Find trusted local electricians in South East Melbourne

Looking for a licensed electrician for the following work: - Install 1 power point/GPO in the attic. - Install a switch inside the house in an easily reachable location to control the power point. - Run the required wiring between the switch and attic. - Ensure the installation is safe and compliant. Requirements: - Must have a valid Victorian electrical licence/REC. - Provide Certificate of Electrical Safety (COES) after completion. - Please provide a quote including labour and materials. - Please advise your availability.

There are 5 powerpoints that are cracked and need replacing and the smoke alarm needs to be checked. It is a 2 bed unit. I have entered $100 as the budget as i want to receive quotes

I need an electrician to check a rental property and provide the electrical safety certificate. I know that there are 5 cracked double power points that need replacing and probably a smoke alarm in a 2 bedroom unit. I want a quote so my estimate of $100 is just to fill in the budget question.on Airtasker

Hi, I need a licensed electrician to diagnose and repair an electrical issue that occurred during restumping. The Issue: * Our main RCD/RCCB tripped during restumping work. * We isolated the problem to the lighting circuit. When the lighting circuit breaker is turned ON, it immediately trips the main RCD/RCCB. * This happens even with all light switches turned off throughout the house. * The main RCD stays on fine as long as the lighting circuit breaker remains off. Possible Cause: * A lighting cable or wire under/around the subfloor was likely damaged, pinched, or cut during the restumping process. What I need: * Diagnose the exact location of the fault/damaged wiring. * Safe repair or replacement of the affected cable section. * Test and restore power to the lighting circuit.

1 fan with light installed in bedroom 2 pendant lights installed over kitchen island

Needing a qualified and insured electrician to pop over and connect a new truck tail lift twi button pendant controller to my Hino 300 truck today. I have 2 x controllers I'd like connected I'd we can please.

I need an electrician probably for a day or two worth of work. Need to assist me to open switchboards and travel to sites within metro.

Hi, I’m looking for a licensed electrician to install hanging/pendant lights(total 3 numbers) above my dining table. The lights are already purchased — I just need them installed and connected to the existing electrical supply. Thanks!

“A power plug and power point are required for the cooktop.”

Wall switch does not press down to turn on

Looking for a licensed electrician to replace a broken Clipsal light fitting/batten holder. The existing fitting is shown in the photos, along with the replacement fitting. This should hopefully be a straightforward swap using the existing wiring, followed by testing to make sure everything is working safely. Job: * Remove existing broken light fitting * Install replacement fitting (provided) * Connect to existing wiring * Test and confirm light is working correctly * Replacement fitting is already available/pictured Timing: ASAP preferred. Available today/tomorrow if possible, otherwise Monday–Friday next week (24–28 August) works well. Please bring any tools/equipment required and be appropriately licensed for electrical work.

Looking for a licensed electrician to remove an outdoor ceiling fan from my verandah/pergola. The verandah is currently being dismantled, so I need the ceiling fan removed and the electrical wiring safely disconnected/terminated so the remaining frame can be removed. Would ideally like this done as soon as possible.

We need someone to connect a new light fitting to the ceiling.

I m looking for an certified electrician to install new oven and provide Certificate of Electrical Safety We have 20A switch breaker already. Current oven is hardwired and new one will require hard wiring the same cables I have attached photos of the switch breaker, current wiring and how its currently hardwired Current oven is 10A We are planing to install 15A oven I believe we need to install rcbo as well Expecting delivery in 3 -4 days so install needs be later next week or early following week

My recliner is stuck and electric has failed

I need to put in 12 downlights and have our pendants replaced in the kitchen We live in a 2 storey house See photos

Title: Repair and repaint two external timber doors and frame (Cranbourne East) I’m looking for an experienced painter/handyman to repair and repaint two external timber doors at my home in Cranbourne East. Job 1 – Timber glass laundry/back door: * Sand and prepare the existing timber door and frame * Fill screw holes, dents and small damaged areas with suitable exterior timber filler * Prime exposed timber and repaired areas * Apply 2 coats of quality exterior weatherproof paint or protective coating * Ensure all door edges (top, bottom and sides) are properly sealed against water damage Job 2 – External painted door: * Sand and prepare the painted door and frame * Repair paint chips and small damaged areas, particularly near the bottom * Fill any holes or dents * Prime repaired areas * Apply 2 coats of quality exterior weatherproof paint * Seal edges and touch up frame where required Requirements: * Supply all labour, preparation materials, filler, primer and paint * Use exterior-grade products suitable for weather protection and water resistance * Protect surrounding areas and clean up after completion * Please include your quote, availability, and whether paint/materials are included Location: Cranbourne East, VIC Photos available. Looking for a neat, professional finish and long-lasting protection from moisture and weather.

Need removal of island benchtop Need to have plumbing capped and GPO set aside for new benchtop Solar panels need to be removed from the roof. Already disconnected from isolators No need to dispose

Replace existing light switch making a buzzing sound in the light fixture