Find a professional lattice installation service in NSW

Repair/ replace 4 broken timber lattice panels at top of the backyard fence and run new garden training wires (stainless steel rope) to support climbing Jasmin.

. Outdoor plastic lattice installation Install plastic lattice across two front verandah openings. Opening 1: 1490 mm wide × 2400 mm high. Opening 2: 1350 mm wide × 2300 mm high. Three lattice panels will be supplied, each measuring 2410 × 1205 mm. Panels will need to be measured and cut to size, with the third panel used to fill the remaining gaps. Lattice to be installed forward of the existing screening to allow climbing vines to grow and be trained through it. Secure installation to suitable existing framing, allowing for expansion of the plastic lattice. Prefer no timber framing. Plastic lattice will be provided by myself. 2. Indoor curtain rod installation Install one curtain rod and brackets indoors. Curtain rod will be supplied by myself Open to offers

Looking for a handyperson to repair a Patio Lattice that has fallen on one side. Open to repair suggestions. Re-secure the fallen timber section to the existing structure Supply appropriate outdoor screws/brackets/fixings Reinforce the attachment points so it doesn't fall again Carefully work around the established vine without damage to plants Make sure the section is stable and reasonably level Remove any loose/broken material

I need some lattice put up against a fence (area is approximately 2100x1800mm). I have the sections of expandable lattice and a whole lot of cable ties.

Hi, I need the old lattice pulled down, the roof behind where the old lattice was to be repainted (will need paint to be supplied/matched to existing house colour), new lattice supplied, painted and mounted in the same position as what is there now

Lattice panels need repairs

Hi, I need help with tree stump grinding and removing a wooden lattice panel in my backyard. Stump Grinding: Grind 3 small tree stumps below ground level. Note that the stumps are close to a Colorbond fence, so care/smaller equipment will be needed to avoid damaging the fence. Waste Removal: Dispose of the dismantled lattice screen, cut vines, and related waste offsite. (Wood chips from stump grinding can be left on site to fill the holes).

Painted lattice privacy screens on back verandah that go to ground level. Install and fit two gates. Varnish back verandah deck

The current balcony has a lattice. The lattice needs to be removed and replaced with merbau slats. All materials will be provided. Quote for labour (with tools). $50/hr. Suitable for a handyman carpenter

repair the rails, straighten the gates, plus discussion on other small repairs caused by the vandalism. Will need discussion.

Install a privacy lattice on our wooden fence. Need to bring a lattice that would be approx 1.8m x 1m (high)

TODAY - looking for someone to remove lattice and dispose of it. All lattice on perimeter to be taken down (want to preserve black tarp thing but take it down). Also need to dig loose spike in front of fence posts (marked in pink on wall). About 15 posts in total. Must be done today. In Cremorne. Tip fee for lattice/posts included in task price.

Fix two sheets of lattice (1800 x 900) to existing brick wall (3200 width).

Supply and install lattice to perimeter of deck and house. Need a little latch door to be installed with lattice panel to be able to access under the house Red markup in photos shows where we need lattice installed. Potential to add a balustrade around the deck too, would need to chat about this in person. Price I’m offering is estimate. Would need to paint lattice white.

Prepare & Paint Timber Lattice Fence White – Mosman Looking for an experienced painter to prepare and paint an existing outdoor timber lattice fence. Approx. size: 14 metres long × 1.4 metres high. Please see photos for the current condition. The fence includes older weathered timber lattice as well as a newer timber lattice section. The older timber has some green/mould build-up and will need proper cleaning and preparation before painting. Job to include: * Clean and properly prepare timber * Remove mould/green build-up and dirt * Sand/scrape where required * Apply suitable exterior primer where required * Paint Dulux Vivid White * Two finish coats for a solid, even finish * Paint lattice, framing and posts * Supply all paint, materials and equipment * Protect all surrounding areas and clean up afterwards I’m happy for the painter to recommend spraying or brush/roller application depending on what will achieve the best finish. Important: I have newly laid decorative tiles alongside the fence, so these must be completely covered and protected. If spraying, careful masking is essential to ensure there is no overspray on the tiles, house, plants or neighbouring property. Please quote for: 1. Painting my side of the full 14 m fence; and 2. The additional cost to paint the reverse/neighbour’s side as well, subject to neighbour approval and access. Please include all labour, preparation, primer/paint and materials in your offer. Experienced painters with good reviews preferred. Location: Mosman

I have a brick front fence and I would like colourbond lattice attached.

Pull down old lattice and replace with new.

I’m open to ideas. Just want privacy after neighbours built a granny flat with windows looking over yard. Perhaps raising my existing wooden lattice on my garden side so it slopes up from fence line.

Must have own tools. Main resources needed will be supplied by us. ( plastic lattice from bunnings, any wood required) Looking for someone to be able to install some lattice to the bottom of our deck and house. I have attached chatgtp sample of the style we going for, but has a lot of cuts required to get around pipe as in standard photo.

Install shower filter Drill hose holder into wall