Find an experienced gas fitter in NSW

Details: INSPECTION ONLY – Looking for a licensed plumber/gas fitter to attend site and provide a written quote for replacing my current electric hot water unit with a continuous flow gas hot water system (Rinnai Infinity 26 preferred). Scope of inspection/quote: Check feasibility of removing existing electric unit. Advise on gas line connection/extension from existing natural gas (already in house for cooking). Assess hot/cold water connections and location. Advise on disposal of old unit. Provide a detailed quote for supply & install (or install only if I supply unit). House: Single-storey home in Ingleburn, NSW. Easy side access to install location. Requirement: Must be a licensed plumber/gasfitter. Please provide licence details with your offer.

Replace new rangehood and removal of old. Repair gas cooktop

Gas water heater not heating up needs to check thermostat might be not sensing

Clean electric oven and gas hobs x 4

The flame of the gas stove is unstable, the fire is too small.

Replacing old lpg cooktop with new cooktop.

2 of my AEG Gas Burner Stovetop is not working, needs to be repaired.

Remove the old gas cooktop, adjust the cutout, and install the new one.

Replacing gas to cooktop should just fit in the bench but bench may need cutting. It is the correct size.

My old gas cooktop has stopped working properly. I have purchased a replacement and need someone remove the old and install the new one (as pictured in box). The old cooktop igniter has stopped working - however given its old and dirty i want to replace the whole thing. I can use a lighter to get the gas burning and gas flow is perfectly fine. Should mean no other parts require servicing. Must dispose of the old one also.

Uninstall existing gas cooktop Install new gas cooktop Removal of old cooktop not required Must be licensed

Just need to swap a new bayonet gas fitting in because the current one is corroded and won’t accept my bbq hose. I have the replacement part, I I just need a plumber to do the fitting.

I have an aquamax 340 gas water heater, and has been working fine. I had to move it up 30cm for some backyard work so the connections were altered. I got a plumber to do it for me. However right after the work has been done, the water pressure dropped massively. Plumber used fittings of same width as before, and the heater company saying it’s a plumbing issue.

I have an existing Fisher and Paykel cooktop that I want replaced with a new Westinghouse hob (same size).

We have no hot water. The pilot light won’t relight.

Cap 2 water lines and a gas line

I have an old copper gas pipe from a disconnected gas service inside my property that needs to be safely capped off. Require a gas fitter to supply and install a compliant end cap to ensure it’s sealed properly.

One fire can ve lighten up but that’s it , need some specialist to help light up and service the old gas fireplace , the other one I have got no idea how to start that off

We have a house with 2 gas connections for a gas heater - one in the lounge room and one in a bedroom. We would like a plumber to remove the gas connection.

Gas stove in building doesn't seem to be working. I'd like someone to investigate the issue and determine the cause