Find a professional kitchen cupboard repair service in Central London

A water tank has been removed and has left a large gap for a cup card to be installed.

The cupboard base is damaged and needs replacing with a moisture-resistant board first. What I need included in your quote: – Remove current shelf & damaged base – Supply and install a new moisture-resistant base – Supply and install 2 deep pull-out drawers suitable for pots/pans – Ensure drawers run smoothly and support weight – Clean up & dispose of old boards Looking for someone with carpentry experience – not a basic DIY job.

I need some kitchen fronts replaced with new (non pre drilled) fronts. I already have the new fronts. Exact measurements are going to be critical, especially with the drawer fronts, to ensure everything stays aligned. Plinth. After switching from an integrated dishwasher to a standlone unit, I need the plinth cut to fit under the sink cabinets. 4 drawer fronts. I need the fronts of 4 drawers replaced. I've had new drawer fronts made to measure to replace the existing fronts. However the fronts do not have pre-drilled/pilot holes, so the positioning of the mounts to connect to the runners will need to be calculated and drilled. This needs to be mm accurate to ensure the fronts are all aligned and that the spacing between fronts is consistent across all 4 drawers. Under oven front panel. I need the panel under the oven replaced with a new panel that I've had made. I'm not exactly sure how this is fixed. Extractor Hood Cover. I need a new extractor hood cover fitted. There are no predrilled holes, so the placement of the hood cover will need to calculated and holes drilled at appropriate locations to allow fitting. Cupboard door. I've had a cupboard door made to replace an existing door, to match the colour of other doors. This will need to be fitted using the flush door hinge from the existing door. Ideally this work would be completed on either 9th, 14th or 21st November. I'm in central London, W1, so there is no private parking. Either on street parking (meter) or a car park will need to be used if driving.

Need new hinges on cupboard door and door rehung

I have fitted a new kitchen unit, I need the door put on - requires the hinges to be recessed into the flat door and then hung

Create a timber infill and fit above the cupboards to hide ducting. Finish with a matching cornice (existing is soft/polystrene material). Make good, seal, paint nicely. Supply all materials except paint. Images show current gap and a mock up of what I need.

I require a handyman to cut my corner kitchen cupboard in half so I can fit a slimline dishwasher. The pictures are attached and job is in SW10. Please give me a quote.

I need to take out a cupboard In my kitchen so I can place a freestanding dishwasher in there. I don’t need the dishwasher connected just the cupboard door taken off and shelves to create an open space

I am looking for a carpenter who can build a cupboard (no door) in our kitchen wall (70x50 cm opening, please see photo). We looked into buying one from B&Q but it is two cm too tall, but perhaps it could be slightly shortened? We also have a few squeaking floorboards, that need some attention.

The old dishwasher was removed and a new one was supposed to be installed but the contractors were not able to fit it because there is a panel at the back which they were not able to remove in order to plumb in the new dishwasher. The panel appears to be firmly fitted but needs to be removed.

HI - I have some new tenants at One The Elephant SE1 6FA. There are 2 issues which I would like someone to resolve ;- 1/ one of the cupboard doors in kitchen has come loose and just needs to be screwed in. Pretty quick and east task 2/The door to the apartment (see pic) is loose so when you turn the handle it is not opening and you need to put the key in the keyhole to pull to open the door

A boiling water and water filter tap is being fitted underneath my sink. It will require the current drawer to be cut from the back to make space for the tanks. I need a carpenter or kitchen cupboard handyman to come and cut out the draw and make good, leaving the space needed. the photo shows the draw and the picture from the website shows the two tanks that need to rest on the bottom.

I need a kitchen cupboard door rehung and reinforced where the body of the cupboard has worn and become loose. The screw holes have weakened, so this may involve repositioning the hinges. I’d like to keep the cupboard body intact and avoid full replacement. Also, while you're there, please check and reinforce any other wonky or weakened hinges across the entire kitchen cupboard suite. It shouldn’t be too complicated. Availability: Monday (today) afternoon/evening or Wednesday through Friday this week. Thanks

Vinyl wrap kitchen cupboards and counter tops

I have ordered 4 METOD cabinets from IKEA, and I'd like to get help to assemble them (easy) and hang them (hard for me).

We have moved into a flat and need cupboard reconfigured for a washer dryer tower which will require widening and reconfiguring of cupboards some plumbing and moving of electrics to accommodate. We have need for storage to be built at entrance also as separate job.

I currently have kitchen cupboards with no handles. I bought some from IKEA but need them put on.

install kitchen cupboard handles (x10), install a key lock on bedroom door(x1), move heavy planters and help tidy up garden

My fitted kitchen fridge door is broken and has nearly fallen off. It looks like the hinges to the fridge and fitting have over time have bent and sagged, certainly the top. Right handed opening and the fridge is a Bosch fridge and I have the original fitting instructions.

My kitchen cupboard is coming away from the wall and I'd like it re hung