Find an experienced gas fitter in Ryde

I have a 5-burner gas cooktop. One of the burners ignites successfully, but the flame goes off when I release the control knob.

Convert a natural gas Weber to lpg ( bottled gas)

Hook up gas pipes for approval, then hook up to gas bottles for certification. 4 x 45kg bottles with LPG changeover system

Looking for a licensed professional gasfitter/plumber to remove and replace a 4 burner gas cooktop and a kitchen sink tap. Bench cutout and cooktop size is pretty much like-for-like. You will need to provide a Certificate of Compliance for the cooktop install. Mixer tap is a pullout type.

Need someone to fix the dripping kitchen tap and connecting BBQ to Natural Gas Bayonet. Please provide your quotes Need a plumber that can do both (certified for Gas Fitter)

Needing to convert out LPG gas bottle dependent hot water system to mains natural gas system.

I need to connect the BBQ to the gas connection point in my new house. There is currently a connection point but that is only if I want ti connect a gas cylinder.

I have a BBQ installed but it’s not hooked up to the gas inlet which is under the stone bench. Will need to drill through stone benchtop to attach gas line to the gas inlet.

Hi, My gas cooktop is having an issue where the burners ignite, but the flame does not stay on after I release the knob. This is happening on all burners (not just one), and it’s intermittent — sometimes it works normally, but most of the time the flame goes out when I release the control. The ignition works fine, but it seems like the gas cuts off too quickly. I suspect it could be related to the gas supply, regulator, thermocouple system, or safety valve, but I need a qualified technician to diagnose and fix it. Looking for someone experienced with gas appliances (licensed gas fitter or appliance repair technician preferred). • Brand: Smeg • Issue affects all burners • Intermittent (sometimes works, sometimes not) • Need diagnosis + repair • Flexible with timing

Need to fix the gas pipe to the bbq

Hi I’m looking for a licensed gasfitter and plumber. Only few jobs around new duplex site. - install 2x new gas cooktops in alfresco (will be supplied) - install a bayonet in living room - fix connection of gas cooktop inside kitchen, there was leak at the connection but stopped when I turned the gas off at the connection. - toilet pan leaking on first floor, needs to be readjusted. The pan connector seems the be the issue.

Hi there, I need a licensed NSW gas fitter to rectify a gas installation defect identified by Jemena on my property in Eastwood. The defect noted on the certificate is: "Earth stake & weep holes in exclusion zone". Scope of work: Relocate/extend the gas regulator vent line or pipework to ensure it is clear of the electrical earth stake and building weep holes (per AS/NZS 5601.1 standards). Perform a pressure/leak test upon completion. Issue a formal Certificate of Compliance and a Leak Test Certificate as required by Jemena. Please refer to the attached photo of the Jemena Non-Compliance notice for exact details. Must be fully licensed and insured in NSW. Please provide your license number when offering. Flexible with timing but needs to be completed within the next few days. Thanks!

Hi there, I’m looking for someone to diagnose and repair an issue with my gas cooktop. One of the four burners has never worked properly. Gas seems to come through fine, but the burner does not ignite, so it may be an igniter/spark/lighter issue. Looking for someone licensed/qualified to work on gas cooktops. Please let me know your availability, call-out fee, and estimated repair cost if possible. Thank you!

We need the gas bayonette currently installed to be changed over to one that fits a Rinnai gas heater. Preferably in raw, unlacquered brass finish.

Install gas between gas kiln & 2 x 45kg bottles (approx 5m between them) And certify gas kiln - needs to have Class B Plumber licence

Gas leak coming from the kitchen stove. Has been happening since we tried to put on a new gas cooktop, which didn’t fit. So we have replaced the original. But now there is a gas leak.

check and replace the natural gas Bayonet Socket outside of the house.

Need a plumber to review a potential gas leak.

Need a licensed gas fitter / gas appliance technician to diagnose and fix my gas cooktop. Issue: • Only 2 of the 4 burners are working • The other 2 burners do not work • Need fault finding and repair • Please also check if it is an ignition, burner cap, jet, thermocouple, or gas flow issue Notes: • Looking for repair first, not full replacement • Please quote for labour and fault finding