Find trusted local electricians in NSW

Blind needs putting up and ceiling light needs changing. Blind fitting: I have an Ikea blind that needs cutting down by about 10cm and then needs hanging Blind: https://www.ikea.com/au/en/p/fridans-block-out-roller-blind-white-10396878/#content Ceiling light: Existing ceiling lampshade needs removing and pendant needs replacing New lampshade: https://www.ikea.com/au/en/p/ikea-ps-2026-pendant-lamp-shade-handmade-white-90617079/ New cord: https://www.ikea.com/au/en/p/havsdjup-cord-set-white-20593251/

Looking for a licensed electrician to repair a damaged outdoor electrical cable under the second-floor eave. Please inspect the cable, replace the damaged section, install a weatherproof junction box if suitable, and test for safety.

Task title Relocate outdoor electrical points near pool fence Task description I’m looking for a licensed and insured electrician to inspect and relocate the outdoor electrical points beside my pool equipment area. The certifier has advised that the points are within 900 mm of the pool fence and create a climb zone. They need to be relocated above the pool plumbing pipes and within the acoustic equipment box. If conduit needs to run along the wall, it will also need a suitable 60° safety shield or wedge cover so it cannot be used as a foothold. Please inspect the area, recommend a compliant solution, complete the electrical work, and provide any required compliance documentation. The finished work will need to be suitable for the certifier’s pool fence inspection. Photos are attached. Please include your availability and quote, and confirm your electrical licence and relevant experience.

Looking for a licensed electrician to install two additional LED batten lights in my garage. There is already one LED batten light installed in the centre of the ceiling. Work required: • Install two new LED batten lights, one on either side of the existing light. • Installation positions have already been marked on the ceiling (see attached photo). • Run power from the existing centre light circuit, provided it’s suitable. • Conceal wiring within the ceiling where possible. • Connect all three lights to operate from the existing light switch. • Test and ensure everything is working correctly. I’m after a clean, professional installation with minimal visible wiring. Please provide a quote for installation, including any additional wiring and electrical materials required. Licensed and insured electricians only.

Looking for a fully licensed electrician to attend my store and carry out the following electrical repairs: Scope of work: * Inspect and replace the faulty chips station switch, which is not working. * Replace the heat globe holder. * Test both items after replacement to ensure they are working safely and correctly. Requirements: * Must be a licensed electrician in NSW. * Must provide their electrical licence details. * Must provide an official tax invoice issued by their own electrical company/business, not an Airtasker-generated invoice. * Must supply suitable replacement parts or advise me of the cost beforehand. * Please provide a quote including labour and parts. Please only respond if you are a qualified and licensed electrician who can provide the required licence details and company invoice. Thank you.

Upgrade main switch board in 1 bedroom unit to make compliant or including RCD switch. I'm looking for the most cost-effective compliant option to install RCD protection. Could you inspect the board and provide two prices if feasible: (1) retaining the existing enclosure and upgrading the protection, and (2) replacing the board with modern circuit protection 2nd task Replace 4 light fittings. Lights to be supplied

Work – Pendant Light Installation Install 4 pendant lights at existing ceiling light locations: 2 pendant lights in the kitchen 2 pendant lights in the hallway Existing fittings at all 4 locations are currently downlights. Install the provided pendant light fittings using the existing electrical points where suitable. Pendant lights will be provided. Kitchen Pendant Light: https://ivoryanddeene.com.au/products/bailey-metal-pendant-light-gold-white Hallway Pendant Light: https://pendantlightie.com/products/vintage-1-light-hammered-square-water-glass-pendant-light

Hi, I need a double power point with silver facing installed on a gyprock wall that has power points on the other side of the wall.

Need to remove electrical connection of existing oven hardwired to MSB. Need to provide new socket for dishwasher

I need someone can have a look my switch box, install circuit break for swim equipment

Install pendant ceiling light in bedroom.

replacing our existing fully working ceiling light, need this new one installed. bought on amazon : https://www.amazon.com.au/dp/B0DGM84MWF?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

I need an experienced handyman or security camera installer to install one Reolink Argus PT Ultra 4K wireless outdoor security camera with a 3W solar panel at my house in St Marys, NSW. I already have the camera and solar panel. The job involves: * Drilling and mounting the camera securely on the external wall. * Installing the solar panel in a suitable position with good sunlight. * Adjusting the camera angle to cover the front door. * Checking the Wi-Fi connection and camera operation. * Helping me confirm that the camera is working correctly on my phone. No electrical wiring or power cable installation is required. Please provide your experience with wireless outdoor security cameras and your total price, including any call-out fee. Thank you.

I need a licensed electrician in NSW to replace three existing power points. I will supply the new power points. Thank you.

Hard-wired smoke detector making occasional piercing sound. Unsure what the issue is. Require qualified electrician to inspect and propose remedy.

NBN port connection has fallen from plate into hole in wall. Urgently needs to be reinstated so NBN box can be reconnected. Wifi extender also needs to be connected once repair completed.

IKEA Kitchen install filler panel above PLUS Electrician to replace built-in mirowave

We have two rooms where the socket that holds the light globes in place have broken. We need someone to replace them? You will probably need to go to Bunnings to buy whatever is needed. Feel free to ask questions as it's hard to describe. We are free anytime Wed-Sat. We'll pay extra for you to go to Bunnings & buy what's needed.

Hi I need a electrician to take down the ikea lights and install new chandelier lights today. Chandelier requires some assembly to make the picture. I can probs assemble it myself (edit: just finished assembling the chandelier parts) but I would love some person who can install it better and aligned to the ceiling than the airtasker who installed the previous one and also have some white spray paint if they have any to spray the wall. Can add $25 for the spray paint

Our sunroom doesn't have a powerpoint so we need to add one. the closest powerpoint is 3.5 meters away. You'll also need to finish drilling through the hole in the wall it doesn't go all the way through. I need a quote with everything included so there are no extra charges on the day. Happy to provide more information if you need.