Find an experienced handyman in Collaroy NSW

Install floating shelf in the pantry, refer to photos for location and timber materials. Timber frame wall with tiles. The timber measure 260mm x 635mm. Only offer if you've done something similar before to ensure the tiles do not crack.

Gyprocking to small area of wall and crack in ceiling

Hi, I’ve recently had a kitchenette installed and am looking for a handyman to complete a few finishing tasks. Main task: * Patch and repair six small holes in the wall. I’ll also be posting an additional job and would be happy to combine them if suitable: * Lay a single row of tiles. Please provide a quote for whichever services you’re able to provide. I can’t always answer my phone so I’d appreciate if you reach out via email\message instead. Thanks! Please let me know if you have any questions. Thanks, Marie

Looking for several plumbers for quotes & hourly rates for general maintenance & after hours backup who can do some or most of the maintenance required for a block of 30 units spread out in 3 separate blocks & a long driveway with plenty of water, gas, sewerage, stormwater, HWS, needing plenty of repairs & replacements, from tap/cistern washers to major works. Currently need quotes on a Backflow Valve servicing & certificate, replacement & jetting of 65mm CI pipes, repairs to 4” sewer, possible reline sections, stormwater pits repairs/resealing etc. Will pay a nominal about for quotes for the serious contenders, eg. $20

I am looking to sound minimise a door between two rooms at home. My preferred solution is removal of the existing hollow core door and insertion of permanent soundcheck gyprock boards with a layer of sound insulation inbetween the boards and sound sealed. I am looking for quotes for supply and install for this work and to complete the job asap.

Its 2 custom wooden shelves 1.5m long each that needs to be installed on the kitchen wall. Brackets been provided by manufaturer

Installation of curtains. The curtain rod / track is 6 metres in length and requires 14 brackets to be screwed into the wall.

Wash ceiling deck area and wash lattice timber. Tools provided.

Replace old front door with new front door we bought. Need to also put on lock, handle & hinges. Need done today - Monday Located COLLAROY

Install my new front door I haven’t bought hinges yet and I haven’t stained it either? Open to that being included or not included in the price. Thanks

I need some Gyprock and villaboard set and then sanded I need Photos attached off the stuff that needs to be set. All walls and ceiling will be sheeted, cornice is being removed wall needs to be square set/set into tiles There will be 2x recessed exhaust fans in the ceilings so need to L bead into the fans

My clothes dryer turns of for a quick second then stops.

I am in need of a handyman for the following: - set up our living room cabinet (not large) - hang mirror on wall - set up 2 x at home desks

Need 2 cavity slider door kits installed and the doors hung Photo is of one of the areas that the doors is going, other area is the exact same I will provide all materials Job needs to be done before Monday

We have 2 shelves that we have removed and now need them reinstalled.

Need a licensed plumber to relocate kitchen sink water supply (hot and cold) and waste drain approximately 90cm back along the wall. Easy access to all pipes with clear under-floor access. Photo attached showing current setup (yellow/ orange) and required change (red). Scope: • Relocate hot and cold supply lines ~90cm back (retain dishwasher connection on cold line) • Relocate waste drain ~90cm back with correct fall Requirements: • Licensed plumber • Available anytime Thursday 30th January preferred Budget $150, open to quotes.

Shed model: Absco Reverse Skillion Shed – Model 15081RSK • Size: approx. 1.52m (W) x 0.78m (D) x 1.8m (H) • Brand new, flat-pack shed on site • flat surface in place to assemble • Shed needs to be fully assembled and anchored to manufacturer instructions • Assembly manual provided (happy to send ahead of time)

See pictures attached. Hopefully you can see from the first Pic, that the corner cupboard door is out of alignment and catching on the door next to it. I have unsuccessfully tried to fix it, making it worse. Someone who knows what they're doing can fix this in 5 minutes.

I have 4 electric blinds in my living room (2 sheer and blackout), which haven’t been working since they were reinstalled after some renovations. Brand: TUBE 35-RTT 6/28 EA The issue is that only 1 blind is working like it should. The other 3 are either not going down to the floor or not working. I can confirm that all the motors are working as I am able to jog all the motors by isolating each motor blind to each the remote. I can get each moving but I can’t reset the upper or lower limit or directions so they don’t all go all the way down.

Door chain was installed incorrectly and I need somebody to come and reinstall it.