Find trusted local electricians in Concord

Assessment and quote for feasibility and cost for running a new circuit to power a pottery kiln/oven on a residential property. Details on the product spec sheet: Phase 1, Volts 240, Amps 33.4, Watts 8000.

I need the existing 3 in 1 heater a shown in the photo to be replaced with a Martec Profile Plus 4 as shown in the link. The existing switch can be used. The existing cut out I measured 335mm x 335mm. For the new one the cut out is 435mm x 275mm. I just need the installation. I can get the unit. https://www.martecaustralia.com.au/product/proile-plus-4-3-in-1-bathroom-heater-with-exhaust-fan-and-4-led-lights/

A ceiling light fixture has short circuited and the tripper knocked off. The light fixture has to be resolved.

Realign solar panels on 2nd story roof. The mounting beams are installed correctly and parallel to roof line. The panels themselves need to be adjusted so that they are also parallel with roof line.

I need to replace my key switches on a limited edition Deathadder essential, there fore I need someone to desolder and , reolace with new key switches and put it back together with no damage

Split type aircon need to be installed on ground floor, house Fujitsu airstage model

Install LED Ceiling light in kitchen

Installation of 2.5kw Fujitsu air condition split system

Powerpoints and electrical wires to be either reconnected/connected and reviewed in a garage/man cave at this property.

We need a new ceiling fan with light fitting in our bedroom. It will require support and may need additional wiring due to the age of the house. Images show the fan, the existing switch and the location of the existing light where the fan is to be mounted. The fan is remote controlled. Please provide a quote for the work thanks

Replace and install 4 Lights ( 3 Pendant lights + 1 Up and Down light )

Need to install a new double GPO on a wall. Have an existing power point nearby. Not sure if there is stud there or not. See photo

Need a qualified electrician to install an outdoor power point in my verandah.

The electrical cord needs replacing as it has totally frayed

I need an a phone line installed. I have purchased a new home and have been advised that I have fibre to the curb. I need a phone line installed from the street. Looks like there is a drawer wire left by the electrician. I need this done asap please. I will be on site tomorrow morning at 7.00am or afternoon at 4.30pm

I have a light bar from Kings that requires to be installed to my roof rack. Harness is provided and I will require to go complete full harness and wire to lights including a switch point internally inside of my car. I also have 2x small lights to be installed rear of car. Extra reverse lights Job scope - Install & supply of any parts required to roof rack

Remove 3 light fittings and fit 3 new LED oyster style light fittings. Have included photos of two old fluorescent oyster lights to be replaced and two new LED lights - Kitchen and sunroom. And a photo of the Led light (Hilux) for the bathroom.

Need to remove existing lights in kitchen and replace with new lights that will need to be assembled and installed. Note: there are two ceiling lights to be removed and installed I have the light fixtures and all lightbulbs needed but all other tools will need to be provided. Photos attached.

We need to change 2 small chandeliers In foyer and bathroom. Possibility of adding a PowerPoint too but not essential. Today would be ideal but flexible Concord West

i need an electrician to reconnect a double power point. discard the one shown and reconnect the one new one i have already bought - Due date: Flexible