Find a fence installation professional in Melbourne

I need 6 fence pallings replace; 4 x 2100 length 95 width 2 x 2100 length 145 width

Install a new gate latch and lock (provided) on a metal gate and wooden post. Metal gate will need some new holes drilled.

I require the installation of two retractable hoses in the front and backyard of my house respectively. The backyard will be attached to a wooden upright or fence. The front yard would be attached to brick.

13m existing fence to be removed and replaced with fence 2.7m Acess is good. Not urgent but would like done asap

Scope of Work: Remove the existing fence on the left-hand side and the middle section, (inc brick base) and construct a new fence in these areas, including a gate/door (the existing door frame can be reused). The replacement is required due to rot and general deterioration. The fence on the right-hand side will remain and does not require any work. Specs: 2600 high Back fence - 5210 wide Side fence - 2840 wide

Replace about 10 broken timber palings. Very easy access

I need a new latch supplied and installed on an existing timber gate. The current latch is broken. The job will involve: • Removing the existing latch hardware • Supplying a suitable replacement latch (strong, weather-resistant, suitable for an external timber gate) • Aligning and installing the new latch so the gate closes and secures properly Photos of the gate and existing latch are attached.

Two corner posts of our front fence are damaged/rot and need to be replaced.

Pool gate was taken off by previous owner and we wish to have it rehung. Screws and brackets still exist, just need a professional to hang it

Hi there, Looking for an experienced handyman or fencing specialist to fix and adjust our front gate area. What needs doing: • Align the existing fence gate so it opens and closes smoothly. • Remove the current timber post and reposition it correctly, then replace it with a steel post for better stability. • Adjust the gate so it closes in a different direction (swap the closing orientation/hardware). • Ensure everything is level, secure, and functioning properly once complete. Photos attached for reference. You will need: • Experience with fencing and gate installation • Ability to work with steel posts (supply and install) • Tools for alignment and re-mounting hardware Flexible timing—preferably sometime this week. Please let me know your experience and availability. Thanks!

Remove existing timber fence and install new timber fence using same or similar timber. Fence size is roughly 10m x 5m, and 6ft tall.

We have an old enclosure that is too bulky and need it replaced with something smaller. Two compartments, one with meter, one with switchboard panel. See pictures attached. Thank you

Looking for assistance moving some fibre cement sheets and holding in place while they get fixed to fence rails

Wanting a quote to build a fence across driveway to meet with side fence Wanting a timber fence with a way to access, ie, gate cut into it

Need new glass pool fence and gate

Need the back fence only replaced my fence is 3 metres in length

We have a side fence on our back garden that needs repair or replacement. Height 175cm palings Length 720cm The 3 spans are approximately 2m, 2.5m, and 2.75m between the vertical posts. The posts are hardwood and solid and are set into concrete and brick paving. The cross beams and palings are rotting and degraded. You could probably just replace the cross beams and the palings to repair the fence rather than complete replacement.

Replace and install Ring gate latch on iron gate. Guessing it should be welded on or with small screw and bolts.

I need 2 cypress fence post ( 2.4m post 125x125) installed to form part of a new front fence. The posts need to be installed to the specific height, width apart and angle to ensure they align to a new gate and existing fence. - i have dug holes to 600m depth - I have purchased both post, primed - I request that concrete and crush rock is supplied along with any levelling/laser equipment required Seeking a trade who has experience with installing picket fence posts. Once posts are installed, There is a further stage I will seek help with after concrete path has been installed. I will explore a seperate quote once this job has been completed

We have a waist high cyclone fence as our front fence. In the process of replacing sewage pipes, our front gate was removed. We want it to be put back in. The task will require create a hole for the fence post at the correct location, retention the cyclone fence mesh and refit the gate. All parts should be there. We will buy any that need replacing. - Due date: Flexible