Find an experienced gas fitter in Epping VIC

All 4 burners not getting gas on Blanco 4 burner natural gas cooktop. Appears to be a faulty gas regulator which needs replacing by a certified gas fitter/plumber. See photos, feel free to ask any questions.

Need to add a 3rd connection for a 3rd fryer in a commercial building Must be a qualified and certified plumber to complete works We will purchase Fryer for install. Will be a 2pan fast fry, lpg gas Must ensure there is enough pressure for 3rd fryer to function correctly, as well as all other gas appliances. Will need to cut away bench as well to allow for space of the fryer.

1. Moving gas pipe from ground to the wall for oven and gas installation 2. Moving kitchen tap hold and colder water up to down to install sink 3. Put one electric point near gas stove 4. install and connect gas stove,5. install and connect oven 5 . install and connect rangehood 6. install sink 3. 1 electric switch on the wall for oven

Gas ignite has no spark.

Hi, I’m looking for a licensed plumber/gas fitter to service my outdoor gas hot water system (Dux 135L, around 11 years old) and diagnose why the pilot light has gone out twice in the past month. System works fine once relit. Likely needs: • Burner/pilot area clean • Thermocouple inspection (happy to pay for the part if replacement is needed) Job includes: • Full check of pilot assembly and burner • Clean and service • Test flame strength • Advise on overall condition and remaining lifespan • Replace thermocouple if required (part reimbursed) Must be: • Fully licensed for plumbing AND gas fitting in Victoria • Able to show license before starting • Experienced with gas storage hot water systems Location: Epping 3076 Flexible with times. Thanks!

Install new freestanding oven appliance. Will need electrician and plumber.

Hi, I need a qualified technician to repair my gas cooktop. Currently the burner will only work if I press/hold the knob and use an external lighter. The igniter is not sparking, and the thermocouple looks rusted (photo attached). Issues: • Igniter not clicking or sparking • Flame only stays on while knob is pressed • Likely thermocouple replacement needed • One burner base is corroded and needs cleaning/fixing What I need: • Diagnose the issue • Fix or replace igniter • Replace thermocouple if required • Make sure burner lights and stays on safely

My technika gas stove has issues with ignition the two burners are working with matched or lighter not automatic

Westinghouse built-in oven • Gas ignites but doesn’t stay on • Suspect issue with thermocouple or gas control, but need an expert to confirm & Fix

1.free standing gas cooktop anti-tilt chain installation 2. install pressure and temperature relief jacket for gas water heating 3. issue compliance report for this two task only

Central gas heating is not working, shows error code 16 and 10, and says RESET. Even after reset, the unit does not start.

I need help to disconnect a free standing gas cooktop. Location is Epping VIC. Please let me know if you can help. Thank you.

The four burner gas stove flame is not burning to its potential. Maybe the tubes or burners need to be cleaned or replaced.

I’m Looking for a quote for a 3 & 5 star heater installation and new control panel install

includes gas, smoke alarm, and electrical assessments. Gas Compliance Check: For rental property need done asap

I need my kitchen stove fixed, I’m looking for a gas plumber to get it working. The flames won’t stay on

The following is the scope of possible work: 1) Remove the existing gas cooktop and close off its gas connection: Dimensions - 72cm (W) x 51cm (D) 2) Wire a 32 or 40-amp circuit from the switchboard to the kitchen (about 8 - 10 meters) 3) Install an isolation switch in the kitchen, and an appropriate RCBO in the switchboard 4) Cut the benchtop to fit the induction stove (35mm thick pressboard) 5) Install induction cooktop (Devanti 90cm Induction Stovetop - will purchase it myself): Dimensions - 90cm (W) x 52cm (D) 6) If possible, install an externally-vented canopy rangehood (will purchase it myself) 7) Issue all necessary compliance certificates and provide a labor warranty

Replacing an existing Braemar ducted gas heater with a new Braemar model. The current Braemer unit is in the roof which need to be replaced. It is a 3-bedroom house in Epping. I do not have the images as I am the owner, and the property is rented out.

I need gas fitter plumber

Need qualified plumber to connect gas stove and check for any leaks. 15 min job, stove is already installed just need to hook up the gas line.