Find a local electronics repairer in Melbourne

Looking for a licensed electrician to replace a single faulty push-button switch mechanism on a 3-gang wall plate in Richmond. The Issue: The left push button no longer latches down in place—the internal mechanical spring has broken and it just pops back up. Switch Type: Clipsal Iconic Push-Button Mechanism (Vivid White). Requirements: Must be a licensed electrician for compliance under Victorian standards. Part: Please specify in your offer if your quote includes supplying the replacement Clipsal Iconic mechanism, or if I should purchase it beforehand. Access is easy, flexible with times this week.

Fit new replacement taps and spout to basin. Fit new replacement taps to wall (shower)

Install 3 new 2.1kw units upstairs.

Looking for someone to clean up my backyard garden bed area ​Tasks required: ​Stump Removal: Dig out/remove 1 tree stumps located in the garden area (please bring own tools) ​Weeding: Thoroughly weed along the garden bed/brick wall section shown in the photos and remove all overgrown grass/weeds ​Waste Removal: I have a Green waste bin any extra needs to be removed from the property (specify if you have a green bin or want them to haul it away).

Fit off two wall mounted sensor taps - rough in stage completed. And install one bottle trap under sink

Render the following: Photo 1 - Bottom of shared wall Photo 2 - Around air vent case Photo 3 - The face of the porch Render texture must match and blend in with existing house. We have a painter who will colour match the paint so render product does not need to include paint colour.

GHD Hair Straightener Repair – Damaged Power Cord I need someone experienced in repairing GHD hair straighteners. The power cord is damaged and the internal wires are exposed. The straightener only turns on sometimes and does not turn on at other times. I would like the damaged power cord to be repaired or replaced, if necessary. 📍North Melbourne, carlton, Brunswick area

I have the new taps and spout To be replace, (And using an old part from the kitchen taps Replacing existing shower tap,)

Tap handle is worn out, needs replacing.

Looking for someone experienced with plumbing to replace the sinks taps in the bathroom, I don't have replacement taps yet as im not sure which to buy, so the person who accepts the job can find the suitable ones, cheers

I need help replacing the lamp shade on my hanging lamp with a paper lantern. The lamp is suspended over a stairwell with no easy way to access it You will need to bring your own ladder/equipment

Need help to jumpstart my car now

-Report (emergency last week and couldn’t get done) -4 magnolia little gem stumps to be removed. -7cm to 15vm approx diameter. They were cut down to 15cm above ground 12 months ago. -on raised garden bed.

Looking for a licensed electrician to carry out an electrical safety inspection and issue a Certificate of Electrical Safety (COES) for two small, adjoining retail shops (25 m² each) in Melbourne CBD. Power has been disconnected during vacancy, and the distributor requires an official COES to turn it back on. Exactly What Needs to Be Done Switchboard Assessment: Inspect circuit breakers, RCD safety switches, earthing, and main switches for both units. Electrical Safety Testing: Perform mandatory testing (insulation resistance, polarity, earth loop impedance, and continuity). Visual Inspection: Quick visual check of power points, lighting, and accessible wiring across both 25 m² spaces. Main Switch Protocol: Ensure main switches remain safely turned OFF ready for distributor reconnection. What Is Required at the End Official ESV Lodgement: A Certificate of Electrical Safety lodged directly through ESVConnect (Energy Safe Victoria). PDF Copy: A digital copy sent immediately so it can be provided to the energy provider.

Tap Needs replacing in the wash basin ; Apartment in first floor

Install a bidet hose and tap for the toilet Replace/replumb the hot and cold water mixer under the bathroom sink Replace the shower taps All parts and fittings have already been purchased.

We’re moving out of our South Yarra apartment and want to get it inspection-ready to secure our bond back. Looking for a general handyman to come give the place a once-over and patch up minor marks and damage before our final inspection. What we need: • Walk through the apartment and touch up scuffs, marks and small dents on walls and ceilings (paint colour matching where needed) • Fill and patch a few small gouges/chips (wall corner, architrave, wall dents) • Supply and fit a cover plate for a double power point that’s missing its faceplate • If possible, repair a small chip in a floor tile — happy for you to take a look, but not a dealbreaker if it can’t be done Please bring your own filler, paint/touch-up supplies and a standard power point cover. If you need us to confirm the paint colour or socket brand beforehand, just message us. Melbourne / South Yarra. Flexible on timing except for Monday as the cleaners will be there — let us know your availability and quote. Thanks!

Need a blown speaker repaired. It’s a onkyo D-77fxII

I need a few touch ups done around my place: 1. Replace a few floorboards in a corner that's previously experienced leaks. I haven't taken them up so I don't know what brand they are. 2. Replace a skirting board. 3. Some paint and plaster touch ups.

As per title. Should be a very simply job