Find a local console repairer in Melbourne

I have the new taps and spout To be replace, (And using an old part from the kitchen taps Replacing existing shower tap,)

Tap handle is worn out, needs replacing.

My car isn’t starting, likely due to a flat battery. Need someone to: • Jumpstart the car • Check that it starts and runs normally • Check for any obvious warning lights/issues • Confirm whether it’s safe to drive to my mechanic Give me your best price please !

Hi! Just moved to Thornbury and need a local handyman for a quick, simple job. No hard-wiring or complex electrical work needed at all—it’s all basic plug-and-play stuff.Should take less than an hour:Swap 2 outdoor lightbulbsReplace 2 plug-in LED strip lightsFix/adjust a battery-operated pantry light sensorBunnings is literally a 4-minute walk down the road if we need to grab a quick part. Looking for someone local who can help out this week.Thanks!

I’m looking for a reliable plumber or handyman to replace two existing kitchen mixer taps at my restaurant in Melbourne CBD. The new taps are the same style as the existing ones, as shown in the photos. Job details: * Remove two existing mixer taps. * Install two new mixer taps. * Check all connections and make sure there are no leaks. * Clean up after the job. The new taps will be provided. Please bring your own tools and any standard fittings required. Location: Melbourne CBD Preferred time: Flexible, can arrange a suitable time. Please let me know your labour price, availability and whether you have experience replacing commercial kitchen taps.

Need washing machine water puors connected to Communal laundry that has one set of taps. Appears to require connectors.

Looking for someone to supply and change the washers in my bathroom for both the basin and shower

I have two leaking tap sets that need repairing: 1. Bathroom basin: Tap is continuously dripping from the spout. I have some generic replacement washers available if it fits. 2. Kitchen sink: Taps are continuously dripping from the spout. Looking for someone experienced with older-style tapware to diagnose and repair both leaks, including replacing washers, seals or cartridges as required. The water supply will need to be isolated before work. I’m not sure where the main water shut-off/isolation point is, so this may need to be located as part of the job. Please bring the necessary tools and any small parts required. Ideally looking for someone who can repair both in one visit.

Looking for someone experienced with plumbing to replace the sinks taps in the bathroom, I don't have replacement taps yet as im not sure which to buy, so the person who accepts the job can find the suitable ones, cheers

I need help replacing the lamp shade on my hanging lamp with a paper lantern. The lamp is suspended over a stairwell with no easy way to access it You will need to bring your own ladder/equipment

Need help to jumpstart my car now

-Report (emergency last week and couldn’t get done) -4 magnolia little gem stumps to be removed. -7cm to 15vm approx diameter. They were cut down to 15cm above ground 12 months ago. -on raised garden bed.

Looking for a licensed electrician to carry out an electrical safety inspection and issue a Certificate of Electrical Safety (COES) for two small, adjoining retail shops (25 m² each) in Melbourne CBD. Power has been disconnected during vacancy, and the distributor requires an official COES to turn it back on. Exactly What Needs to Be Done Switchboard Assessment: Inspect circuit breakers, RCD safety switches, earthing, and main switches for both units. Electrical Safety Testing: Perform mandatory testing (insulation resistance, polarity, earth loop impedance, and continuity). Visual Inspection: Quick visual check of power points, lighting, and accessible wiring across both 25 m² spaces. Main Switch Protocol: Ensure main switches remain safely turned OFF ready for distributor reconnection. What Is Required at the End Official ESV Lodgement: A Certificate of Electrical Safety lodged directly through ESVConnect (Energy Safe Victoria). PDF Copy: A digital copy sent immediately so it can be provided to the energy provider.

Tap Needs replacing in the wash basin ; Apartment in first floor

Install a bidet hose and tap for the toilet Replace/replumb the hot and cold water mixer under the bathroom sink Replace the shower taps All parts and fittings have already been purchased.

We’re moving out of our South Yarra apartment and want to get it inspection-ready to secure our bond back. Looking for a general handyman to come give the place a once-over and patch up minor marks and damage before our final inspection. What we need: • Walk through the apartment and touch up scuffs, marks and small dents on walls and ceilings (paint colour matching where needed) • Fill and patch a few small gouges/chips (wall corner, architrave, wall dents) • Supply and fit a cover plate for a double power point that’s missing its faceplate • If possible, repair a small chip in a floor tile — happy for you to take a look, but not a dealbreaker if it can’t be done Please bring your own filler, paint/touch-up supplies and a standard power point cover. If you need us to confirm the paint colour or socket brand beforehand, just message us. Melbourne / South Yarra. Flexible on timing except for Monday as the cleaners will be there — let us know your availability and quote. Thanks!

I need a few touch ups done around my place: 1. Replace a few floorboards in a corner that's previously experienced leaks. I haven't taken them up so I don't know what brand they are. 2. Replace a skirting board. 3. Some paint and plaster touch ups.

As per title. Should be a very simply job

Pretty simple task but I’d prefer someone with a little experience, otherwise I will DIY. Just need muscles and some care.

Switch replace two gang clipsal Qualified electrician only