Find trusted local electricians in Point Cook

New 4 point area. 2 of them drill from the brick and another one and 2 internal wall

The existing bathroom exhaust fan is to be replaced. It is hardwired with a wall switch. I need someone to disconnect the fan and change the connection to a standard power point inside the ceiling (so I can replace the fan later). Also, in the living room I need to replace a faulty smart 3-gang light switch with a new one (already bought)

3 new power points. 1 power point through acrylic splashback.

There is a water leaking from the joint on roof between solar panel and heater

frost valve leakage on a single-storey home in Point Cook Adjust the pipes to bypass the solar panel heating and only use the instant heating water heater for heating

Install 3 TV’s with power points (1x 75inch, 2x 65inch - brackets provided), two pendants next to a bed including a light switch for them, and about +-26 downlights (replacing pre-existing downlights and new downlights provided - aiming for same diameter lights as the existing so no new cut out required except for one new downlight location, directly next to an existing downlight). Double storey home built in 2009 for context. Thanks

Looking for removal of old system (5 yrs old, wall to wall), ground floor, and installation of new system in same spot. New system is a Kogan SmarterHome™ 5.2kW Inverter Split System Air Conditioner (Reverse Cycle).

There is plumbing issue / leakage on roof water dripping on the roof and flowing through gutter.

Need help with quote for 3 multi light pendants and 4 additional power points please. Attached is the electrical plan. Big green dots signify pendants and small are power points. It’s a double storey house but job is on the ground floor. Open to offers. https://www.beaconlighting.com.au/alana-6-light-pendant-in-brass-with-white-linen-shade https://www.beaconlighting.com.au/alana-3-light-pendant-in-brass-with-white-linen-shade https://www.freedom.com.au/product/13168721

Replace one 4 gang switch in bathroom. Replace 2 downlights. Replace/fix one focus light which flickers when switched on. I have the replacement switch and downlights

Need one power point installed in bedroom which is upstairs in double story house

Need to get a electrical point installed in toilet to install toto bidet system.

Seeking a qualified electrician to install an outdoor weatherproof GPO in preparation for motorized outdoor blinds. The job involves ensuring proper wiring, compliance with safety standards.

Single story 2 electric switches 1 heat lamp bathroom installation

Check if Hot Water single solar panel is disconnected from the main system or not. We have gas booster, but we don’t have a storage system. There is a solar panel on the roof, so need to check if it is disconnected and can be removed. It’s a single storey house.

Need home downlight upgrade. Total 20 lights. Current one are hard wired only one colour. Need to change it to downloghts with switch which comes with 3 colour and max luminous

installation of air conditioner

I would like the following installations and fixes completed, please: 1. Chandelier Installation: • Install the lightweight chandelier (as pictured) in place of the existing light bulb. It should go in the same spot. 2. Bathroom Exhaust Fan Fix: • The exhaust fan is making noise after the AC technicians removed it during wiring. It may need to be properly refitted or secured to stop the noise. 3. Outdoor Light Replacement: • Replace the current outdoor light with a bright, warm-toned, modern spotlight for better night-time visibility. • Please feel free to recommend a suitable fitting, or supply one if you have something appropriate in stock.

Our down lights are flickering and would like to get it checked by licenced electrician.

Hi, I’m looking for a licensed electrician to do the following in my garage: 1. Install a new PowerPoint – I recently had my fibre connection installed in the garage and need a PowerPoint installed nearby. 2. Fix ceiling tube lights – I have two tube lights in my garage; one fell off, which caused both to lose power. The fallen light needs to be reinstalled and both reconnected.