Find experienced local tradies in Yatala SA

4 verandah panels have cracked and are leaking when raining. Need replacing. Person needs to buy panels and replace.

I have bought the part to replace it. Just need someone to come and pop it on for me. One of the power switches was falling off, I opened it thinking it was just a clip on cover, but it’s not. Can someone please come and help me? I need the job to be done around 7am in the morning due to work or on weekends. Thank you

Repair two cracks of about 10 cm on the gypro surface. We hope for a good appearance while controlling the cost.

I am looking for a qualified, licensed electrician to install a Deta 7kW Wall-Mount EV Charger (untethered) at my property in Golden Grove. I already have the unit in my possession. ​Scope of Works: ​Installation: Mount the Deta 7kW EV charger to the wall and perform the electrical connection. ​Circuit Requirements: Assess and install a dedicated circuit to support the 7kW load. ​Switchboard/Safety: Inspect switchboard capacity and install appropriate protection (RCBO/RCD) to ensure the installation is safe and compliant with Australian Standards. ​SAPN Compliance: As this is a 7kW installation, please confirm you are familiar with the SA Power Networks (SAPN) requirements. I expect the successful candidate to manage the submission via the SAPN portal (SmartApply) to ensure the installation is fully approved and documented. ​Certification: Provide a Certificate of Electrical Safety (COES) upon completion. ​Requirements: ​Must be a licensed electrician in South Australia. ​Experience with EV charger installations is highly preferred. ​Please include your electrical license number in your offer. ​Note to bidders: Please confirm in your quote whether you are providing all necessary cabling, conduits, and mounting hardware, or if I need to supply additional materials. Let me know your current availability to complete this work.

Freestanding bathtub with tub and tile refinishing kit supplied. Need someone with skills to resurface it.

Render hole patch in facade

Need to fix the single carport ceiling which is approximately 3metre wide x 6 metres long. The house is 28years old as the carport is exposed to outside weather like wind and cold gyprock ceiling have cracks at joining areas and have bubbles formed. So someone with experience with gyprock and painting may need to have a look at the pictures and suggest and quote to fix this ceiling before it gets worse.

Plasterer required to remove lounge room Cornices and install new cornices. roughly 4m on each wall Cornices to be installed will be supplied.

Rendering required for roughly 27SQM of walls in total (Bathroom & Toilet walls ) , since the tiles have been removed. Please provide quote INC materials

Three bits of plastering needed - have done some DIY in places and got sick of it. 😅 1 - bathroom upper walls, 2 - half of wall approx 165 x 165cm, 3 - partial spot in kitchen approx 110 x 75cm.

Plumbing required to lower vanity tap and washing machine taps lower so that a new vanity and laundry bench can be installed , will need someone who can cut out gyprock to get to the pipes and then patch up . Need to supply and install washing machine valve and connect to washing machine.After a new laundry sink is installed will need to connect sink and new mixer tap.

Need a single light switch replaced and a double power point, hardware will need to be included

Looking for someone to install a cornice and flush/sand one wall and a boxed area. Also need a few repairs where Gyprock paper has ripped off and screw holes in room need repair.

Hang a number of framed pictures on walls. A few on plaster over brick walls, rest on gyprock and study walls. Have some fittings. May need to supply others.

I would like 4 power points installed 2 in the outdoor entertaining area and 2 in the carport.

Need small textured render repair to front entry wall/corner of house. A pallet was accidentally knocked into the rendered corner near my front door, causing a section of the textured render/coating to chip away (see photo). Looking for someone experienced with render or texture coat repairs who can patch, texture match, and repaint/blend the area neatly. Located in Adelaide. Please quote including materials if possible. Experience with acrylic render/texture coat preferred.

Hi, I’m looking for a handyman/tradie to help with a couple of jobs at my house in North Adelaide. Potential for ongoing work as we’re planning further upgrades. 1. Remove and dispose of backyard awning • Large awning attached under balcony (see photos) • Appears to be fixed to a horizontal bar with a tension cable • Needs to be safely removed and taken away (too large for hard rubbish) • May require 2 people due to size/awkwardness 2. Replace door seals (already purchased) • Remove existing screw-in door seals • Install new compact brush seals (screw-in) • Approx. 4 sets of French doors + 2 standard doors • May require cutting to size (we have a saw if needed)

**ADELAIDE CBD not Prospect** Requiring help hanging a large (approx 190 by 140cm) framed tapestry and 80x80cm framed artwork on drywall. Needing wall anchors provided or guidance on which to buy!

Please quote for wood rot in post and beam of verandah, also bottom of a garage door. I will have a painter finish the job. Budget flexible as I’m insure of the scope of work. Thank you!

Need a power point installed external on a brick veneer wall. There is a power point internally directly inside the wall. It is under cover outside so no special durability is required.