Find trusted local electricians in NSW

Hi, I need help with electrical stuff in my apt the last 3 months One of the safety switch( for wall sockets around the house) keep turn off everytime I turn or random powerboards around the house, connected to TV, laptop, or hair dryer. After a while, Its back to normal, or have to turn off something to get everything else work again.

Need installation for spotlight.

Supply and install 27 x down lights Change old and install new pendant lights x 10 Supply and instal 3x switch Supply and install 4 x power point

Job Scope: 1. Remove existing solar panel (8 panels) completely from the roof 2. Clean the Pigeon Nest underneath (with pressure washer), 3. Clean the gutter next to the solar panel. 2 Storey house. Please give me a quote.

2 tasks First, install 1 GPO and 2 brush faceplates. Both supplied. (estimate 1 hour) Second, move ceiling lights approx 40cm so above wardrobe. Fill old holes (estimate 1 hour)

There is Redback battery system that disconnected. Need to connect that and install a 1 back up circuit for lights.

Licensed Electrician to rewire a Ubiquiti UniFi G4 doorbell to a sufficient power source.

Looking for a licensed electrician to install a pendant light over my dining table. There is an existing ceiling light point, however it is not centred over the table, so the job will involve creating an offset/swag-style installation (or advising on the best solution). Scope of work: Install pendant light (I will supply fitting) Create an offset from existing ceiling point to centre over dining table Ensure safe, compliant installation (NSW standards) Neat finish (ideally minimal visible cabling or clean swag style) Property: Residential home in Manly Ceiling height: 2.5m

Make the household rent-ready and the studio functional as soon as possible. Scope includes, primarily, replacing the dimmer light switch in the upstairs middle room to a normal light switch. Secondarily, re-installing light switches in the studio and wall power points. This job is focused on urgent, simple works only.

10 lights to be replaced with oyster lights. Currently lights in the photos installed which need to be replaced - most are the dome light.

Outdoor light has not been cabled correctly and does not turn on. Need to lift roof sheet and run cable, $100 an hour plus materials. Maybe 3 hours. Must be free by 1pm in Thursday.

Looking for a licensed electrician to replace 7 existing pendant lights in our terrace home in Petersham. • Straight swap: remove existing fittings and install new pendant lights (already purchased) • All are existing light points (no new wiring required) •Mix of standard pendants and one larger ceiling fixture •Standard terrace ceiling heights Photos of the current lights are attached for reference. Requirements: •Must be licensed and insured •Clean, careful install with good finish around ceiling plates Additional (Ceiling Finish / Cover Plates): If there are visible gaps or marks after installation (from smaller fittings replacing larger ones), can you assist with minor patching to tidy the finish? Please quote a per-light cost for any touch-ups or ceiling cover plate solutions.

Seeking a licensed electrician for two quick residential tasks in Toronto (2283) Kitchen Relocation: 1x single power point currently screwed into a cabinet backboard needs to be disconnected so I can remove the board. Once the board is out, I need the power point re-mounted securely onto the gyprock wall behind it. Bathroom Upgrade (Supply Included): 1x existing single power point needs to be upgraded to a double power point. Please include the supply of a standard white double GPO faceplate in your quote. Requirements: Must be a NSW Licensed Electrician (please provide license number in offer). Must provide a Certificate of Compliance (CCEW) upon completion. Quote should be all-inclusive (labour, call-out, and the double GPO part). ASAP this week, though I am flexible on the specific day/time. Location: Toronto, NSW 2283 Any questions, just ask! Thanks.

Need to replace 2 Switches and 1 x 3 Gang. All materials supplied. Just need expertise to replace them.

Pls help run an ac cable and a socket for NBN router, cause there is no power socket available at the Telstra equipment.

Licensed NSW electrician needed to fix kitchen downlights ( new bulbs don’t work, likely sockets/drivers) photos attached; available weekdays after 3pm

We need a licensed electrician to come and fix our bathroom switch ASAP as the lights have stopped working (not the lamps) 😭

Note for your electrician: You need the blue cat 6 cable extended from outside to inside with RJ45 connector at the end and then u also need a powerpoint for the nbn ntd on the same side of the wall. Once this is done the nbn ntd will be connected to the blue cable and ur modem/router from telstra will stay in the same place.

1. Orange side of the wall: [1 double power point and 2 data points] 2. White wall adjacent to the orange wall [1 double power point and 2 data points / 1 TV antenna point] 3. Install additional 4 down lights. Existing Wiring / cabling is on top of the gyprock ceiling accessible upstairs and please refer to the images.

Need to replace to broken exhaust fans. One in bathroom and one in laundry. Im 100m walking distance to Bunnings in Rozelle where new fans can be purchased and then installed.