Find a local console repairer in Melbourne

I have two washing-machine taps that protrude quite far from the wall. This prevents my stacked washer and dryer from being pushed further back. I’m looking for a licensed plumber who can advise whether these can be replaced with much more compact/low-profile washing-machine valves, preferably with downward or sideways hose connections. My aim is to reduce the projection from the wall by approximately 5–7 cm, or as much as reasonably possible. Please let me know: • What type of fitting you would recommend • Approximately how much space it would save once the hoses are connected • Estimated cost including parts and labour At this stage I’m checking feasibility and cost before proceeding. Photos attached.

I’m looking for two people to help unpack, move and set up a Reformer Pilates machine. The machine has been delivered in a large box/crate and weighs approximately 52 kg. The task will involve: * Unpacking/removing the reformer from the delivery box/crate * Carefully carrying the reformer upstairs (via stairs) * Moving it into the required room Two people are required due to the size and weight of the machine. Ideally looking for someone experienced with heavy furniture/equipment moving and assembly who will take care when moving it through the house and upstairs. Please bring any tools/equipment you may need for the move and assembly.

Looking for someone experienced with plumbing to replace the sinks taps in the bathroom, I don't have replacement taps yet as im not sure which to buy, so the person who accepts the job can find the suitable ones, cheers

Need 2 x sealed man holes, a decommissioned gas vent and a hole in the ceiling all plastered over please. Painting not required.

I need help replacing the lamp shade on my hanging lamp with a paper lantern. The lamp is suspended over a stairwell with no easy way to access it You will need to bring your own ladder/equipment

Our hot water tank is connected to a heat pump which is faulty, and not providing hot water. Looking for an electrician experienced with heat pumps to restore hot water urgently . Heat pump: Siddons Solar Stream Air To Water Heat Pump Water Heater Bolt On Split System (on roof of apartment building) with hot water tank (on balcony of apartment) Error codes 1(mainly) and 6. Possible fix: 1. Replace long wire from heat pump to sensor (new) in the tank. Would involve removing metal cover of the wire on roof and replacing possible faulty wire, about 5-6 metres. 2. Replace PC board in heat pump.

Cut and install timber panels to an existing fence, including measuring, cutting the timber to size, and securely fixing the pieces over/around the existing fence holes. Basic carpentry skills and your own tools required.

Need help to jumpstart my car now

-Report (emergency last week and couldn’t get done) -4 magnolia little gem stumps to be removed. -7cm to 15vm approx diameter. They were cut down to 15cm above ground 12 months ago. -on raised garden bed.

Leaking washing machine, tap connected to washing machine needs to be checked and fixed.

Grouting needing to be redone in shower

Looking for a licensed electrician to carry out an electrical safety inspection and issue a Certificate of Electrical Safety (COES) for two small, adjoining retail shops (25 m² each) in Melbourne CBD. Power has been disconnected during vacancy, and the distributor requires an official COES to turn it back on. Exactly What Needs to Be Done Switchboard Assessment: Inspect circuit breakers, RCD safety switches, earthing, and main switches for both units. Electrical Safety Testing: Perform mandatory testing (insulation resistance, polarity, earth loop impedance, and continuity). Visual Inspection: Quick visual check of power points, lighting, and accessible wiring across both 25 m² spaces. Main Switch Protocol: Ensure main switches remain safely turned OFF ready for distributor reconnection. What Is Required at the End Official ESV Lodgement: A Certificate of Electrical Safety lodged directly through ESVConnect (Energy Safe Victoria). PDF Copy: A digital copy sent immediately so it can be provided to the energy provider.

Tap Needs replacing in the wash basin ; Apartment in first floor

Tap washers fixed and leaking pipe fixed

Quick job to replace old taps with new ones. St Kilda location. Sunday 23rd Aug ideal otherwise most week nights after 6pm ( not possible during day as I’m at work).

Install a bidet hose and tap for the toilet Replace/replumb the hot and cold water mixer under the bathroom sink Replace the shower taps All parts and fittings have already been purchased.

We’re moving out of our South Yarra apartment and want to get it inspection-ready to secure our bond back. Looking for a general handyman to come give the place a once-over and patch up minor marks and damage before our final inspection. What we need: • Walk through the apartment and touch up scuffs, marks and small dents on walls and ceilings (paint colour matching where needed) • Fill and patch a few small gouges/chips (wall corner, architrave, wall dents) • Supply and fit a cover plate for a double power point that’s missing its faceplate • If possible, repair a small chip in a floor tile — happy for you to take a look, but not a dealbreaker if it can’t be done Please bring your own filler, paint/touch-up supplies and a standard power point cover. If you need us to confirm the paint colour or socket brand beforehand, just message us. Melbourne / South Yarra. Flexible on timing except for Monday as the cleaners will be there — let us know your availability and quote. Thanks!

I need a few touch ups done around my place: 1. Replace a few floorboards in a corner that's previously experienced leaks. I haven't taken them up so I don't know what brand they are. 2. Replace a skirting board. 3. Some paint and plaster touch ups.

As per title. Should be a very simply job

Pretty simple task but I’d prefer someone with a little experience, otherwise I will DIY. Just need muscles and some care.