Hire a professional washing machine services in Central London

Old washing machine to be moved outside and new washing machine installed.

Drill a hole in cupboard to allow space for washing machine tubes

Washing machine shows sign “waterproof fault “

Washing machine needs to be installed and old one removed. Live in a 3 story maisonette. No lift.

Deep clean / service of washine machine - clean of soap drawer - unblocking of conditioner dispenser (checking siphon tube mechanism for blockage) - seal clean - filter clean - external body clean - internal drum xlean - internal descaling

Just to disconnect washing machine and deliver to a flat ,10 mins drive away and then connect back up. Pickup location: Victoria, London, SW1V , England Drop-off location: Westminster, London, SW1P , England Removals size: A few items Stairs: At both places

Water blockage. The machine is not getting water from the tube.

New washing machine won’t drain properly. Had some bedding in the drum for the last 2 days as the lock is still on and won’t allow me to open door because there is still some water inside of the drain and won’t drain when I put it on the spin cycle. Shouldn’t need any replacements as appliance is brand new.

You need to open and place back wire around gasket of the washing machine, see photo enclosed. It's a 5 mins job that can be done with a couple of pliers/screwdrivers. Not sure why/how it got off so if you have time you should also test the machine spinning to make sure it's holding in place.

The washing machine is stopping halfway through cycles, not draining or spinning, and leaking water from the filter area. I checked the filter as advised, but there is a blockage in the pump that I cannot safely remove. The appliance is unplugged.

Washing backing not washing, drum not working

help to Carry new washing machine next door about 30 yards and and then up to the first floor, and then help to install correctly

I have a Bosch VarioPerfect Serie-4 Washing Machine. It is showing an E18 Error, seemingly due to a blocked Filter. I tried to unscrew the Filter Cap but it gets stuck, indicating there is an item blocking the Filter’s Tube inside. I need someone to come and resolve this issue asap

Hi, I need someone to help with a drainage problem. My washing machine isn’t draining properly and when it does drain, the dirty water backs up into the kitchen sink. There’s also stagnant water left sitting in the washing machine drum and it smells bad. I think the shared waste pipe between the sink and washing machine is blocked or draining very slowly. I need someone to inspect it, clear the blockage, and make sure the washing machine drains properly again. Ideally looking for someone affordable as it should be a quick job.

Current connector to washing machine has a slow leak (as evidenced by the limescale on pipe on the picture). The valve needs replacement, the pipe needs clearing of limescale, and the dishwasher needs reconnecting.

Experienced Plumber Needed My washing machine currently pumps water into my kitchen sink drain, causing water to back up into the sink when running a wash cycle. Both appliances share the same waste pipe and this issue persists even after basic cleaning and checking for blockages. I am looking for an experienced plumber who can: -Diagnose the plumbing configuration under the sink and washing machine.Identify and fix any underlying blockages, incorrect connections, or pipe sizing problems. -Reconfigure connections and pipework if needed, so that water from the washing machine never backs up into the sink. -Advise on and implement any long-term solutions to prevent this issue from recurring. Please respond with: -Your plumbing experience with similar drain/waste pipe problems. -An estimate for inspection, diagnosis, and full repair.Approximate timeline for completion. -Task must include all parts, labour, and a warranty for the fix. Job Location: London, SW129AZ

I need my washing machine removed, and the new one installed

E10 error code. I’ve got this working again so many times checking for kinks, water pressure and the inlet but eventually the same code appears each time we try to dry the clothes and also when washing. Machine is a Zanussi Lindo 1000

Non-draining washing machine, error messages e03 and e20 (Baumatic, BWDI1485D). Could be a lot of build up (years). Took front cap off. Filter core is jammed. Washing machine is housed in an under sink unit. Could need handling underneath machine to detach drain pump. Need experienced domestic appliance engineer with good washing machine, Baumatic, knowledge.

Washing machine is Indesit XWA 81682. Needs urgent repair. It fills and drains, but the drum doesn’t spin. The belt appears to be snapped or off-track, and the motor may have detached slightly. Please open the machine, refit or replace the drive belt, reattach the motor if needed, and test the spin cycle. Keybox access available. Guest is on-site, so clean and quiet work is important. Please confirm your availability, call-out/labour cost, and whether you can bring a replacement belt (likely 1225 J5 or 1233 J5).