Find experienced local fencing contractors in Beaumaris VIC

We have this lovely Rainbow playground in our backyard and it’s not been given the love and attention It deserves and some of the elements have rotted out and I need them replaced. If you’re familiar with Timber, it’s probably a very straightforward easy process for you to drill holes and Bolt replacement pieces in. The S.E.T itself came from the USA, Amercian cedar, so I can’t get the exact same Timber but I’m open to whatever you think is worthy to supply or I will buy the Timber for you and you can provide your skills to cut and repair the rotted out timber sections. We’re located in Beaumaris Vic 3913 and it would probably take the first visit just to run through what timber parts need to be replaced then you could either provide me with a list and I will organise the purchase and delivery of the replacement Timbe - then you come back and replace the parts? You can see the climbing wall needs replacing the timber that the horizontal slats screw into as rotted. Some steps require replacing and some of the large beams Simply swapped out. I’m thinking we could use Merboo? I know it’s not the traditional chippy carpenter job, but we really need this Playground back in good working order and I’d appreciate the help.

Remove fence one (grey, horizontal slats), including posts. Remove fence two (black vertical slats) and reinstall it where fence had been.

Put up chicken wire on bottom of gate to prevent dogs getting out

Gate needs to be lifted slightly -using the hinges? to stop it dragging on the ground

Build 6 metres of fence standard height :: see picture = also remove and dispose of all existing fence materials. The job is replacing the current black fence in the picture.

Build an L shaped deck on aluminium posts/base with composite boards approx 1ft off ground & 38sq metres total. Trees and area will be already cleared.

Install garden gate. I have the two slat garden gates here; other materials will be reimbursed. Installation on the side of the house. 2 panels for one gate. One panel needs to be static and the other panel is the gate opening and closing.

30 m of wooden fence with lattice on top with Jasmine wound through, jasmine heavy and now lattice leaning and needs support to straighten.

We have 2 house posts that connected to an upstairs deck that have rotted at the bottom and need to be replaced. Airtasker will need to arrange the replacement posts / parts to replace it with.

Scope of works: Remove and replace 6 palings on back fence that was damaged due to bad weather. Remove existing trellis and re-install 15m of trellis. Trellis will be provided and any other materials needed (nails) No painting needed No rubbish removal needed

Repair or replace timber paling fence between 2 units Single story. Existing fenceMeasure: width 3m length 2m Removal of existing fence and posts if replaced

New/second hand posts needed. 1.95 metres high.

7 metres of fence at 1.9 metres high. We want to have palings face our side of fence.

install 15 metres of fence extension to a paling fence. extensions are 2400 x 400 and have the verticaql pieces already attached.

Need to fit fence post between boundary fence and glass pool fence. Currently gap between fence is 200mm needs to reduced to sub 100mm. Therefore 125x75mm fence post to be fitted between fences. Height min same as glass fence (under130cm)

Two rebuilt brick piers (marked #1 and #2 in photo attached) require concrete fence capping to match remaining brick piers (marked #3 to #5 in photo attached) One brick pier approx 35cm wide. Other brick pier approx 65cm wide. See photos Tasker to supply capping, remove temporary capping and install replacement capping and caulk in.

Our full height brick fence needs repair as it has moved over time.

I need a brick fence painted. I already have paint and will supply anything else needed. Price is for labour only. Fence is about 12m x 2m. It is already powerwashed and ready to paint. Inside will be painted white and will need two coats. Outside will be painted dark and might need one or two coats depending on how the first coat comes up. There is some foliage on the inside. The house has already been painted and windows cleaned so I am wary of overspray and would prefer a roller. It might also require a trip to Bunnings, which is less than 10 minutes away, if extra paint is required. Let me know if any questions! 🙂

19m x14m rendered brick fence. Corner block 2m height on main 19m side Lower height on side street

Need a fence lock changed