Find trusted local electricians in South East Melbourne

Need electrician to put this socket together and make sure it’s safe to use

Hi, We need to replace a downlight in our store optom room. Please send us your quotes including supply and replacement of the faulty downlight.

53 downlights needs to replace product and Service needs to be provided by Electrician Barry from 700 to 800

ELECTRICIAN REQUIRED: I have 23 solar panels on my roof that I need to be removed due to potential damage to the roof underneath, Removal of the panels and system would need to be handled carefully to ensure there is no damage to my property. If you want the panels afterwards you can have them.

Need to get the downlights removed and patch up the holes, total 6 holes. I can remove the lights too.

53 downlights need to be replaced with new one product and installation need to be provided

53 downloads need to replace material and installation list people wired

I need an Electrician to remove 5 old Mirabella downlights size 95mm at my house. Electrician to supply same or similar product in Clyde North.

Issue Details: The switch mechanism is stuck/fused in the 'ON' position—the ceiling downlight stays on continuously and won't turn off via the wall switch. The safety switch/breaker cuts power to the light normally, confirming the issue is isolated to the wall switch mechanism itself.

We have a bunch of lights in the house that are dimmable and connected to two circuits, have two dimmer switches to replace our current switches with and want someone qualified to do so. Should be very quick we have the switches already and have verified existing lights are dimmable

My water heating just stopped working (22nd). Looking for someone certified to come diagnose and repair the issue. It is a Vulcan brand heater I have attached pictures.

- Disconnect and remove existing bathroom ceiling light (see images) - Install a new IXL Tastic Original 3 In 1 Bathroom Heat Fan Light unit in the required ceiling location(client supplied) - Upgrade existing two gang wall switch plate to a suitable four gang wall switch plate to provide individual control of the IXL functions as required - Install new electrical cabling between the wall switch location and new IXL unit as required - Complete all necessary electrical connections and terminations - Test and commission that IXL unit to confirm correct and safe operation of all functions

need a qualified electrician to install a ceiling fan. i will provide the fan. there is an existing ceiling fan in the room that will need to be removed first. i will need a certificate of compliance, do not apply if you are not a licensed electrician. this is the fan and i have connected the blades to the motor: https://www.bunnings.com.au/brilliant-132cm-white-matt-grace-4-blade-dc-ceiling-fan-with-remote_p0332326

install 10 downlights on eaves on two side sides of the house. Existing switch and one existing light outside can be used as the source of power. Replace two internal switches with dimmer switches. dimmer switches available only need the installation. Will need to widen the hole in the door trim to fit the dimmer switch. small house so not a lot of wire will be required. Look into the attached plan to see where these new downlights will go to estimate your wire cost.

Looking for a licensed electrician experienced with EV/Tesla charger installations to install a Tesla Wall Connector at my home. I’ve attached photos showing: * Existing switchboard * The brick wall where I would like the Tesla Wall Connector installed. The charger will be mounted externally on the brick wall shown in the second photo. The switchboard/meter is located outside the front door, as shown in the first photo. Job includes: * Install the Tesla Wall Connector on the wall * Connect it to the existing switchboard * Supply any necessary materials * Test the charger and make sure it is working safely * Provide Certificate of Electrical Safety (COES) upon completion I will supply the Tesla Wall Connector.

Licensed electrician required for a rental property in Narre Warren South. Work required: - Install/replace 2 hardwired smoke alarms - Replace 2 light switches - Remove the faulty existing patio light near the garage and install 1 Arlec LED batten light on the patio beam - Test completed electrical work I will supply: - Clipsal 755PSMA4 smoke alarms - Tesla light switches (1 gang into Kitchen, 2 gang into Laundry) - Arlec LED batten light Need a Certificate of Electrical Safety (CoES) as its a rental Please only offer if you are a licensed electrician and can complete the work on or by Thursday 10 September 2026.

Change 3 old dimmer switch to normal switch. Change 1 old fluorescent tube light fitting with a standard LED light fitting. We will provide all switches and light. Everything install on same location

Install pendant light in dining room

Hi, I’m looking for a licensed electrician to install hanging/pendant lights(total 3 numbers) above my dining table. The lights are already purchased — I just need them installed and connected to the existing electrical supply. Thanks!

“A power plug and power point are required for the cooktop.”