Hire a reliable appliance service in Kent

Lawn mower stopped working

Stanley Max impact drill not working think it’s a lose connection, light flashes but driver not working

Install new fridge freezer & remove old one.

The door seal has come off our washing machine and needs refitting

Washing machine start button not working so unable to start a cycle

The chair is stuck in one position.

We have an existing supply which runs from a cellar up and around a front door through and along a wall. This will want channelling into the floor and drilling through a wall beneath the joists (access is not an issue)into adjustment room to be reconnected to the existing supply. The supply is in a cellar and is on own isolation valve. Access is easy here to make replacement connection

It’s stopped working There’s power to the treadmill but it’s not working

Mountfield 827M ride on lawnmower will still when cold, but won’t start once warm. May be need belt tension adjusting/service.

Nodictrak commercial 1750 treadmill. Belt sticking/stopping when run on. Have tried silicone gel under belt and adjusting belt tension - can't seem to get it right and sole the problem.

Lawnmower not starting after winter months

My usually very quiet washing machine has suddenly become extremely noisy during wash. I need someone to diagnose and fix the problem.

I have an Echelon Stride auto fold connected treadmill and an Echelon EX3 smart bike that needs a service.

Reebok GT60 treadmill not working. Electrical issue. Need a repair.

Lamona double fan oven approx 5 years old has started making a noise when you switch on. The fan is turning but seems to be making a noise rattling the oven still lights and heats up.

I’ve got a new freestanding dishwasher and washer/dryer to install

Need to replace my kitchen hood with an extractor fan that takes the smoke outside

I have an e6 error on my Taurus treadmill model TF-T95-2 believe it to be the incline rotor however need someone to have a look and determine the diagnosis of the problem and find a fix

Blades are hitting each other on ride on mower

I have an existing robotic mower (EcoVacs GOAT O500 Panorama) which appears to have lost its map of the garden. I have attempted to remap the area myself, but have not been able to get it working correctly. I am based in Wainscott, Kent, and would like to ask whether you offer a reconfiguration and remapping service for an existing mower, rather than a full installation. The garden is relatively small (approximately 80m²), and I am simply looking for someone to come out and set it up properly so that it is operating as intended.