Find experienced local fencing contractors in Sandringham VIC

Looking for someone to build a fence and gate on the side of our house. We already have a fence & gate on one side, (see picture), we want the other side to look the same. There is currently a large hedge there which I will remove prior to fence being built, the gap is roughly 280cm. We will do the painting so just need fence installing.

We have a glass pool fence and gate. The gate has dropped and it’s very difficult to close. See photos for more detail. Pics of hinges included too. Screws to hinges have rusted so could these be replaced too please. Only 2 hinges on gate.

Install a letterbox in a picket fence.

The wooden panels in photos (it is an inner or secondary boundary fence) require a scraping firstly & then a light sand. A primer has been applied to the slats already to loosen the product. Fence dimensions approx 2.5m x 12m + an additional 8 panel length in last photo which is approx 5m long. The additional 8 panel length has already been scraped - only needs a sand. Any day from tomorrow

To accommodate a delivery, we need to temporarily remove a single only one) glass pool fence panel, and then reinstall it back into place after the delivery is complete. Removal needs to be on Tues 15/8 or Wed 16/8 before 9:30am, and reinstall needs to be Wed 16/8 after 12:00pm. Should be a very simple job for someone who knows there way around pool fences (we don't).

Needing replacement of old wood paling fence. Roughly 18.5m length shared with 2 neighbours. Palings are 1800mm height. Posts need to be redone.

Install new wooden fence between driveway and neighbours driveway. Renovate wooden gate. Renovate wooden fence

11.5m long 1.8m treated pine paling fence. Required materials: - 125x75mm white cypress/ hardwood post. - Posts with concrete footings at a minimum 900mm depth due to sandy soil in the area. - 75x50mm treated pine rails. - 1.8m 150x12mm and 100x12mm treated pine palings. - 150x25mm treated pine plinth board. -All galvanised nails. The old fence is full removed. The site is completely cleared and clean. The soil is all sand so easy digging.

Build side fence with gate. 2300 wide fence, and will need a gate in the middle. Have already got pickets on site, would just need 2 posts for gate, concrete and 2 posts either side which can go into brick. Will also need gate frame.

Need to build a 3.3w and 2m height masonry fence and match the other fence.

Demolish and remove 3 m wide limestone fence and install wooden fence of 1,5 meter. While demolishing the fence border it with a protecting mesh

Install a 100 x 100 dressed cypress posts onto post support bracket. Install treated pine plinths, rails and pickets.

We currently have a balustrade fence that is rotting. This fence goes along the pathway to our house. There is some stairs. We need this balustrade replaced and then we want it to be extended by about 3 metres

Require some adjustments to swimming pool gate latches (glass panels) to meet the VIC Compliance Certificate. Gates are not closing/returning to the closed position from a stationary position.

I want someone to take the attachments off once pence post and reattach them to another and retighten the wires. See pics.

Two fence posts have rotted at ground level, fence is otherwise OK, so need two new / dummy fence posts put in and the fence connected to them. See photos. this post definitely rotted through at ground level. next one along wobbles too, but harder to see as there is a tree in the way. 3rd one along is solid

Gate is no longer self closing and has dropped slightly

Existing brick fence to be modified to add a new pedestrian gate (shown in blue). New brick pier to be constructed shown in red. Gate will be supplied for free.

I have a 3-4m section of fence that is damaged at the top and needs replacing, with fence toppers. Remove old palings and add new rails (if needed) and palings that line up with other section of fence and then add toppers to whole run. Palings and fence toppers supplied. Photos below. - Due date: Flexible

Cut fence and install new exposed post to match existing. Supply and install new single gate and lock latch - Due date: Before Thursday, 30 November 2023