Find trusted local electricians in Kensington VIC

-Removing existing flue pipe from the roof. -Installing  Alpine low profile roof vent ( The vent supplied by owner). -Replacing bathroom exhaust fan and ducting to roof vent. -Remove existing laundry fan from tight ceiling space to higher ceiling space nearby. Two exhaust fans and roof vent will be supplied. 

We are looking for a certified electrician to do the following jobs. -Moving one power point down under the benchtop, preparing for washing machine and dryer, checking with the capacity of the cable for running through two machines,capping off the powerpoint. -Capping off five power points in kitchen. -Disconnect and removing the slideout rangerhood, Capping off the powerpoint. -Installing 10 Led downlights. There are 8 led downlights in kitchen/dinner room and 2 led downlights in laundry/toilet room. There are two ceiling lights need to be isolated in kitchen. -one powerboard upgrades to 3 gang board. -installing one sensor light in front door. Downlights, lights and powerboard are supplied by owner. Cables and plugs are supplied by tasker. Valid Electrical work certificate EWC must be provided upon completion.

Need an electrician to rewire the fan so that it always has a power supply and can I control it with remote. There is a light and fan in the loft. If the switch is off then can't run the fan. If the switch is on can turn off the fan light but not the other light.

I'm looking to have approximately 12 existing lights removed and replaced with new ones : 8 ceiling lights - 2 of them are dimmable 4 wall lights Please note that some of the wall lights have dried paint around them, which might make removal a bit more challenging. I'd also need some advice on how to find new lights that are compatible with existing wirings.

5 halogen down lights in ceiling of 15 lights are not working even when bulbs are replaced - transformer needs checking and perhaps replacing. One electrical point in a child's room is unsafe and needs to be removed.

I need 11 Downlights along with Plug base to be installed in my apartment. I have the downlights and plug base with me.

Hello, I’m looking to have an existing ceiling light removed and replaced with a new pendant light (photos available if needed). The wiring is already in place from the current light fitting. Could you please provide an estimate for: Removing the old flush-mount ceiling light Installing the new pendant light in the same spot Location: Kensington 3013 Preferred timing: [insert your availability here] Please let me know your call-out fee, approximate total cost, etc. Thank you, Lisa C

Hi, Electrician needed to pull 2 new lines in my factory in Kensington Vic 3031, needed 2 new power point of 20amp which i think needed new line.

i already have the downlights, just need help with replacing and swapping out downlights

In after an electrician to: 1. Replace 2X light switches 2. Replace 2x fans in bathroom 3. Reconnect one fan to the switch (it is all wired however was disconnected for safety as fan not installed properly) 4 join a fan and light switch (2 seperate buttons right now on the one switch) so you just turn light on and both light and fan turn on I can get the new light switches (2 of them) and fans (2 of them) or happy for you to bring . Image of the light switches attached I can also get bathroom fans or if you have, happy to pay cost price

In order to install multi-split systems, my older switchboard needs to be upgraded. A switchboard upgrade is required for a double-story terrace house to be compliant with current Australian standards. The compliance certificate will be provided after completion.

I need a light fitting changed pendant light in kitchen

I have an Error Code 7 (disconnection between inside and outside unit) on my AC. Was working a few months ago and then has sat for a long time. Have been advised it might just need a good cleaning and the connecting wires checked.

We would like an electrician to install an nbn wall socket to which we can connect our wifi modem

One batten holder to be replaced. I have the replacement piece. Fix two flickering down lights (not due to blown globe). Possibly loose wiring.

Two Old Down Lights Need to be Replaced with two Ikea Lights (already purchased)

Hi, I am looking to move my NBN access point that was just placed in the closest room to the front of the property to upstairs in the living room. It’s a coax HFC connection.

I have a solar system and kitchen system that i need to understand for future rennovatiom

Replace 2 outdoor light fixtures

We are getting roof insulation installed and there is some old wiring in roof we need checked and neutralized before insulation goes in. 2 bed terrace house. Roof space is about 60sqm.