Find an experienced gas fitter in Hornsby

Hi, ​I am looking for a qualified technician to replace my current 4-burner Bosch gas cooktop with a 4-burner Bosch electric induction. ​[Key Details] ​Same Dimensions: The new Bosch induction has the exact same dimensions as the current Bosch gas cooktop. No extra countertop cutting should be required. ​Attachments: I have attached photos of the current setup and the specifications/manual of the new induction for your review. ​[Important Process & Requirements] My building is managed by Strata, so I must obtain official approval from the Strata committee before the actual work can begin. To get this approval, I need the selected technician to provide the necessary documentation first. ​Please apply ONLY if you can provide the following: ​Valid Electrical License & Gas License (Required for gas capping and induction installation) ​A simple Work Plan / Installation Plan ​Product specification details (I can also share the exact model via chat) ​[How We Will Proceed] ​I will select and hire a technician here on Airtasker. ​The hired technician will provide the required documents via chat. ​I will submit them to Strata for approval. ​As soon as Strata gives the green light, we will immediately schedule the actual installation date. ​Location: Hornsby, NSW ​Please reply with your quotes. If you have experience dealing with Strata required documents, please let me know. Thank you!

I need a licensed gas fitter to safely disconnect a gas bayonet heater hose that appears to be stuck. I’ve attempted the usual push-and-twist method, but it won’t release.

Need to replace gas input for a kitchen stove in apartment. Either valve or pressure regulator is leaking (slight smell of gas), so I need somebody to come and replace the whole input (hose+regulator+valve). I got hose and valve, just pressure regulator (1/2 inch) is required.

Hi Airtasker community, I need someone experienced to take a look at my Rinnai Convector 417 gas heater. When I turn it on, I can hear the igniter sparking for a few seconds, and the fan starts running. However, it doesn't ignite. After a short while, the sparking and fan stop, and the 'combustion' indicator light starts to blink. I'm looking for a qualified gas fitter to check, service, and ensure the heater is safe to use. Please quote for an initial inspection and diagnosis, as well as an estimate for any necessary repairs. Thanks!

I am getting a new freestanding gas oven. Will need a gas licensed plumber to disconnect the existing one and connect new one.

I’m replacing my kitchen bench top along with that replacing sink, sink tap and gas cook top. Need to get these tap and gas connected

Remove old gas top and install new gas cook top

remove the olde gas cooking top and install the new one.

Just connect gas to new cooktop. btw, I have it already cutted out this morning, no need cut out by gas fitter. new photo will be reuploaded soon

I want to replace the existing 60 cm gas cooktop with a similar new one.

When the old electric oven below our Gas Cooktop is replaced with a new one, we were informed by the electrician that the gas line regulator/valve of the gas cooktop needs to be repositioned to allow the oven to be fully pushed inside. Looking for a quote for both material and labour to complete the repositioning and to get the electric oven properly seated. Thanks - Due date: Flexible

Gas Compliance certificate and compliance plate needed for- -Bottled gas at stand alone house -Appliances - Cooktop, fireplace heater GST invoice/billing required. Please send quotes via AirTasker. - Due date: Flexible

Smeg gas oven needs a service. One if the 4 largest hibs does not work. - Due date: Needs to be done on Saturday, 9 December 2023

Replace existing gas pipe from gas metre to the first connection in the house basement. Approximately 14m long. Submit leak test certificate to Energy Australia. - Due date: Flexible

Smeg gas cooker needs service. One of the gas hobs the largest one lights but the has a huge flame my e that is not steady and then goes out. We had a Smeg specialist look at it earlier this year and they recorded changing whole top part as it could be that there is food stuck right in the bottom . 3 hops work fine but the largest still unstable and no my tater what we do goes out after one minute. - Due date: Needs to be done on Thursday, 31 August 2023

Gas oven in our church kitchen not working - Due date: Flexible

Need to disconnect my existing 90CM SMEG gas cooktop appliance + oven (Integrated)and install a new 90cm UltimateTaste 900 dual fuel freestanding cooker. Model # EFEP916DSE - Due date: Needs to be done on Thursday, 18 May 2023

Disconnect small gas stove. Put in new gas stove and reconnect. Move old stove out of unit to rear garden. In Hornsby unit. Flexible on dates. Must be licensed plumber.

SMEG 90CM burners are not holding the flame after releasing the knob, few of tem.

Replace the current natural gas cooktop with a new one (90 cm 5 burner). No cutting or supply required. - Due date: Flexible