Hire a professional washing machine services in Central London

Hi there, My washing machine has recently broken so I am looking for someone to help me switch the washing machines and remove the old one. It is an integrated washing machine unit. I am looking for someone to help me: - remove the old washing machine from under the counter - unbox and install the new one - test for leaks etc - fit on the door Note: I live on the third floor and there is no lift access. I can try to help carry the old washing machine down stairs but I am not very strong 😄. Otherwise for reduced price I am happy to just change washing machine and I can arrange the old one to be removed separately

My Hisense washer-dryer shows an F17 error part-way through the drying cycle I need help from someone experienced in diagnosing and repairing washer-dryers

I do not know I started the machine , came to check an hour later and the sink was flooded also the floor. Shut down the machine. Tried to re activate it to drain the water and take out my clothes, the machine is not responding

I have a broken washing machine. I would like to buy a used washing machine to replace it. I'm looking for someone who can pickup the new machine and deliver (optionally install it as well) and dispose of the current one. Delivery is on the first floor of apt block with a few up/down steps in the courtyard and then 1 set of stairs

Hello....Just recently my washing machine has been making extremely loud sounds when on the spinning cycle..I believe this to ether be the Stablers or bearings, I would need a diagnosis first to see if worth replacing or to buy a new machine - Thank you.

I took the top off the small emergency drain hose, then the hose fell through it's hole and I can't retrieve it. If you look at the image I put a yellow circle around the hose im talking about. I took the top off now the hose went in the hole

The waste pipe came apart under the kitchen sink and sprayed water everywhere (as shown in the picture). It’s been temporarily reconnected now. This is a natural wear-and-tear issue, likely because the washers have gone or the connection became loose over time due to pressure from the washing machine/sink drainage. What I need: 1. Reconnect properly secure the pipe (the connection near the Saniflo pump). 2. Thoroughly check the entire under-sink drainage system to ensure it is 100% leak-proof and secure. 3. I want to make sure the pipe won't come off or loosen again when the washing machine or sink is being used heavily. Please bring necessary tools and standard plumbing washers/parts. Please see attached image.png for reference.

We are getting our cooker and washing machine removed we need someone certified to take out gas cooker off and washing machine

Disconnect integrated and hard wired washing machine and removal for disposal then installation of new integrated machine. Please note I am on 4th floor with no lift so only machine will need taken down for removal. New machine is already up the stairs

Washing machine cable has broken and needs repairing

Hi, I need someone to remove a broken integrated washing machine and prepare the space for a replacement freestanding washing machine. The existing machine is an integrated Candy washing machine fitted under the kitchen worktop. Appliance installers have advised that they cannot remove the integrated unit themselves and have asked me to arrange this before they can install the new machine. The job would include: • Disconnecting and removing the existing integrated washing machine. • Checking the clearance under the worktop and removing or adjusting any trim, panel, bracket, or fitting above the machine if required to allow a standard freestanding washing machine to fit. • Taking away and disposing of the old machine. • Leaving the water, waste, and electrical connections ready for the new appliance installer. I can provide photos of the current setup below. Please let me know if this is something you can do and provide a quote if possible. Thank you.

My Hotpoint washing machine has f05 showing and it’s not draining. I need it fixed today is possible, please.

Looking for a plumber to install a proper cold water feed valve for a washing machine. There is an existing cold water pipe in place, but it does not currently have a standard threaded outlet suitable for a washing machine hose. The job is to fit a suitable isolation valve with a 3/4" threaded connection. The waste pipe is already in place. Access is straightforward (see photo).

Washing machine belt recently replaced but moving out of position and causing a rubber smell, need someone to diagnose and fix.

Washing machine drain requires unblocking by specialist (currently causing leak into downstairs flat ). Flat is in London bridge

Received a new washing machine in my new flat need help to install it.

I need a section of the skirting board in the kitchen cut out to be able to remove the washing machine which is currently integrated so we can install a freestanding one. need the sides where it has been cut left neatly and not rough.

Washing machine leaking, unsure why

Washing machine SMEG WDI14 C7

Hi, I need someone to help with a drainage problem. My washing machine isn’t draining properly and when it does drain, the dirty water backs up into the kitchen sink. There’s also stagnant water left sitting in the washing machine drum and it smells bad. I think the shared waste pipe between the sink and washing machine is blocked or draining very slowly. I need someone to inspect it, clear the blockage, and make sure the washing machine drains properly again. Ideally looking for someone affordable as it should be a quick job.