Find a professional gate installation in Malvern North

A trench 550 mm deep to take an electric cable from the house to the electric gate. 6 meters long

Replace Front Picket Fence & Install Gate – Malvern Location: Malvern, VIC Job Type: Supply & install front picket fence + single gate Budget: Open to quotes Scope of Works I’m looking for an experienced fencing contractor to remove and replace the existing front fence with a new timber picket fence, including a pedestrian gate. Fence details: • Approx. 5.4 metres along street frontage • 2 metres high timber picket fence • 3-rail construction • Includes 200 x 50 timber sleeper at base (thicker sleeper required as plinth) • Posts to be installed behind the sleeper • Fence to be installed in concrete footings Gate: • 1 x single pedestrian gate • Steel frame • Steel latch post • Gate hinged off fence post (left side) Other details: • Letterbox will be supplied by owner, contractor to install (TBC) • Fence line is clear, however any trees/plants to be cleared prior by owner • Existing fence will need to be demolished and removed • There is concrete at the fence line – breaking concrete may be required (please note if this is included/excluded in your quote) What I’m Looking For • Experience with timber picket fences • Ability to supply materials or work with supplied materials (please specify) • Clean, professional finish suitable for a front façade / street appeal

The metal part that connects the gate to the post has snapped.

Re-attach gate blown off in the wind and attached latch.

Replace broken hinges on metal gate frame as per attached photos. Quote should cover cost of new replacement hinges if needed.

Need to cut 1 inch off the bottom of our paling gate so that it does not scrape against the ground. Needs to be done neatly without splinters/cracking. Also minor repair to re-screw in gate latch so that it closes cleanly.

Gate continues to slip causing lock and latch to be misaligned.

The brick fence that the iron fence is bolted to has moved slightly so that now the gate doesn't close properly and doesn't lock. I've had a look and I think the easiest fix would be to remove the old bolts, place spacers between the iron fence and the brick wall, adjust so that the gate closes properly and can be locked and insert new bolts.

Metal gate no longer closes. It hits the upright.

Garden gate has dropped a little I think and doesn’t line up and lock properly, needs adjusting

Need to replace the arms on my front gate. I will supply the parts, you need to remove gate, remove the upper and lower arms, replace with new arm and re-install. The gate will need to be aligned with the other gate.