Find an experienced gas fitter in Melbourne

Seeking a licensed gasfitter to decommission and take away a Rinnai Energysaver flued gas wall furnace from my apartment in St Kilda. Photos attached showing the unit inside and the balanced-flue terminal on the external brick wall. Scope: - Isolate supply and disconnect the appliance - Cap the redundant gas branch at the nearest practical accessible point (not just the appliance stub) - Pressure/leak test the remaining gas installation - Lift the heater off its wall bracket - Seal the redundant flue internally: trim the ducts back flush, pack ducts and the annular gap with mineral wool, and seal airtight with foil tape and sealant — not expanding foam alone. Finish flush or slightly recessed, ready for plastering. External terminal stays in situ as the weather seal - Remove and dispose of the unit (mostly metal, suitable for scrap) - Issue a Victorian plumbing compliance certificate for the gasfitting work Not required: - No external work and no ladder — the flue terminal remains on the wall untouched - Making good — I’m handling all plaster repair and painting myself Details: - Unit is plug-in via a standard power point, so no electrical disconnection needed - Easy internal access at floor level - Around 1–1.5 hours on site, plus cartage - Flexible on timing, weekday or weekend Please include your gasfitting licence number and confirm the compliance certificate and sealing materials are included in your price.

Apartment stove has weak blue flame and oven isn’t turning on. Grill working fine. Need someone to check.

Job includes: Install a new Goldstein BQG36-X 914mm gas chargrill. Run a new gas line (approximately 2 metres) from the existing commercial gas connection to the chargrill. Connect and commission the chargrill. Pressure test for leaks. Provide a Gas Compliance Certificate on completion. Location: Little Collins Street, Melbourne VIC Budget: $600. Please quote if additional fittings or materials are required.

Disconnecting my gas supply with GloBird Energy. Need a licensed plumber to disconnect 1 x gas cooktop and cap the pipework. Requirements:Licensed Gasfitter (VBA registered) Must provide name and licence number for my GloBird formMust issue a Victorian Certificate of Compliance (CoC) Location: Port Melbourne

Need this old/unused gas line cut and capped at floor level. Gas has been turned off at the meter for 6 months (not abolished). Everything is now electric.

I have an outdoor BBQ which used natural gas. I want it disconnected from the galvanised "T" connector which is located on the side of the house. We have landscapers re-doing the garden and want to remove the old BBQ, but need it disconnected first. The copper pipe (to the right) needs disconnecting (see picture)

I need my gas cooktop and kitchen tap disconnected and capped in preparation for a new bench top to be installed.

Need kitchen sink, gas cooktop and tap disconnected for kitchen demolition and complete removal. Need them all completely removed to within wall cavity. Please note that gas has been fully disconnected from the property, so there is actually no gas running to the cooktop. It just needs to be removed to any point within the wall.

Require a gassfitter or plumber with gasfitting endorsement to safely disconnect oven gas line etc in order for kitchen to be removed and line made available for next kitchen install.

Oven not staying on when on low setting

Hi there, Calling all gas Braemar central heating specialists - following attached errors have come up . Could be simple or more involved - also gas fireplace has stopped working too. Guessing just pilot light needs relighting But actual gad supply has been confirmed - gas to house cooking and hot water is AOK FYI PAYMENT $200 including call out fee and 1 hour labour included in this listing +separately $120/hour on top thereafter

We are moving out and need our gas stove disconnected.

cap gas as gas stove top to be replaced by induction

Gas supply has confirmed leak on property side (after meter). Scope of work: - Locate source of gas leak in residential gas line - Repair leak (includes fittings, joints, or pipe section as required) - Pressure test system after repair - Ensure system is safe and compliant - Provide Gas Compliance Certificate (mandatory) - Liaise with gas provider if required for reconnection Details: - Single residential property - Gas currently disconnected at meter (no live gas) - All work must be completed by a licensed gas fitter - Include call-out, labour, and standard materials in quote - Note any exclusions clearly upfront Budget: $200 (for minor/straightforward fixes) Only respond if you are licensed and can provide compliance certificate.

Looking for a licensed gas fitter to disconnect a gas cooktop and install a 1/2 inch gas cock to safely isolate the gas supply. Please provide a quote and availability, cheers!

I’m going to get rid of my cooktop and move to induction. I only need the gas connection to be closed in the kitchen

Disconnect gas fire that is no longer in use

I have an old outdoor spa and a fixed gas heater that need to be fully disconnected prior to demolition. Scope of work: • Isolate, disconnect, and cap the gas supply to the outdoor spa/heater • Disconnect and cap hot and cold water supply lines • Ensure all services are left safe, compliant, and certified Requirements: • Must be a licensed plumber with gasfitting endorsement (Victoria) • Must be able to issue the required Gas Compliance Certificate (and plumbing compliance if applicable) • No demolition or removal required – plumbing work only Access is easy and the area is clear. Please include your licence details in your response.

The gas cooktop does not ignite at times. When ignited and lit, once the knob is lifted, the flame turns off