Find trusted local electricians in Bondi Junction

Two light switches need dimmers put on them

I need 2 light fittings replaced with original oyster lights.

Discuss supply & install of 6.5Kw Solar PV System. Scope of Work. Supply & Install - 13 x Trina Vertex N TSM-500NEG18R.28 PV panels (6.5Kw). Install Only - Connect & commission our new SENEC AIO V3 Home Already Installed - New AC/DC wiring, main string Dektite, AC/DC breakers etc. Available -External Isolation switches, Mounting Rails/kit. Tasks- Supply & Install 2nd Dektite, a couple of metres of 25mm conduit & small trunking for Cat 5e/6. Home - Single storey access, Corrugated Iron 10º skillion roof. Single Phase. TOU Meter. See attached proposed new panel plan. We require experienced & proficient technician(s) with SAA/CEC accreditation and familiarity with Hybrid systems. Please provide Solar reviews, references & figures for this easy and straightforward one day job. Please, no CCC need apply! Any questions, just message here.

Have purchased a Hyundai 3.5kW Inverter Smart Split System Air Conditioner. Need the evaporator installed in the living room of a terrace house. And the condenser unit on the near flat, low, easily accessible roof of the house. Electrics will need to be wired by installer, gassing, and a working system ready to go.

Add two power points on skirting board on either side of existing power point

NBN connection port is found above the door and close to the ceiling. TPG have advised that this needs to be rewired/relocated so we can provide power to the NBN Box. We live in at an apartment and we have a gyprock ceiling With a 80-100mm cavity. All brick walls. We need an electrician to be able to run the cable from the front door up into the ceiling all the way over to the corner of the living room area (corner of tv wall). Run it down the center of the wall in neat white conduit, then mount the new point behind the tv unit. Bottom of point to be above 135mm to clear the skirting. Bring the conduit/duct along the wall just above the skirting near the existing PowerPoint

1. Replace with Deta brand switches. The double switch may need a bit extra drilled out of the architrave to accommodate the vertical arrangement. 2. The oven and cooktop are on one circuit They both trip the circuit breaker on a high setting, though I can run the cooktop on a lower one. Not looking for this to be necessarily fixed, just some advice.

Dog crewed through lamp cord and switch. Needs to be reconnected.

I need a licensed electrician to diagnose and fix a circuit breaker that keeps tripping in my home. The issue seems to be with one of the circuits in my switchboard, which includes power for various appliances. Task Details: Inspect the switchboard and identify the cause of the recurring tripping. Check for potential overload, short circuit, or faulty wiring. Test connected appliances and outlets if necessary. Ensure the circuit is safe and functional after repairs.

Change lighting fitting as per photos. Shoukd be able to be done quic

I have an ongoing electrical issue in my home where a specific fuse in my fuse box keeps tripping, even when there appears to be minimal electrical load from the connected appliances. I need a qualified electrician to diagnose and fix this recurring problem.

Loose PowerPoint on tiled area in kitchen

My ghd hair straightener is not working. It seems like the thermostat is faulty and needs repair.

1. Change power point, i already bought a new power point 2. Change 1 light in the bathroom, i dont know what to get 3. Help to change oven light, i don't know how to fix it

Swap out a standard LED down light for a flexible LED spot light. See photos

I removed 3 indoor and 1 front door intercom that just need the wires reconnected. Shouldn’t take more than 1 hour to complete as I have had these re connected in the past.

Split a current cable to the oven into a power point for a microwave. Please note that the cable for the oven needs to stay the same (!!). In summery; 1. Use the oven cable to be sloppy into a power point 2. Retain the same electrical structure for the oven.

Installation of 1 x sensor light (supplied) Location: In the backyard. Wiring to be connected to the side bathroom. Maroon metal piping to cover the wire may be required where the wiring is exposed. Must be a qualified and certified electrician

House move - Electrician to remove my 2x pendant ceiling lights and change back to owner’s spot lights.

Install rheem hot water heater.