hitting water pipes.

2 off A/C units vibrate when switched on. Need to have the outside units brackets re-bolted to wall or new brackets installed and anti vibration pads added to feet of both units. Units are elevated so need to be supported with a lifting device. Good space available to carry out maintenance.

Dog has chewed ensuite door frame so think the whole thing needs to be ripped out and replaced. Can possibly be repaired but not sure. Unsure of costs but please send me your quotes

I have a small front yard and verge and need the reticulation serviced and sprinkler heads changed. Happy to pre-purchase the sprinklers if you let me know what ones or you can quote how much over the asking price for the task for you to supply.

Need to fix one two pavers on the patio should hopefully be a 10-15 minute job. The sand underneath the sunken paver has fallen away through a hole in the fence

- 8 oyster lights changed to downlights that have left small holes in the ceiling needing patching. Vary from 1cm to 7cm. - 1 exhaust fan hole that needs patching (approx 24cm). -Approx 6 meters of cornices to be replaced (removed during renovations) needing repairs. Can provide cornices if needed

One of the wires (white wire next to purple ) going into the igniter connector doesn’t have any voltage. Needing this looked at/fixed please. Pitboss pellet smoker

Replace internal door with a new one

I have a big mirror that needs to be installed for the master bedroom. The dimension is 1800x1200mm and it will be installed on a tiled wall. Link to mirror: https://www.highgrovebathrooms.com.au/product/reflekta-pencil-edge-mirror-1800x1200mm/ Task involves bringing the mirror upstairs.

My door knob and fly screen door handle are loose and require either tightening/replacement altogether

Need some repairs done to a 2012 Hyundai iLoad. Need parts supplied. Would be good to get done asap.

Supply and fit new flat profile doors to existing cabinets: 8 x 920 x 295mm 4 x 920 x 595mm 5 x 695 x 295mm Supply and fit new flat profile front planets to existing drawers: 3 x 795 x 255mm 3 x 795 x 315mm 3 x 795 x 125mm 1 x 795 x 565mm Supply and install: 1 x island bench 1560x750 with countertop 1600 x 790mm I'm thinking drawers on 1 side with an open space for a microwave (560 x 320). The countertop will overhang on 2 sides to accommodate stools. Lift existing face height cabinets 210mm higher up the wall. I also want to replace the kitchen sink and the countertops (white stone, or stone look).

Make handyman alterations to a single bed frame (the bed is put together) so that under where a mattress would go, half the bed opens up creating a storage area. Also a square hole made large enough for an electrical socket to go through so the bed can go up against the wall. All excess materials need to be taken away including an extra beam I bought that wasn’t needed for the job.

Please remove rusted screws from the gate (as pictured) and install new gate drop pin lock

install rivets and tighten coolroom door wheel. we tried to tighten the bolt but fall off every 3 days. Must tighten it permanently somehow