Find trusted local electricians in South East Melbourne

22KW EV car charger to be installed in carriage Double story house, colorbond roof

I’m looking for a licensed electrician to complete the following work at my rental property in Huntingdale, VIC: - Install a new safety switch for the oven circuit. - Disconnect and remove the existing oven. - Install and electrically connect a Whirlpool oven, which has already been delivered to the property. - Test the installation and ensure it is safe and compliant. - Provide a Certificate of Electrical Safety (COES) upon completion. The property is tenanted. The tenant is available for access after 3:30 pm, Wednesday to Sunday. Please include in your offer: - Your availability - Confirmation that you are a licensed electrician/registered electrical contractor - Confirmation that the COES is included - Your total price, including any materials required Thanks!

I need a licensed electrician to install a plug point for my TV on a wall in my living room. It is in ground floor.

Install 5.2kW Kogan Split System – Full Installation Description Need a brand-new Kogan SmarterHome 5.2kW Inverter Split System Air Conditioner (Reverse Cycle) fully installed in Cranbourne VIC. - Single-storey house, back-to-back installation - No existing electrical or plumbing at installation point - Meter box is less than 10m away - Quote must include complete installation: mounting, refrigeration pipework, drainage/plumbing and all electrical work - All required compliance/certificates to be supplied - Looking for installation week commencing 12 October 2026 Please provide a full fixed quote for the entire job, not just mounting the unit. No generic messages if you need any information to quote accurately, please ask.

One of my power plugs keeps tripping the electricity. Also, my smoke alarm keeps beeping every 20mins and have changed batteries too but it still continues to beep.

Post Kitchen refresh Install new range hood wiring already in place Re connecting 2 power outlets to existing wire Swap over 2 under bench lights to new (supplied) Swap existing ceiling light to larger version supplied Relocate that removed kitchen light to another one.

Projector and power point installation will provide the mount

I got down lights need installer

We have a bunch of lights in the house that are dimmable and connected to two circuits, have two dimmer switches to replace our current switches with and want someone qualified to do so. Should be very quick we have the switches already and have verified existing lights are dimmable

My water heating just stopped working (22nd). Looking for someone certified to come diagnose and repair the issue. It is a Vulcan brand heater I have attached pictures.

- Disconnect and remove existing bathroom ceiling light (see images) - Install a new IXL Tastic Original 3 In 1 Bathroom Heat Fan Light unit in the required ceiling location(client supplied) - Upgrade existing two gang wall switch plate to a suitable four gang wall switch plate to provide individual control of the IXL functions as required - Install new electrical cabling between the wall switch location and new IXL unit as required - Complete all necessary electrical connections and terminations - Test and commission that IXL unit to confirm correct and safe operation of all functions

need a qualified electrician to install a ceiling fan. i will provide the fan. there is an existing ceiling fan in the room that will need to be removed first. i will need a certificate of compliance, do not apply if you are not a licensed electrician. this is the fan and i have connected the blades to the motor: https://www.bunnings.com.au/brilliant-132cm-white-matt-grace-4-blade-dc-ceiling-fan-with-remote_p0332326

install 10 downlights on eaves on two side sides of the house. Existing switch and one existing light outside can be used as the source of power. Replace two internal switches with dimmer switches. dimmer switches available only need the installation. Will need to widen the hole in the door trim to fit the dimmer switch. small house so not a lot of wire will be required. Look into the attached plan to see where these new downlights will go to estimate your wire cost.

Looking for a licensed electrician experienced with EV/Tesla charger installations to install a Tesla Wall Connector at my home. I’ve attached photos showing: * Existing switchboard * The brick wall where I would like the Tesla Wall Connector installed. The charger will be mounted externally on the brick wall shown in the second photo. The switchboard/meter is located outside the front door, as shown in the first photo. Job includes: * Install the Tesla Wall Connector on the wall * Connect it to the existing switchboard * Supply any necessary materials * Test the charger and make sure it is working safely * Provide Certificate of Electrical Safety (COES) upon completion I will supply the Tesla Wall Connector.

Licensed electrician required for a rental property in Narre Warren South. Work required: - Install/replace 2 hardwired smoke alarms - Replace 2 light switches - Remove the faulty existing patio light near the garage and install 1 Arlec LED batten light on the patio beam - Test completed electrical work I will supply: - Clipsal 755PSMA4 smoke alarms - Tesla light switches (1 gang into Kitchen, 2 gang into Laundry) - Arlec LED batten light Need a Certificate of Electrical Safety (CoES) as its a rental Please only offer if you are a licensed electrician and can complete the work on or by Thursday 10 September 2026.

Change 3 old dimmer switch to normal switch. Change 1 old fluorescent tube light fitting with a standard LED light fitting. We will provide all switches and light. Everything install on same location

Install pendant light in dining room

Hi, I’m looking for a licensed electrician to install hanging/pendant lights(total 3 numbers) above my dining table. The lights are already purchased — I just need them installed and connected to the existing electrical supply. Thanks!

“A power plug and power point are required for the cooktop.”

Wall switch does not press down to turn on