11 Roofing Contractors in Rose Bay

Require a plumber to remove solar heating tubes on 2 story home. The system has been decommissioned 20 years ago and would like it removed urgently to accomodate solar panels. Location 42 Spencer St, Rose Bay. Looking for prompt service.

Gutter cleaning around the house 2 levels up.

Job to include - Pressure clean existing metal & terracotta roof ( front & back ) to remove all dirt, grime, rust & alge. Re-set loose ridge cappings on new sand and cement compound Hand trowel repoint all ridge cappings & collars using flexible mechanical fastening compound Re-seal parapet flashings Re-seal flu pipes Repair box gutter Apply 1 coat rust inhibitor primer to metal roof & apply 2 coats roof protection membrane coating

gutters at the back of the house only, and one 40cm section of flashing has slipped down and needs to be re-secured

Two storey house needs gutters cleaned. Approximately 2 hours work.

Clean gutters and check that downpipes are OK. Single storey semi. Require own extension ladder.

Solar suncatcher system Water leaking from a specific area on lower section of roof Budget is initially to check and advise

I need my gutters cleaned out

We need sealing for a box gutter

We need a bathroom unit built and floor tiling and waterproofing done.

I need a reliable contractor to seal a roof cavity to keep possums out complete the lining of the space to create a loft room. The work was commenced prior to purchasing the house.

Fence fix required for dog proofing

At the Woollahra Sailing Club, in our back storage shed, we need to install a new Roof Rafter. The reason is because the 2 supports under the existing Roof Rafter are in the way. The existing supports can be reused under the new Rafter. The vertical supports are 40mm OD Scaffold tube, 2.4/2.5m high. The size of the new timber Rafter needed is 50 x 120 x 4900mm. The rafter will need to be installed by a team of 2 people, nailed off into existing beams / girts, and then the existing vertical supports will need to be moved under the new Rafter. The distance that the supports will need to be moved is approx 1m. The old Rafter will remain in the old position and will not be removed. Materials required: 50 x 120 x 4900mm timber beam. 4 x 10mm dynabolts. Carpentry tools inc conc hammer drill. Trades should have a nail gun.

There are 4 gutters at the ground floor level and one higher up accessed from garage roof. Includes cleaning any debris collected. I have a sturdy ladder, garden brooms and a large recycle garden rubbish bin available.

I need somebody to clean outside of white colourbond gutters, under eaves, outside walls of the house, windows, woodwork etc. Just to remove dust, cobwebs, dirt that has built up. This would be by hand with some help from hose and/or maybe gurney (bore water in use). I have the rags, brushes, gurney etc Two hours work on trial. Likely more on follow-on if work is done well

I'd like 2 existing hollow core bedroom doors replaced with doors that provide significant soundproofing. I'd like suggestions from trades people that are skilled in solving this problem

Clean all box gutters on then main 2 storey house and pool house

I have a small waterproofing and tiling job. Waterproof 670mm x 920mm. You must be a licensed waterproofer. You will need to give me a certificate. You will then tile an area 670mm x 920mm, 1450mm x 1110, 670mm x 1110mm. I will supply all materials. You should have your tools